Q3: Manometer connected to car tire, the height of the mercury level increased by 80 cm above the air level which is 10 cm below the measuring point on the left limb, density of the air is 1.29 Kg/m³, find the car pressure? If the height of the mercury level is decreased to 600 mm then what happens to car pressure. Discuss the results for car pressure.

Q3: Manometer connected to car tire, the height of the mercury level increased by 80 cm above the air level which is 10 cm below the measuring point on the left limb, density of the air is 1.29 Kg/m³, find the car pressure? If the height of the mercury level is decreased to 600 mm then what happens to car pressure. Discuss the results for car pressure.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A mercury barometer at the base of the mountain reads 620 mm. At the same time, another barometer read 450 mm. Assuming w of air is to be constant at 10 N/m^3, what is the appropriate height of the mountain?
The inverted U-tube manometer of Fig. contains oil (SG 0.9) and water as shown. Find The pressure differential between pipes A and B. If a =1.5 m , h= 90 cm and b=2 m.
In Fig.the tank contains water and immiscibleoil at 20 ° C. What is h in cm if the density of the oil is898 kg/m 3 ?
A Russian submarine crashs, loses control and runs aground at the bottom of the sea. The pressure,at atm, to which the submarine gets subject ed when it ran aground at a depth of 100 meters is?(For seawater take that density is worth 1000 kg/m³)
Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe A is 35 cm above the pipe B. The height of oil in right limb is 25 cm. Also, the mercury level difference is found in right limb as 90 cm. Find the pressure difference between these two pipes in kPa. Also find the pressure equivalent in water head in mm.
A cylindrical tank is fully filled with water (Fig. P3–67).In order to increase the flow from the tank, an additionalpressure is applied to the water surface by a compressor. ForP0 = 0, P0 = 5 bar, and P0 = 10 bar, calculate the hydrostaticforce on the surface A exerted by water.
A U-tube manometer filled with water, density 62.4 lbm/ft^3, shows a height difference of 10 in, what is the gauge pressure?
The system in Fig. is at 20 ° C. If atmosphericpressure is 101.33 kPa and the pressure at the bottomof the tank is 242 kPa, what is the specific gravity offluid X ?
A U tube differential manometer containing mercury was used to measure the difference of pressures in two pipes containing water. The difference in mercury level is 0.8 m, the level of water in left limb from mercury level to center of the left pipe is 1.9 m and the level of water in right limb from mercury level to center of the left pipe is 0.8 m. Find the head difference in m. S for water = 1, S for mercury 13.6. b. Draw a neat diagram shows all parameters. c. Discuss the differences between U tube and slanted U tube manometers. Difference in heads in m
A U tube differential manometer containing mercury was used to measure the difference of pressures in two pipes containing water. The difference in mercury level is 0.9 m, the level of water in left limb from mercury level to center of the left pipe is 1.8 m and the level of water in right limb from mercury level to center of the left pipe is 0.8 m. Find the head difference in m. S for water = 1, S for mercury 13.6. b. Draw a neat diagram shows all parameters. c. Discuss the differences between U tube and slanted U tube manometers.
A water tank of circular shape of diameter 1.2 m is fitted at the top of a building.Find the total pressure exerted by water when it contains 1.6 m of water
A wedge splits a sheet of 20 °C water, as shown in Fig.P3.39. Both wedge and sheet are very long into the paper.If the force required to hold the wedge stationary is F =124 N per meter of depth into the paper, what is the angleθ of the wedge?