Q16. As shown in the image below, the 0.9-kg ball strikes the rough ground and rebounds. The directions of its velocities before and after the strike are shown. If the speeds are v1 = 23 m/s and v2 = 11 m/s, determine the magnitude of the ball's linear momentum (in kg-m/s) before it strikes the ground. Please pay attention: the numbers may change since they are randomized. Your answer must include 1 place after the decimal point. V2 v1 45° 30°

Q16. As shown in the image below, the 0.9-kg ball strikes the rough ground and rebounds. The directions of its velocities before and after the strike are shown. If the speeds are v1 = 23 m/s and v2 = 11 m/s, determine the magnitude of the ball's linear momentum (in kg-m/s) before it strikes the ground. Please pay attention: the numbers may change since they are randomized. Your answer must include 1 place after the decimal point. V2 v1 45° 30°

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Dynamic Lesson The ski and the rider, with a total mass of 90 kg, are moving along the curved path in the shape. Since the equation of the curvilinear path is determined as y = 0.08x2 and the speed at x = 10 m is known as 5 m / s, the skier at this pointa) The rate of increase in speed,b) Obtain the value of the Normal force applied to ski.
Application of de A motorboat and its load weigh 2,450 N. AssumIng that the propeller force is constant and equal to 120 N, and water resistance is equal numerically to 7.50v N, where v is the speed at any instant in m/sec., and if the boat starts from rest, determine the speed and the distance traveled at the end of 10 seconds.
The ski and the rider, with a total mass of 90 kg, are moving along the curved path. Since the equation of the curvilinear path is determined as y = 0.08x2 and the speed at x = 10 m is known as 5 m / s, find the value of a) the rate of increase in the speed of the skier at this point, b) the normal force applied to skiing.
the P platform is located on a spring and is tied to the ground with lines so that they cause the spring to deflect from a free state of 1 m to 0.4 m. Next, a brick with a mass of 2 kg was placed on the platform and the spring was loaded by 0.1 m, and then the platform with the brick was released so that the brick was shot up to the height h. Determine the height h in relation to the ground. Assume the acceleration due to gravity g = 9.81 m / s ^ 2. k = 250 N/m
A steel ball was released from rest into a cylinder full of water. the downward acceleration up the ball is defined by the equation a=0.9g-CV. whose g is accelerating due to gravity. C=3.02/s. Det. the velocity in m/s after 0.25mins. a) Det. the dept of the ball from the water surface after 0.25 mins. b.) when of the following most nearly gives the acceleration of the ball when it reaches the bottom if the total height of the cylinder is 50 ft?
What allows us to make the determination that the boxes arent moving at the same velocity after being released from rest? It seems to me we would base this off of each boxes resistance to friction, but in this problem they are moving on a smooth surface. And then in this problem, we consider the boxes to move at the same velocities after the spring is released? Please explain how we can make this judgement. This is the problem: The two blocks A and B each have a mass of 5 kg and are suspended from parallel cords. A spring, having a stiffness of k=60 N/m is attached to B and is compressed 0.3 m against A and B as shown. Determine the maximum angles θ\thetaθ and ϕ\phiϕ of the cords when the blocks are releasedfrom rest and the spring becomes unstretched.
A ball is thrown vertically upward with a speed (vo) of 15 m/s at an initial position of so= 10 m. The ball is subjected to a constant downward acceleration of 9.81 m/s2. Determine the maximum height, smaxreached by the ball. Determine the time of flight when it returns to its original position. Determine the time of flight when it hits the ground. Determine the velocity just before it hits the ground. Check your answer using a different equation. Plot v(t) and s(t) from t = 0 to the time when the ball hits the ground.
A mass m is initially at rest at the center of the coordinate system.When t = 0, a force F = F0(1-te−λt) is applied to the particle. Determine the acceleration, velocity, and position of the particle as a function of time
The horizontal motion of the plunger and shaft is arrested by the resistance of the attached disk which moves through the oil bath. The velocity of the plunger is v0 = 3.1 m/s in the position A where x = 0 and t = 0, and the deceleration is proportional to v so that a = -kv where k = 0.32 s-1. Find (a) the velocity when t = 2.9 s, (b) the position x when t = 2.9 s, (c) the velocity when x = 4.2 m.
The motion of a particle is defined by the function x = at3 - bt2 - ct + d where x is in centimeters and t is in seconds When is the particle at rest if a = 1.3, b = 3.5, c = 8.3, and d = 5.2?
5. A slider of mass 10 kg moves along a slipway as shown. The spring has a value of K = 60 N/m and when the slider is stationary atAt position A, the spring is stretched for a distance of 0.6 m. moves through point CAt a speed of 1.2 m/s, find the magnitude of the force acting on the end of the rope.
Determine the acceleration produced in a body of 20 kg mass when it is acted upon by a force of 200N. Use D’ Alembert’s principle.