Answered: Q2: Draw the single line diagram of a…

Q2: Draw the single line diagram of a substation having the following equipments: (1) Incoming lines: Two, 400kV (2) Outgoing lines: (a) Two 400kV, (b) four, 132kV (C) Three, 33kV

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter15: Dryer Outlet, Lighting, And Receptacle Circuits For The Laundry, Powder Room, Rear Entry Hall,and Attic

Section: Chapter Questions

Problem 10R

See similar textbooks

Related questions

Q: Consider an experimental 2000 kV three phase bundle-conductor line with 16-sub-conductors to each…

A: (c) Given Inductance in H per meter per phase is 0.744X10-6. Capacitance in Farads per meter per…

Q: 2. Solve the following question and submit the solution before the deadline. A transmission line…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: a. What are the main components of overhead transmission lines (OHTL)? b. List commonly used…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A 500-kV, 60-Hz, 3-phase completely transposed overhead line has the resistance R = 0.0201/km, D =…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: Choose the correct Answer: ETC Department of UTAS-NIZWA wants to install the cable in the computer…

A: There are three fiber optical cables are given as we know fiber optical cable has high bandwidth.…

Q: The impedance seen from the relay side in a distance relay is 10 ohms. Given that the CT ratio is…

A: Given: CT ratio is 1000 : 1 PT ratio is 100,000 : 110 Line has a resistance of 1 milliohm per km and…

Q: Find out the Sending end Voltage (Line) (Vs) for the given readings

Q: If the branch is added between old bus to the reference bus then the size of Zbus,new increased by…

A: Choose the correct option The given Statment If the branch is added between old bus to the reference…

Q: If a new line is added between buses 2 and 3 in a system, then the elements of the Ypus affected by…

A: When a new line is added between 2 and 3,the fallowing are the elements that are effected in a y bus…

Q: Give the raceway size required for each of the following conductor combinations: 1. Three, 1/0 AWG…

A: Given information, Three, 1/0 AWG and 1 AWG with THW type insulation is to be carried by EMT…

Q: A three phase overhead transmission line is designed to deliver 190.5mva at 220kv over a distance…

A: The diameter of the conductor and its size

Q: 1. Draw the equivalent circuit of any transmission line, indicating all voltages, currents, and…

Q: Voltage regulation of a short transmission line is found to be zero, If resistance and reactance of…

A: Voltage regulation of a short transmission line is zero. Vs = Vr

Q: 1-DO you need a repeater station if we used optical cable under the sea level? And why?

A: If we used optical cable under sea level then there is a chance that it lose or reduce its signal.…

Q: What are the maximum and the minimum value of VSWR of transmission line?

A: VSWR stands for Voltage Standing Wave Ratio. It is a function of reflection coefficient and it can…

Q: Determine the current in the neutral conductor and the current in each line conductor (i.e., IR, IB…

A: A 3-Φ, four-wire system is shown below: The phase voltage and the line voltage in a star…

Q: Bus bar system which ensures continuity of supply during breakdown is... single bus bar single bus…

A: large stations, it is important that breakdowns and mainte-nance should interfere as little as…

Q: - The figure below shows the structure of which busbar? If CBF has occurred, please explain how many…

Q: write and explain the main component used in overhead transmission lines.

A: Overhead transmission lines are used to feed the bulk amount of electricity energy from generating…

Q: Subject: Electrical & Electronics Engineering Course: Power Systems Question: In case of modeling…

A: Modeling a Long Transmission Line, procedures :- Physical ACSR conductor is replaced with…

Q: What overhead conductor size should be used to supply a load of 40,000KVA at 95% pf and receiving…

A: Given Overhead conductor P=40, 000 KVA pf =0.95 Vr =69 kV permissible voltage drop = 5% length =8…

Q: (a) Describe how TLBs are used to increase paging efficiency.

A: TLB contain entries page table have been most recently used. The processor examines , the frame…

Q: Give the reason of acharging current is exiting in a line even when line is open circuited at the…

A: In a transmission line, air acts as a dielectric medium between the conductors. When the voltage is…

Q: Derive the expression for the receiving end power in the voltage control method.

Q: a List the factors affecting the sag of a transmission line. (write any three factors)

Q: 8. How do the terms ‘impedance drop’, ‘voltage drop’ and ‘voltage regulation’, in connection of…

A: Impedance drop: Impedance drop is the product of the current and the internal impedance. The…

Q: (i) Explain the major components of a high voltage transmission lines with suitable diagram. Label…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: A Double Circuit Transmission System will always only have six cables or conductors suspended on the…

Q: For underground and underwater transmission, why are line losses for HVDC cables lower than those of…

A: As per Bartleby guidelines we are allowed to solve only one question, since these parts are…

Q: A 400 kV, 3-6, 200 km length loss less transmission

Q: 3. What are the causes of voltage drop and line losses in a transmission line?

A: Line voltage drop occurs due to Voltage drop in line resistance Voltage drop in line inductive…

Q: A duplicate bus bar system is used to ensure continuity of supply. Select one: True False

A: In this answer we will find out what a bus bar is and the use of a duplicate bus bar as explained…

Q: Transmission lines can be categorized on the basis of their length. Explain short transmission line…

A: Trans mission lines can be cateogerized into 3 types on the basis of their lengths 1. Short lines…

Q: If a new line is added between buses 1 and 4 in a system, then the elements of the Ybus affected…

A: The fallowing are the elements that are effected by the adding of an element between 1 and 4 buses:

Q: 6. Which type of transmission technique is employed by paging system?

A: The solution is provided in the following section.

Q: If the Transmission Line System is in Double Circuit Configuration, with three conductors in a…

A: In double circuit configuration each tower has six wires two for each phase. One wire acts as…

Q: Draw clearly, neatly, and properly the Circuit Schematic Diagram for a SINGLE BUSBAR SYSTEM with BUS…

A: Draw clearly, neatly, and properly the Circuit Schematic Diagram for a SINGLE BUSBAR SYSTEM with BUS…

Q: Which type of lines is implemented when authorities prohibit the use of Overhead Lines for general…

Q: D/Y11 (C) One, 2MVA, 33KV/ 420V,Y/Y (4) Bus-bars: 400KV Duplicate bus-bar, 132 kV-Duplicate bus-bar,…

A: Please find your answer below in step 2

Q: What is the box fill volume allowance for each conductor originating outside and terminating inside…

A: We need to answer what is the box fill volume allowance for each conductor originating outside and…

Q: 6- Discuss the cases "matched and mismatched" in transmission line? 1 Add file

Q: Estimate and costing for installing 11KV transmission line

A: 11kV Transmission Line:- The local transformers, which distribute power to the nearby buildings, are…

Q: The generating set lines L1 and L2 are connected to bus-bar A. L2 is supplied from a powerful system…

A: In the given, information given, that there are two generating lines L1 and L2. L2 is supplied from…

Q: Which of the following criteria is correct for the electrical design of the overhead line? O Tensile…

A: Need to find the criteria for Electrical design of overhead line

Q: In the Duplicate Busbar System, all the incoming and outgoing lines can be connected to the Main and…

A: In the duplicate busbar system, all incoming and outgoing lines can be connected to the main and…

Q: A transmission line has a span of 150m between level supports of 10 meter height. The ground…

A: Consider the diagram shown in Figure below

Q: Prove that the conductor cost for transmission line is inversely proportional to the square of the…

A: Power suppied by source is cosntant VIcosϕ = constsant I∝1vlosses are also constant (I2R = constant…

Q: A transmission line has a span of 150m between level supports of 18 meter height. The ground…

Q: o (i) Describe the main purpose of insulators in overhead transmission lines. (ii) Explain the…

A: The explanation is as follows.

Concept explainers

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.

Question

Please I need the answer in 30 minutes

Q2: Draw the single line diagram of a substation having the following equipments:
(1) Incoming lines: Two, 400kV
(2) Outgoing lines: (a) Two 400kV, (b) four, 132kV (C) Three, 33kV

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An overhead transmission line has a span of 250 m and the weight of the line conductor is 0.68 kg per metre. Also the maximum allowable tension in the line is 1510 kg. Calculate the maximum sag and calculate the height above ground at which the conductor should be supported. Assume ground clearance required is 10 metre.
How does rise in voltage at the receiving end of an open circuited line depend upon the length of the line and system operating voltage? Subject Power Transmission and Distribution
The Voltage Regulation of a Transmission Line should be _____? A. very high percentage. B. more than 100%. C. zero or nil D. as low as possible.
5. Identify the minimum distance requirements between network cables and power sources and identify types and location for cable supports.
State the types of transmission lines.
Please answer the question full sentence 5. Identify the minimum distance requirements between network cables and power sources and identify types and location for cable supports.
5. Identify the minimum distance requirements between network cables and power sources and identify types and location for cable supports. Note: Please do not handwritten.
Give the reason of acharging current is exiting in a line even when line is open circuited at the load end
(Engineering Utilities) Identify and describe the types of transmission media used in a telecommunications network.
Identify and describe the step-by-step process used to install cable in the NCT Colledge buildings? Note: Please do not handwriting
"A 75-ohm load terminates a 50-ohm transmission line. The point of reflection is at the load. If the measured incident voltage at the point of reflection is 10 Vrms, what is the total voltage at the load? Enter only the numerical value. No need for the unit. Use four decimal places (if the answer is not an integer)."
5. Identify and describe the step-by-step process used to install cable in the NCT Colledge buildings? Note: Please do not handwritten.