Q2) A 4 pole, lap wound, compound DC generator has an armature resistance of 0.2 Q, series field resistance of 0.12 and a shunt field resistance of 220 Q. The generator supplies the following loads as follows, Load 1 (L1): 200 Lamps, each lamp is rated at 40 W, at a terminal voltage of 220 V. Load 2 (L2): A 5 KW heater at a terminal voltage of 220 V. The machine has 1000 conductors, assume long shunt connection, a) Calculate the total load current. b) Find the generated voltage, Eg and total load power. c) If all lights are turned off, calculate the generated voltage of the machine, Eg, and the speed of the machine,. if flux is 20 mwb/pole.

Q2) A 4 pole, lap wound, compound DC generator has an armature resistance of 0.2 Q, series field resistance of 0.12 and a shunt field resistance of 220 Q. The generator supplies the following loads as follows, Load 1 (L1): 200 Lamps, each lamp is rated at 40 W, at a terminal voltage of 220 V. Load 2 (L2): A 5 KW heater at a terminal voltage of 220 V. The machine has 1000 conductors, assume long shunt connection, a) Calculate the total load current. b) Find the generated voltage, Eg and total load power. c) If all lights are turned off, calculate the generated voltage of the machine, Eg, and the speed of the machine,. if flux is 20 mwb/pole.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A long shunt compound generator delivers a current of 10A at 200V and has a series field resistance and shunt field resistance of 1 ohm and 200 ohms respectively. Then line current is a. 2A b. 1A c. 9A d. 10A
D2. When a generator's full-load output voltage is the same as its no-load output voltage it is said to be a) under-compounded b) flat-compounded c) over-compounded d) none of the above D3. The output of an overcompounded DC generator can be lowered by use of a a) rheostat connected in series with the series field b) rheostat connected in parallel with the series field c) rheostat connected in parallel with the shunt field d) none of the above D4. When might it be desirable to use an overcompounded generator? a) never b) always c) to compensate for line loss d) when you need a higher no-load voltage than your full-load voltage
A short shunt compound generator delivers 150A at a terminal voltage is 230V. The shunt field current is 2.5A. The resistances of the armature, series field and diverter are 0.032-ohm, 0.015 ohm and 0.03 ohm, respectively. Calculate the electrical efficiency of the generator at this load.
There are 144 slots in a 3-phase, 16-pole, 50 Hz., star connected alternator. There are 4 conductors in each slot and all the conductors in a phase are connected in series. Coil span is 1500 electrical and the flux per pole is 0.05 Weber sinusoidallly distributed. Calculate the emf induced per phase.
The terminal voltage of a 150 kW series generator is 600 V at rated load. The armature resistance is 0.06 ohms and the series field resistance is 0.04 ohms. Find generated emf.
A single phase, 2000 V alternator has armature resistance and reactance of 0.8 ohms and 4.94 ohms respectively. The voltage regulation of the alternator at 100 A load at 0.8 leading power factor is ??
A wave wound armature of an eight-pole generator has 06 slots. Each slot contains 16 conductors. The voltage required to be generated is 300 V. What would be the speed of coupled prime mover if flux per pole is 0.05 Wb.If the armature is rewound as duplex lap wound machine and run by same prime mover, what will be the generated voltage.
12. Calculate the number of series turns per pole required on a com generator to enable it to maintain the voltage constant at 460 V be- tween no load and full load of 100 kW. Without any series winding, it is found that the shunt current has to be 2 A on no load and 2-65 A on full load to maintain the voltage constant at 460 V. Number of turns per pole on the shunt winding 2000 If the series coils were wound with 8 turns per pole and had a total resistance of 0-01 2, what value of diverter resistance would be re- quired to give level compounding? !!
1.) A 6-pole, 3-phase, 60-Hz alternator has 12 slots per pole and four conductors per slot. The winding is 5/6 pitch. There are 0.025 Wb entering the armature from each north pole, and this flux is sinusoidally distributed along the air gap. The armature coils are all connected in series. The winding is wye-connected. Determine the open circuit emf per phase of the alternator. Subject Electrical machine 2
3) 4 Pole generator has a wave wound armature with 32 conductor per slot. The flux per pole is 40mWb and the speed of the generator is 480rpm. Find the total number of slots to generate an EMF of 409.6V
The dc armature resistance of delta-connected alternator measured across its two terminal is 0.8 ohm. The effective resistance per phase is?
Q- In a DC generator, what will be change in emf induced if flux is reduced by 20% and the speed is increased by 20%.