Q.5) Two weights C = 2000 N and D = 1000 N are located on a horizontal beam AB as shown in 4 m Figure. Find the distance of weight C from support A, i.e., x so that the support reaction at A is twice that at B. Both supports are roller.

Q.5) Two weights C = 2000 N and D = 1000 N are located on a horizontal beam AB as shown in 4 m Figure. Find the distance of weight C from support A, i.e., x so that the support reaction at A is twice that at B. Both supports are roller.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter8: Rotational Motion

Section8.3: Equilibrium

Problem 40PP

See similar textbooks

Related questions

Q: The leg and cast in the figure below weigh 160 N (w1). Determine the weight w2 and the angle α…

A: the tension on the strings are balanced by the weight,

Q: Problem #4 Find the tension T in each cable and the magnitude and direction of the force exerted on…

Q: A block of weight w is suspended from a rope tied to two other ropes at point O. One rope is…

Q: Two identical strings making an angle of 0 = 25.4° with respect to the vertical support a block of…

A: 126.85 N

Q: Consider the following figure. (a) What force (in N) must be exerted by the wind to support a 2.00…

A: a) The equation to find torque due to weight of the chicken is τ=Fweightrweight=mgrweight Substitute…

Q: Using the system shown below, what would be the maximum mass, M, that can be supported by the…

Q: A framed painting weighs 30kg. The two wires supporting it makes an angle of 120° with each other.…

A: Given: Weigh of framed painting = 30 kg = 30 X 9.8 = 294 N Two wire supporting to makes angle with…

Q: Two identical strings making an angle of θ = 30.0° with respect to the vertical support a block of…

A: Given data: The mass of block is m=15 kg. The angle of string with vertical is θ=30°.

Q: For Exercises 89–94, the given forces (in units of pounds) act on an object. a. Find the resultant…

A: The resultant of all the forces acting on an object is equal to the vector sum of individual…

Q: The weightless strut in the figure below is not attached to the wall; it is prevented from falling…

Q: The 6-m pole ABC is acted upon by a force P as shown. The pole is held by a ball-and-socket joint at…

Q: 1. Find the tension T in the cable and the magnitude and direction of the compression force C…

A: Refer to the following figure :

Q: A 50-kg block is suspended as shown. The beam is weightless and is hinged to the wall at A. The…

A: Given : Mass of block=m=50 kg In this question we have to find the magnitude of Tension T in the…

Q: The leg and cast in the figure below weigh 273 N (w1). Determine the weight w2 and the angle α…

A: Given information:

Q: NOTES ASK YOUR TEACHE A uniform plank of length 2.00 m and mass 27.0 kg is supported by three ropes,…

A: The net torque on the left end is, T1sin40L=wd+mgL2T1sin40×2=690 N0.5 m+27 kg9.8 ms22…

Q: A block of weight w is suspended from a rope tied to two other ropes at point O. One rope is…

A: Given: A = 60 degree W = 100 N

Q: Ten bags of top soil, each weighing 180 N, are placed on a 2.05-m long sheet of wood. They are…

A: The total momentum at one end (left side),

Q: A cook holds a 1.95-kg carton of milk at arm's length (see the figure below). What force F, must be…

Q: The upper leg muscle (quadriceps) exerts a force of 1270 N, which is carried by a tendon over the…

Q: In order to lift a shovelful of dirt, a gardener pushes downward on the end of the shovel and pulls…

Q: A force F is applied on handle C to hold a box as shown in the figure below. The mass of the boX IS…

A: Given that the mass of the box is 40 kg

Q: A student's head is bent over her physics book. The head weighs P = 25.6 N and is supported by the…

A: Given head weight=p=25.6Nmuscle force =Fm→=60.0N, 35° below the horizontalwe have to…

Q: A 10 m uniform rope of 100 N is supported at two ends. A person (400 N) sits 2 m from the left side.…

A: We have Σ F = 0

Q: The arm in the figure below weighs 36.7 N. The force of gravity acting on the arm acts through point…

A: From the figure , we can understand that θ = 12° ∑Ft = [ (Ft . sin 12) * Distance from Origin ] -…

Q: A framed painting weighs 30 kg. The two wires supporting it makes an angle of 120° with each other.…

A: Mass of framed painting: m = 30 kg The angle between two wires: θ1 = 120o Implies the angle…

Q: A 50N body is supported by two ropes, one making 30* with the vertical and the other making 45* with…

Q: 2. For the system shown above with a 45 kg sign suspended from a 12 kg, 2.8 m horizontal beam with…

A: Let ms be the mass of sign board, mb be the mass of the beam, theta be the angle at which the…

Q: A 160-N child sits on a light swing and is pulled back and held with a horizontal force of 120 N.The…

A: The components of tension can be written as

Q: Two children push on opposite sides of the door during play. Both push horizontally and…

A: Given Force F1 = 185 N Distance r1 =0.600 m r2 = 0.450 m

Q: A bag of cement of weight 325N hangs from three wires as shown below. Two of the wires make angles…

Q: 5. Find the maximum weight of the bucket that the wire system can support so that no single wire…

Q: A uniform 23.0 kg chain 2.00 mm long supports a 50.0 kg chandelier in a large public building.…

A: To determine,1)Find the tension in the top link of the chain. 2)Find the tension in the bottom link…

Q: The drawing shows a per- son (weight, W = 584 N) doing push-ups. Find the normal force exerted by…

Q: A Christmas decoration consists of three identical balls, each with a mass of 0.15 kg. It was hung…

Q: A window washer is standing on a scaffold supported by avertical rope at each end. The scaffold…

Q: Two force 4N and 3N acting on a object then fin the resultant force on the object if the angle be…

Q: 3. Two masses in an Atwood machine are 1.9 and 2.1 kg, the vertic the heavier body being 20 cm above…

A: Givenm1=2.1 kgm2=1.9 kgd=20 cm

Q: Two forces are applied to the construction bracket as shown. Determine the angle 0 which makes the…

Q: During most of the stance phase of the gait, the knee flexion is less than 20º. What force must the…

A: Given: Weight of the patient, w = 836N Distance from line of joint to center of gravity, d = 5 cm…

Q: 5. IThe arm in figure below weighs 39.3 N. The force of gravity acting on the arm acts through point…

A: Solution:

Q: The leg and cast in Figure P4.20 weigh 220 N (w1). Determine the weight w2 and the angle α needed so…

A: If the hip exerts no force on the leg, the system must be in equilibrium as shown in free body…

Q: A 3.0-m-long rigid beam with a mass of 100 kg is supported at each end, as shown in Figure below.…

A: The free-body diagram of the beam is shown below. Here, M is the mass of the beam and m is the mass…

Q: A uniform plank of length 2.00 m and mass 28.0 kg is supported by three ropes, as indicated by the…

Q: Suppose you use an ideal pulley of the top shown in figure 5.18 (b) and find it necessary to exert a…

A: Given data: - The force to support the load is T = 210 N.

Q: Four forces are exerted on the eyebolt as shown. If the net effect on the bolt is a direct pull of…

Q: The leg and cast in Figure P4.40 weigh 220 N (w). Deter- mine the weight wz and the angle a needed…

A: From the diagram given in the question,

Q: A setup similar to the one shown in the figure below is often used in hospitals to support and apply…

A: Part (a) Assuming the pulleys to be frictionless, then the tension in the string at each end will be…

Q: A 30 kg mass is supported at the end of a horizontal beam of negligible mass that is hinged to a…

A: In this problem we will use the condition of static equilibrium. Sum of vertical forces is zero.…

Q: Suppose you use an ideal pulley of the top shown in figure 5.18 (b) and find it necessary to exert a…

Concept explainers

Rotational Equilibrium And Rotational Dynamics

In physics, the state of balance between the forces and the dynamics of motion is called the equilibrium state. The balance between various forces acting on a system in a rotational motion is called rotational equilibrium or rotational dynamics.

Equilibrium of Forces

The tension created on one body during push or pull is known as force.

Question

Q.5) Two weights C = 2000 N
and D = 1000 N are located on a
1 m
B
A
D
horizontal beam AB as shown in
4 m
Figure. Find the distance of
weight C from support A, i.e., x so that the support
reaction at A is twice that at B. Both supports are roller.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A uniform horizontal strut weighs 400.0 N. One end of the strut is attached to a hinged support the wall and the other end of the strut is attached to a sign that weighs 200.0 N The strut is also supported by a cable attached between the end of the strut and the wall. Assuming that the entire weight of the sign is attached at the very end of the s find the tension in the cable and the force at the hinge of the strut.
Check Your Understanding A 50-kg person stands 1.5 m away from one end of a uniform 6.0-m-long scaffold of mass 70.0 kg. Find the tensions in the two vertical ropes supporting the scaffold.
If an odd number of forces act on an object, the object cannot be in equilibrium.
In order to lift a shovelful of dirt, a gardener pushes downward on the end of the shovel and pulls upward at distance l2 from the end, as shown below. The weight of the shovel is mg and acts at the point os application of F2 . Calculate the magnitudes of the forces F1 and F2 as functions of l1 , l2 , mg, and the weight W of the load. Why do your answers not depend on the angle that shovel makes with the horizontal?
Explain the need for tall towers on a suspension bridge to ensure stable equilibrium.
(II) Two cords support a chandelier in the manner shownin Fig. 9–4 except that the upper cord makes an angle of45° with the ceiling. If the cords can sustain a force of1660 N without breaking, what is the maximum chandelierweight that can be supported?
A 500-kg load is suspended from the end of a horizontal boom, as in the figure. The angle between the boomand the cable supporting its end is 450Assuming that the boom’s mass can be neglected compared with thatof the load, find (a) the tension in the cable and, (b) the inward force the boom exerts on the wall.
A trapeze artist, with swing, weighs 800 N; he is momentarily held to one side by his partner so that the swing ropes make an angle of 30.0° with the vertical. In such a condition of static equilibrium, what is the horizontal force being applied by the partner?
A uniform plank of length 2.00 m and mass 26.0 kg is supported by three ropes, as indicated by the blue vectors in the figure below. Find the tension in each rope when a 710–N person is d = 0.500 m from the left end. Answer the 3 boxes below:
A hungry bear weighing 730 N walks out on a beam in an attempt to retrieve a basket of goodies hanging at the end of the beam (see the figure below). The beam is uniform, weighs 200 N, and is 7.00 m long, and it is supported by a wire at an angle of θ = 60.0°. The basket weighs 80.0 N. (a) If the wire can withstand a maximum tension of 875 N, what is the maximum distance the bear can walk before the wire breaks?
A diving board 3.00 m long is supported at a point 1.00 m fromthe end, and a diver weighing 500 N stands at the free end (Fig. ).The diving board is of uniform cross section and weighs 280 N. Find(a) the force at the support point and (b) the force at the left-hand end.
A uniform drawbridge must be held at a 38o angle above the horizontal to allow ships to pass underneath. The drawbridge weights 55000 N and is 15.0 m long. A cable is connected 3.5 m from the hinge where the bridge pivots (measured along the bridge) and pulls horizontally on the bridge to hold it in place. What is the tension in the cable? Find the magnitude and direction of the force the hinge exerts on the bridge. If the cable suddenly breaks, what is the magnitude of the angular acceleration of the drawbridge just after the cable breaks? What is the angular speed of the drawbridge as it becomes horizontal? What is the velocity of the drawbridge, just before it “hits” (i.e. goes horizontal)?