Q2: A. Three similar resistors connected in star draw a line current of 10 A from a 380-V, 3-phase mains. To what value should the line voltage be changed to obtain the same line current with the resistors connected in delta?

Q2: A. Three similar resistors connected in star draw a line current of 10 A from a 380-V, 3-phase mains. To what value should the line voltage be changed to obtain the same line current with the resistors connected in delta?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.9P: For the circuit shown in Figure 2.24, compute the voltage across the load terminals.

See similar textbooks

Related questions

Q: Q3: A 3- phase transmission line having impedance of (2+j6) ohm the supply voltage is 350-volt 50…

A: In this question we need to find efficiency of the system when the load is connected in delta and…

Q: . Explain the reasons for the low power factor in the power system network. 2. Discuss any two…

A: We need to explain the reasons for the low power factor in the power system network.

Q: Which of the following is not an advantage of hydroelectric power plant? Low running cost Fuel cost…

A: Hydro electric plant does not require fuel Hence No fuel cost Low running cost If water is…

Q: the efficiency of 3 discs insulation system is 85% for a 33kv transmission line and the voltage of…

Q: The desired secondary voltage is 115 volts l, 3-phase, to monitor the voltage of 230 kV line and…

Q: a wye connected load as 480v applied to it what is the volatage drop across each phase?

Q: Three similar resistors connected in star draw a line current of 10 A from a 380-V, 3-phase mains.…

A: Given: Line-to-line voltage VL = 380 V, Line current IL = 10 A. For a star-connected system, For…

Q: 4. The power taken by a 3-phase, 400-V motor is measured by the two wattmeter method and the…

Q: An over string of 2 insulators has Ce=0.14C. If the string is connected to 3- phase line has a…

A: GivenOver string of 2 insulators hasCe=0.14C3-phase line voltage VL=45 kV

Q: Which of the following statement is wrong for 3 phase 4 wire ac distribution systems? It is…

A: 3 phase 4 wire ac distribution system: It has 3 phases and 4 wires including 1 neutral wire. The…

Q: Over sting of 3- phase transmission line has 4 insulators and Ce=0.15C. If the voltage between the…

Q: Find the average voltage from 45⁰ to 180⁰ @ Em = 100 Volts? b) what is the average current if this…

Q: : The statement is True or False? If a balanced 3 phase supply is provided to an inductive load, the…

A: Given To determine given statement is true or false

Q: 2- In a PWM, given that the duty cycle is 80% what is the voltage output?

A: NOTE: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: A delta connected load with a resistance of 10 ohm and 50 mH in each branch is supplied by a star…

A: A delta connected load resistance =R=10 ohm Inductance L=50 mH Source is star connected mains at…

Q: A Current Transformer with a ratio of 50:2 and a PT with a ratio of 100:1 are connected to the…

A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…

Q: A wattmeter with a current coil connected to phase A, and the voltage between phase A and C gives a…

A: Since, the value of the current for each phase is different that means the system represents the…

Q: current and 3 kW at 220-V. Determine the values of resistance and reactance of each phase of the…

A: For a balanced delta connection The line voltage, VL = Phase voltage, VPh The line current, IL = 3…

Q: Three similar coils, each of resistance 10 Q and reactance 10 Q, are connected in star across a…

Q: Figure 2-18 shows a one-line diagram of a small 480-V industrial distribution system. The power…

A: WYE connection: If we connect together one side terminals of the poly-phase winding, a WYE…

Q: Three coils each having resistance 6  and inductance are connected in star with 415V. If the line…

A: Need to find power dissipated when they connected in delta

Q: Explain the working principle of three-phase separator. Support your answer with a diagram?

Q: determine total power consumed by resistor 3?

Q: If a 1500-W hair dryer is connected to a 120-V line. What is the maximum current drawn? I =

A: The solution is given below

Q: Label where each of the following electrical quantities would be found in both the “Y” and “Delta”…

Q: What is the reading (in kW) of both the wattmeter, when measuring the power of a three-phase three…

A: Given- Three-phase three wire systemInput power=5 kWPower factor=0.866To Find-The reading of both…

Q: The dc resistance line to line between the stator of a 3-phase IM is 0.835 ohm. It draws 7.1 A from…

A: In this question, We need to determine the stator copper losses if dc resistance RDC = 0.835 ohm…

Q: 20- The data of the devices used in a 220 V sinusoidal single-phase workshop are given below.…

A: In the question A single phase system given. The supplied voltage = 220 V According to this; What…

Q: Example 14.8. A 3-phase, 4-wire system supplies power at 400 V and lighting at 230 V. If the lamps…

Q: Calculate the line and phase current drawn bythe load

A: In this question, We need to calculate the line and phase current drawn by the load. Current I=…

Q: f a 1500-W hair dryer is connected to a 120-V line, what is the maximum current drawn?

A: An AC motor is an electrical machine which takes AC electrical input energy and produces mechanical…

Q: Q2:- Prove that neutral current can zero-sequence flow only if present. currents are 7:00 ✓

A: The objective is to proved the given statement.

Q: Question: Need Help! 1. In A Wye-Connected Circuit, If The Line-To-Line Voltage Is 346 V, What Is…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: find the ratio of volume of copper required to transmit a given power over a given distance by…

A: A three-wire DC system requires a minimum conductor area because as compared to an AC system for the…

Q: Three similar coils, each having a resistance of 8 Ω and an inductive reactance of 8 Ω are connected…

Q: b. Find the current I, e. Draw the power triangle. d. Find the type of elements and their impedance…

Q: An air conditioner draws 18 A at 220-V ac. The connectingcord is copper wire with a diameter of…

A: Given data, The value of current is I = 18 A. The value of voltage is V = 220 V. The value of the…

Q: 9. Where branch circuit panelboards for normal and essential power serve the same patient care…

A: The explanation is as follows.

Q: Simple summary about the measurement of power in a 3 Phase AC circuit using a two-wattmeter.…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Three loads each having a resistance of 10 ohms are connected in wye. The total three-phase power is…

Q: 2- Explain how Y-connected stator winding of alternator requires 58% of turns w.r.t. that of…

A: In the ∆-connected stator winding Line voltage =phase voltage VL=Vph In the Y-connected stator…

Q: 8. The nameplate rating of an electric iron is 120 V, 10 A. The heating element of this appliance is…

Q: In the Distribution System, the Feeders supplies the O A. DISTRIBUTION SUBSTATIONS O B. SERVICE…

A: Feeder is a conductor connect sub station to the area where power is distributed. In other word…

Q: Refer to circuit shown below, Determine: (a) The equation for Kirchhoff's Current Law (b) The 3…

Q: 1. In a wye-connected circuit, if the line-to-line voltage is 346 V, what is the line-to-neutral…

A: According to guidelines we need to solve only the first three sub-parts. According to the question…

Q: A voltmeter connected line to ground reads 66 volts. What is the transmission line voltage of the PT…

Q: 12 - What is the part of the grounding voltage that can be bridged by the body? A) Earth resistance…

A: What is the part of the grounding voltage that can be bridged by the body?

Q: In the Open-circuit test of the transformer (OC TEST), wattmeter measures 4.5 kW, in the short-…

Q: 1. Which of the following factors is not considered after selection of site for substation? a)…

A: In this question , we will write which factor we don't consider after selection of site for…

Q: a) The Electricity Company of Ghana (ECG) has noticed two different values of voltage between the…

A: Given : The different values of voltage between the No load voltage and the load voltage at the end…

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

Q2:
A. Three similar resistors connected in star draw a line current of 10 A from a 380-V, 3-phase mains.
To what value should the line voltage be changed to obtain the same line current with the resistors
connected in delta?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The dc resistance line to line between the stator of a 3-phase IM is 0.835 ohm. It draws 7.1 A from a 229 V line and pf is 0.19 at no load. What is stator copper loss? Use 1.25 as the factor to compute the effective resistance per phase
Three similar resistors connected in star draw a line current of 10 A from a 380-V, 3-phase mains.To what value should the line voltage be changed to obtain the same line current with the resistorsconnected in delta?
low voltage systems What is the system called if current flows through its neutral conductor? a)Balanced b)Unbalanced c)Proactive d)Complex
An air conditioner draws 18 A at 220-V ac. The connectingcord is copper wire with a diameter of 1.628 mm. (a) Howmuch power does the air conditioner draw? (b) If the lengthof the cord (containing two wires) is 3.5 m, how much power isdissipated in the wiring? (c) If no. 12 wire, with a diameterof 2.053 mm, was used instead, how much power would bedissipated in the wiring? (d) Assuming that the air conditioner is run 12 h per day, how much money per month(30 days) would be saved by using no. 12 wire? Assumethat the cost of electricity is 12 cents per kWh.
A 4.4 kVA power and 220 V 1-phase load is fed from a distribution line with a total resistance of 0.20 ohms and a reactance of 0.30 ohms. What is the absolute value of the voltage at the source according to the connected load of the line, pure resistive, that is, completely ohmic state?
4. A 3-phase, 4-wire system is used for lighting Compare the amount of copper required with that needed for a 2-wire D.C. system with the same lamp voltage. Assume the same losses and balanced load. The neutral is one-half the cross-section of one of the respective outers
1. what 15 the percentage saving in copper feeder if the line voltage in a 2-wire D.C. system is raised from 220V to 500V for the same power transmitted over the same distance and having the same power loss?
1. While carrying out OC test for a 10 kVA, 110 / 220 V, 50 Hz, single phase transformer from LV side atrated voltage, the watt meter reading is found to be 100 W. If the same test is carried out from the HVside at rated voltage, the watt meter reading will be(A) 100 W (B) 50 W (C) 200 W (D) 25 W
electrical eng'g- What is the relationship between line and phase voltages of a 4-wire STAR resistive balanced load?- What is the relationship between line and phase currents of a 4-wire STAR resistive balanced load?- Illustrate the phasor diagram of a 4-wire STAR resistive balanced load.
The two-wattmeter method gives P1 = 1200 W and P2 = -400 W for a three-phase motor running on a 240 V line. Suppose the motor load is connected across star and taking a line current of 6 A. Calculate the pf of the motor and its phase impedance.
A resistor, in series with a 138-microfarad capacitor, is connected to a 60-cycle source.If the voltage drop across the capacitor is 115 volts and the power taken by the circuitis 922 watts, calculate (a) the circuit current, (b) the ohmic value of the resistor, (c) theline voltage, (d) the circuit power factor. draw the circuit diagram
Determine mesh currents. Show step by step solution thank youu.