Q1: A: What will be the (a) gage pressure (b)absolute pressure of water, at depth 14m below surface.Use (Pwater = 1000 kg/m³, PaTm = 101 kN/m²).%3D%3DB: Differential vacuum pressure between A and B equal to 10 kPa, and diameter for A&B equal to150mm and 200mm respectively. Determine reading (y). (Answer with sketch, See Fig.I)45cm25cmyWaterFig.1

Note:As per our guidelines we are supposed to answer only one question. Kindly repost other…

Answered: Q1: A: What will be the (a) gage…

Q1: A: What will be the (a) gage pressure (b)absolute pressure of water, at depth 14m below surface. Use (Pwater = 1000 kg/m³, Patm = 101 kN/m²). %3D

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter1: Heat, Temperature, And Pressure

Section: Chapter Questions

Problem 14RQ: Atmospheric pressure at sea level under standard conditions is ______inches of mercury (Hg) or_____...

See similar textbooks

Related questions

Q: A closed tank contains 0.5 m of mercury, 1.5 m of water, 2.5 m of oil of specific gravity 0.8 and…

Q: 3. A spaceship lands on a planet where the atmosphere is completely made of water (p = 1000 ). The…

A: Given data, ρ = 1000 kg/m3 g= 20 m/s2 H= 20 m

Q: For the system in the Figure below if atmospheric pressure is 100 kPa. Calculate the pressure at the…

Q: Q3. Determine the gauge pressure at point A in the figure shown. Is it higher or lower than…

A: The gauge pressure at point A is PA,gauge = 12281.62 Pa (vacuum). It is lower than Patmosphere.

Q: The open tank shown, which has a liquid with a specific gravity of S=12.4 as shown in the give…

A: Given Specific gravity = 12.4 Therefore Density = 12400

Q: Two pipes are connected by a manometer as shown in Fig. below. Determine the pressure difference, PA…

A: Given datax=0.6 my=1 mz=2.5 mv=9.81 kN/m3To find PA-PB in kPa

Q: B water mercury S-133 60 cm 60 cm 20 cm What is the pressure at the center of plpe l (kPa)

A: Given Data: The specific gravity of mercury, S=13.3

Q: 6. The water in a marine aquarium is 5 m deep. a. What is the pressure at the surface? b. What is…

A: We can take pressure at the surface of marine aquarium as atmospheric pressure (P atmospheric) =1…

Q: Q3: Manometer connected to car tire, the height of the mercury level increased by 80 cm above the…

A: Given data as per question Density of air = 1.29 kg/m3 considering reference plane

Q: A closed tank contains 0.5 m of mercury, 1.5 m of water 2.5 m of oil of specific gravity 0.8 and air…

Q: A manometer containing mercury with density, ρ = 13,600 kg/m3 is attached to a tank filled with air.…

Q: Q:- An 8-cm-diameter piston compresses manometer oil into an inclined tube, as shown in Fig. When a…

A: Given data Diameter of piston (dp) = 8 cm Oil rises distance = 10 cm

Q: Determine the depth of a liquid needed to create a pressure difference of 225 kPa if the liquid is…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: The open tank shown, which has a liquid with a specific gravity of S=5.7 as shown in the give…

A: Given Specific gravity = 5.7 Therefore Density = 5700 kg / m3

Q: Q2:- A wood cone floats in water in the position shown in fig.2.The specific gravity of the wood is…

Q: The tank contains water and immiscible bil with S=0.70. What is h in cm? h 6 cm 12 cm Oil Water

Q: QUESTION 7 "A vertical rectangular plate with a width of 18 m and a height of 13 m is located 5 m…

A: Given Width, w = 18 m Height, h = 13 m Depth in…

Q: The height difference is 760 mm, and the gauge pressure is 5,218.92 Pa. Find the density of the…

A: From Pascal's law in fluid mechanics Pressure will add when going downward. Pressure will subtract…

Q: At 20 ° C gage A reads 350 kPa absolute. What is the heighth of the water in cm? What should gage B…

A: Given Data: Absolute pressure at A is PA = 350 kPa. Temperature of system is T = 20 °C. The height…

Q: Any pressure reading can be expressed as a length or head,h = p / ρ g . What is standard sea-level…

A: Given data The temperature of all given fluid is, T = 20°C. The pressure at sea level, P = 101325…

Q: Fill a glass approximately 80 percent with water, and add alarge ice cube. Mark the water level. The…

A: It is stated that the glass is filled 80% with water, and a large ice cube added in the glass due to…

Q: Findthe pressure at a depth of 15 m below the free surface of water in a reservoir.

Q: A reservoir dam holds an 8.00-km² lake behind it. Just behind the dam, the lake is 12.0 m deep. What…

A: Given Data The depth of the lake is: h=12 m (a) The water pressure at the base of the dam is…

Q: The barometric pressure at the base of a building is 105 kPa and on the roof it is 98 kPa. If the…

A: It is the very basic but practical numerical where height of building calculated by barometer…

Q: An oil storage tank contains oil with specific gravity of 0.88 and depth of 20 meters. What is the…

A: Given Data S=0.88 H=20 m

Q: 2.37 The inclined manometer in Fig. P2.37 contains Meriam red oil, SG = 0.827. Assume the reservoir…

Q: What would be the submerged weight (submerged weight = weight – buoyant force) of a 12m³ of steel in…

Q: A closed tank contains 0.610 m of mercury, 1.524 m of water, 2.438 m of oil of specific gravity…

A: Given Data Pb= 276 kPag

Q: The speicfic gravity of a liquid is 0.75. what height of that liquid is needed to provide a pressure…

Q: 1.) A wooden block 4mx1mx0.5m is floating in water. Its specific gravity is 0.82. Find the volume of…

Q: Three different liquids are used in the manometer shown below. www P₁ P₂ T hi Pc Suppose fluid A is…

Q: P2.30. Determine the pressure difference, P, – Pa betv 0.5 m Water 0.6 m 1.3 m Gage fluid (SG = 2.6)…

Q: Q3 (a) Consider a large cubic ice block floating in seawater. The specific gravity of ice is 0.92.…

Q: Q2:- A steel cylinder of (s.g submergence , h? 0.64) floats on water , find the depth of

A: Given data S.G of cylinder = 0.64 Diameter = 8 cm Density of water = 1000 kg/m3 Density of cylinder…

Q: A tank of height 30 cm is filled with water up to a height of 10 cm. Oil with SG= 0.9 is poured to…

Q: The open tank shown, which has a liquid with a specific gravity of S=12.7 as shown in the give…

A: As the fluid is accelerated upwards it will lead to pseudo acceleration(a) acting on the fluid in…

Q: I have attached a figure of an inclined manometer problem. I know I am supposed to use Lsine(α)=H.…

A: Obtain the value of L when the water is compressed by a distance h and the liquid in the pipe is…

Q: A block of steel floats at a mercury-water interface as shown. Then the ratio of a and b for this…

A: Given:(SG)Hg=13.57(SG)steel=7.85

Q: What is the absolute pressure at a point 4 meter below the free surface of liquid of specifc gravity…

A: Given: Atmospheric pressure = 750 mm of Hg depth of point from free surface of liquid, h = 4 m…

Q: The open tank shown, which has a liquid with a specific gravity of S-6.2 as shown in the give…

A: Given Specific gravity = 6.2 Therefore Density = 6200 kg / m3

Q: Determine the pressure difference between point A and B using the following Specific Gravity:…

A: Given Data: The specific gravity of Benzene, 0.88 The specific gravity of air,0.0118 The specific…

Q: In Fig. , determine the gage pressure at point A in Pa.Is it higher or lower than atmospheric?

A: Pressure at A can be determined as,

Q: Explain the Variation of Pressure with Depth?

A: Let us consider that there is a tube filled with some fluid and at a depth h from the free surface a…

Q: 2.1. Determine the gage pressure at point A in Pascal .Is it higher or lower than atmospheric?…

A: By the help of hydrostatic law, we will develop a relationship as:

Q: Q1: A: What will be the (a) gage pressure (b)absolute pressure of water, at depth 14m below surface.…

A: Given Data Depth of liquid is : h=14 m ρwater =1000 kg/m3 Patm=101 kN (a) Gauge pressure of due to…

Q: How much does the capillary water rise above the water table in a very fine sand (d = 0.1 mm) if the…

A: Given Data, d = Diameter of the capillary = 0.1 mm = 0.1x10-3 m ζS = Surface tension of water =…

Q: If you dive to 3 m below the surface of a swimming pool fill with milk, (a) what is the pressure due…

A: The most common method of monitoring pneumatic pressure is gauge pressure. It is the compressed…

Q: Determine the gage pressure in kPa at point "a", if the liquid A has a SG = 1.20 and liquid B has SG…

Q: 4. Figure shows a tank within a tank, each containing air. Pressure gage A is located inside the…

Q: Q.- Two water tanks are connected to each other through a mercury manometer with inclined tube as…

Question

Q1: A: What will be the (a) gage pressure (b)absolute pressure of water, at depth 14m below surface.
Use (Pwater = 1000 kg/m³, PaTm = 101 kN/m²).
%3D
%3D
B: Differential vacuum pressure between A and B equal to 10 kPa, and diameter for A&B equal to
150mm and 200mm respectively. Determine reading (y). (Answer with sketch, See Fig.I)
45cm
25cm
y
Water
Fig.1

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

A closed tank contains 0.610 m of mercury, 1.524 m of water, 2.438 m of oil of specific gravity 0.750, and an air space above the oil. If the pressure at the bottom of the tank is 276 kPa gage, what should be the reading of the gage in the top of the tank?
A cylindrical tank contains a certain liquid (SG = 1.36) to a depth of 0.5 m. A pressure of 59 kPa is acting at the surface of the liquid. If it is accelerated upwards at 4.99 m/s2, what is the resulting pressure (kPa) at the bottom of the tank?
18 - A cylindrical tank with a diameter of 20 cm and a height of 50 cm was filled with water to a height of 30 cm. If the tank is rotated about the vertical axis of symmetry at a constant speed of 21 rad/s, what will be the pressure difference between the bottom center and bottom edge of the tank? a) 1750 Pa B) 1045 Pa NS) 3327 Pa D) 2205 Pa TO) 1125 Pa
11th - A rectangular plate with a width of 2 m and a height of 3 m was submerged in water. The distance of the upper edge of the plate from the free surface of the water is 5 m. Since the atmospheric pressure is 95 kPa, what is the hydrostatic pressure force on the plate surface considering the atmospheric pressure? a) 688 kN B) 747 kN NS) 864 kN D) 307 kN TO) 2950 kN
A closed tank contains 0.610 m of mercury ( specific gravity = 13.6 ), 524 m of water, 2.438 m of oil ( specific gravity = 0.75 ) and an air space of 1 m above the oil. If the pressure at the bottom of the tank is 276 kPa, what should be the reading of the gage in the top of the tank?
An oil storage tank contains oil with specific gravity of 0.88 and depth of 20 meters. What is the hydrostatic pressure at the bottom of the tank in kg/cm2?
ASAP pls dont round off initial values, round off final ans only ty An open tank contains 3.86 m of oil (sp.g=0.8) and 5.41 m of water. Find the pressure at the midpoint level of water.
The pressure 10 ft below the free surface of a liquid is 6.51 inHg. What is the specific gravity of the liquid?
On a sea-level standard day, a pressure gage, mooredbelow the surface of the ocean (SG = 1.025), readsan absolute pressure of 1.4 MPa. How deep is theinstrument?( a ) 4 m, ( b ) 129 m, ( c ) 133 m, ( d ) 140 m, ( e ) 2080 m
An atmospheric pressure of 101.325 kPa will be supported by how much height of the water? a. 10.32 m b. 15.42 m c. 13.23 m d. 15.45 m
The speicfic gravity of a liquid is 0.75. what height of that liquid is needed to provide a pressure difference of 200 kPa?
An object (SG = 7.3) floats in mercury (SG = 13.6) such that a certain portion is above the liquid surface. If the volume of the object below the liquid surface is 0.014 m3, what is the weight, in kN, of the object? Round off to two decimal places.