Q1/ The angular velocity Q of a car wheel was found to be a function of its height H as compared to the car height L, diameter D, the number of blades N, wind speed V, and density of air p. Find appropriate pi groups for this problem when viscosity effects are neglected.

Q1/ The angular velocity Q of a car wheel was found to be a function of its height H as compared to the car height L, diameter D, the number of blades N, wind speed V, and density of air p. Find appropriate pi groups for this problem when viscosity effects are neglected.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.5P: Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen,...

See similar textbooks

Related questions

Q: The sketch shows an oil manometer that is connected between two pipes which transport water. The…

A: Given, h1=0.17 mh2=350 mm=0.35 mh3=15 cm=0.15 m The specific gravity of the oil, γo=0.76 The density…

Q: certain gasoline weighs 7 kN/ cu. M, what are the values of its der ecific volume and specific…

Q: A steel ball with the density of 6229 kg/m and the radius of 0,65 cm was dropped into the oil whose…

A: Givenρb=6229 Kg/m3r=0.65 cms=99 cmt=4.7 secmo=2.1 gVo=100 ml

Q: 1. If the level of the liquid measured by using capacitive probe and buoyant force is same, find the…

A: Buoyant force: It is the force applied on the object when any object is fully or partially submerged…

Q: If the fluid rises to a height of 160 mm, we write its gauge pressure as 160 mm H2O. (a) Express…

A: Solution:

Q: What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.00201 N/cm2…

Q: nd the Prandtl number of the mercury at 300 K. If the properties of mercury at 300 K are, Density =…

A: Given:ρ=13529 kg/m3Cp=0.1393 kJ/kg.Kμ=0.1523×10-2 N/s/m2k=8.540 W/mKT=300 K

Q: A square block has 320 mm bottom sides dimensions, weighing W is 1.4 kN on an edge slides down an…

A: Given data: The bottom side, a = 320 mm. The weight of the block, W = 1.4 kN. The incline angle,…

Q: Air with density of 1.225 kg/m^3 and viscosity of 1.789 x 10^-5 kg/m-s flows in a wind tunnel, the…

Q: 1- The thrust (P ll i) of a propeller depends upon diameter (D); speed (u) through a fluid density…

A: The dimensional formula for each is as shown below.

Q: A flat plate of area 1.5 x 106 mm2 is pulled with a speed of 0.5 m/s relative to another plate…

A: Given : A = 1.5 x 106 mm2 = 1.5 m2 dy = 0.2 mm du = 0.5 m/s viscosity = 1 poise = 0.1 N.s/m2

Q: Q2:- If the velocity of flow v, dynamic viscosity u, bulk modulus of elasticity K and diameter of…

Q: Q3) The quantities viscosity H, velocity V, and surface tension Y may be combined into a…

Q: The belt in Fig. P1.52 moves at a steady velocity V andskims the top of a tank of oil of viscosity μ…

A: This numerical is based on the Dimensional Analysis area. Dimensional Analysis technique is widely…

Q: The quantities viscosity u, velocity V, and surface tension Y may be combined into a dimensionless…

Q: Using Laplace equation figure out how higher than atmospheric pressure is the inner pressure in a…

Q: Q1/ The angular velocity n of a car wheel was found to be a function of its height H as compared to…

Q: (d) The force, F, of a turbine generator is a function of density p, area A and velocity v. By…

A: d) The dimensions of the variables are given by,

Q: 4.1 Use the Buckingham a method to develop an expression for the viscous torque T produced on a disc…

A: 4.1 The given system is - T = fD,N,μ,ρ The total variables is 5 (including T) . TTorque=ML2T-2, D=L,…

Q: 3. A piece of wood that measures 3.0 cm by 6.0 cm by 4.0 cm has a mass of 80.0 grams. What is the…

A: 3. Given: The volume of the piece of wood, V = 3 cm x 6 cm x 4 cm The mass of wood, m = 80 gm

Q: A soccer referee inflates a soccer ball to the standard required measured pressure for a game of…

Q: Task 1 (d) The force, F, of a turbine generator is a function of density p, area A and velocity v.…

A: “Since you have asked multiple question, we will solve the first question for you. If youwant any…

Q: A sphere 6 ft in diameter, contains oxygen at 300 psi a and 80 o F.How many drums 6 inch in diameter…

A: Since we are allowed to answer one question at a time. We’ll answer the first question since the…

Q: 1 (a) A plate 0.05mm distant from a fixed plate moves at 1.15 m/s and required a force per unit area…

A: Given:Distance between plates, y=0.05 mmvelocity of moving plate, v=1.15 m/sForce per unit area=3.2…

Q: A block of weight W is being pulled over a table by another weight Wo, as shown in Fig. P1.60. Find…

Q: q1(c) A 20 × 20 cm cubical block slides on an oil surface over the inclined plane at 20° horizontal.…

Q: As shown in Fig. 1.12, a horizontal interface 0-0 exists between two immiscible liquids. The dynamic…

Q: C1 (a). A lubricating oil having the dynamic viscosity of 0.051 poise and specific gravity of 1.12.…

A: Given data: Dynamic viscosity of oil, µ = 0.051 poise. The specific gravity of oil, SGoil = 1.12.…

Q: Determine the dynamic viscosity in terms of Ns/m2 of a fluid

A: Kinematic viscosity=0.036 Specific gravity=0.9

Q: the Newton's law of viscosity with one CAum (b) Calculate the pressure difference (in kPa) between…

Q: 10A plate 0.05mm distant from a fixed plate moves at 1.25 m/s and required a force per unit area of…

A: GIVEN DATA- 1(a) SHEAR STRESS =2.2N/m2 , U=1.25 m/s , y=0.05mm , Specific gravity of oil =0.7 1(b)…

Q: Example: H. VV Example : Pressure in A Decelerating Tank of Liquid The tank on a trailer truck is…

A: Given data The tank on a trailer truck is filled completely with gasoline, which has a specific…

Q: A manometer is a device that measures pressure using a curved tube filled with liquid of constant…

Q: The efficiency (n) of a fan depends upon density (p), and dynamic viscosity (µ) of the fluid,…

Q: hree different liquids (A, B, and C) are used in the monometer as shown bellow. 1- Drive an…

A: Given data: The magnitude of pressure P2 = 1.5 bar. The density of methanol, ρA = 0.792 g/cm3. The…

Q: The pressure at 9.85m depth in a fluid is 102,482Pa. Calculate the density of the fluid and present…

Q: skater weighing 500 N skates at 10 m/s and is supported by an average skating area of 10 cm2. If the…

Q: : Using Raleigh’s method, Analyze an equation to determine the resistance, P of a sphere of…

Q: In Figure below all fluids are at 20 deg.C. Determine pressure at point B, if pressure at point A is…

Q: Q5(b) | The force (F) exerted by a flowing fluid on a stationary square plate of height (L),…

A: Let Force exerted by the flowing liquid be a function of height (L), Velocity (V), Density (ρ),…

Q: Find a non-dimensionless expression relates h with the other given variables by using Buckingham…

Q: Q2: The function relates the different variables in a capillary rise of a liquid is given by: h=f…

Q: Q1 : Calculate the viscosity index for a crude oil has achange in viscosity due to changin…

A: Given L = 90 cSt H = 40 cSt U = 0.05 × 10-4 / 0.8 = 62.5 cSt

Q: The kinematic viscosity of liquid oil is 20 stoke and relative density = 0.85. Find the dynamic…

A: Given: kinematic viscosity of liquid = 20 stokes The relative density = 0.85

Q: In Figure below all fluids are at 2o deg.C. Determine pressure at point B, if pressure at point A is…

A: Given:PA=150 KPaTo determine the pressure at point B.

Q: When disturbed, a floating buoy will bob up and down atfrequency f . Assume that this frequency…

A: (a) The given dimensionless function: - Assume,Frequency, f=fncm,d,γWhere m is mass of buoy,d is…

Q: 1 (a) A plate 0.05mm distant from a fixed plate moves at 1.15 m/s and required a force per unit area…

Q: The increase in pressure in the blood vessels is transmitted to the cerebrospinal fluid. What should…

A: Solution:

Q: A hemispherical container, 26 inches in diameter, is filledwith a liquid at 20 ° C and weighed. The…

A: Given Data⇒Diameter of hemispherical containerD=26 inradious of hemispherical containerr=262 inr=13…

Q: If a scuba diver descends too quickly into the sea, the internal pressure on each eardrum remains at…

Question

Q1/ The angular velocity 2 of a car wheel was found to be a function of its height H as
compared to the car height L, diameter D, the number of blades N, wind speed V, and
density of air p. Find appropriate pi groups for this problem when viscosity effects are
neglected.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Step 1

VIEW

Step by step

Solved in 2 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen, air, and saturated steam at a temperature of 100C. Let D=1m,U=1m/sec, and hc=1W/m2K.
The quantities viscosity µ, velocity V, and surface tension Y may be combined into a dimensionless group. Find the combination which is proportional to µ. This group has a customary name, which begins with C. Can you guess its name?
A plate 0.05mm distance from a fixed plate moves at 1.25 m/s and required a force per unit area of 3 Pa to maintain this speed by using an oil of specific gravity 0.65. Find the dynamic viscosity in centipoise and kinematic viscosity in stokes of the fluid between the plates. Calculate the specific weight in kN/m³, density, and the specific gravity of a liquid having a volume of 662900 cm and weight of 55 kN
The variables in a Saybolt viscometer are the time (t) required to empty a certain volume of oil of density (ρ) and viscosity (μ), a length (L) representing the dimensions of the viscometer, and the gravitational acceleration (g). Using the Buckingham Pi-theorem, show that
The thrust force, F generated by a propeller is found to depend on the followingparameters: diameter D, forward velocity u, density ρ, viscosity µ and rotationalspeed N. Determine the dimensionless parameters to correlate the phenomenon
Books on porous media and atomization claim that the viscosityμ and surface tension Y of a fl uid can be combinedwith a characteristic velocity U to form an important dimensionlessparameter. ( a ) Verify that this is so. ( b ) Evaluatethis parameter for water at 20°C and a velocity of3.5 cm/s. Note: You get extra credit if you know the nameof this parameter.
The pressure coefficient is defined by the ratio between the static pressure difference and the dynamic pressure (pictured): Where P is the static pressure [Pa], P∞ is the reference static pressure [Pa], ρ is the density [kg/m3], and V is the velocity [m/s]. Using the primary dimensions and their units, show that the pressure coefficient is dimensionless.
The belt in Fig. P1.52 moves at a steady velocity V andskims the top of a tank of oil of viscosity μ , as shown.Assuming a linear velocity profi le in the oil, develop asimple formula for the required belt-drive power P as afunction of ( h , L , V , b , μ ). What belt-drive power P , inwatts, is required if the belt moves at 2.5 m/s over SAE30W oil at 20° C, with L = 2 m, b= 60 cm, and h = 3 cm?
When disturbed, a floating buoy will bob up and down atfrequency f . Assume that this frequency varies with buoymass m , waterline diameter d , and the specific weight γ ofthe liquid. ( a ) Express this as a dimensionless function. ( b )If d and γ are constant and the buoy mass is halved, howwill the frequency change?
Taylor number (Ta) is used here to describe the ratio between the inertia effect andthe viscous effect. By applying Buckingham Pi’s Theorem, determine an equation forTa as a function of the radius of inner cylinder (r), cylinder tangential velocity (v),fluid dynamic viscosity (μ), gap distance (L) and fluid density (ρ).
Consider the pressure Drop depends on : characterstic lugth I density gravity g speed of sound с angular velocity w Surface tension 6 Velardy of fluid V Viscosity of M write an an expression of the pressu drop ?
Q2: The function relates the different variables in a capillary rise of a liquid is given by: h = f (d, g, ?, ?, ∅) where; h= capillary rise, d= tube diameter, ? = mass density, ? = surface tension; ∅ = contact angle Find a non-dimensionless expression relates h with the other given variables by using Buckingham theorem