Q2)two shunt generators running in parallel supply a total load current of ( 4000 A ) .Each generator has an armature resistance of (0.02 ohm )and a field resistance of ( 40 ohm). The fields are excited so that the E.M.F induced in one generator is (480 v ) and another ( 490 V) . Find the bus-bar voltage and kilowatt output of each generator ?

Q2)two shunt generators running in parallel supply a total load current of ( 4000 A ) .Each generator has an armature resistance of (0.02 ohm )and a field resistance of ( 40 ohm). The fields are excited so that the E.M.F induced in one generator is (480 v ) and another ( 490 V) . Find the bus-bar voltage and kilowatt output of each generator ?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter11: Transient Stability

Section: Chapter Questions

Problem 11.3P

See similar textbooks

Similar questions

A separately excited generator has no-load voltage of 125V. A certain load rated at 1200W, 120V is then connected at the terminal. Calculate the series resistance needed to connect to the armature circuit in order for the load to operate at rated condition if the armature resistance is 0.0692Ω.
A shunt generator supplies a 31kW load at 230V through cables of resistance, R = 122mΩ. If the field winding resistance, Rf =50Ω and the armature resistance, Ra =51mΩ. Determine the following below: The terminal voltage is, Answer and unit for part 1 The e.m.f. generated in the armature is,
A shunt generator supplies a 33kW load at 225V through cables of resistance, R = 100mΩ. If the field winding resistance, Rf =56Ω and the armature resistance, Ra =40mΩ. Determine the following below: The terminal voltage is, The e.m.f. generated in the armature is,
A short shunt compound generator has an armature; series field and shunt field resistances of 0.031Ω, 0.04Ω and 100Ω respectively. At rated load condition, the terminal voltage is 400V while the armature is developing an emf of 409V. Find the kW delivered to the load at rated condition.
Two similar 6,600-V, 3-φ, generators are running in parallel on constant-voltage and frequency bus bars. Each has an equivalent resistance and reactance of 0.05 Ω and 0.5 Ω respectively and supplies one half of a total load of 10,000 kW at a lagging p.f. of 0.8, the two machines being similarly excited. If the excitation of one machine be adjusted until the armature current is 438 A and the steam supply to the turbine remains unchanged, find the armature current, the e.m.f. and the p.f. of the other alternator. [789 A, 7200 V, 0.556]
(a) A short shunt cumulative compound dc generator supplies 6kW at 235V. The Shunt field resistance, Series field resistance and Armature resistances are 8012, 0.192 and 0.22 respectively. Calculate the induced emf and load resistance.
The armature of a 6-pole separately excited dc generator is triplex wave wound with 534 conductors. This machine delivers power to the load at 200V while being driven at 900rpm. At this load, the armature circuit dissipates 640W. If the flux of this generator is 180-mWb, determine the kW rating of the load served. Assume a total brush drop of 2V.
A short shunt compound DC generator supplies a load current of 10A at a voltage of 10 volts. If the resistance of armature, shunt field and series field windings are 0.001 ohm, 1 ohm 0.00 ohm respectively. a) Draw the the figure. And find the generated voltage.
Two generators rated 200MW and 400MW are operating in parallel. The droop characteristics of both the governor have a drop of 4%. from no load to full load. Assuming that the generators are operating at 50Hz at no load, how would a load of 600MW be shared between them? What will be the system frequency at this load? Assume free governor operation.
Two similar 6,600-V, three phase generators are running in parallel on constant-voltage andfrequency bus bars. Each has an equivalent resistance and reactance of 0.05 Ω and0.5 Ω respectively and supplies one half of a total load of 10,000 kW at a laggingp.f. of 0.8, the two machines being similarly excited. If the excitation of onemachine be adjusted until the armature current is 438 A and the steam supply to theturbine remains unchanged, find the armature current, the e.m.f. and the p.f. of theother alternator.
111/ The armature reaction of the DC generator reduces the generated EMF. Select one: True False
A three-phase, Y-connected, 220 V, 5 kVA, salient-pole synchronous generator is employed to supply power to a load with unitary fp. By means of a slip test, the direct-axis synchronous reactance is determined to be 12 Ω and the quadrature-axis synchronous reactance, 7 Ω. Consider that the rated current is delivered to the load at the rated voltage and that the armature resistance is negligible. (a) Calculate the corresponding value of the excitation voltage. (b) What is the value of the internal phase shift angle? (c) What is the value of the power angle?