Q2) Write an assembly language program to monitor the physical digitized quantity come from port 8080h and if it is greater than 40h the processer sets the valve connected to the port A00Ah on bit 2 and otherwise resets it.

Q: Q2) Write an assembly language program to monitor the physical digitized quantity come from port…

A: Introduction to assembly language program It is defined as a low-level programming language for a…

Q: Q2) Write an assembly language program to monitor the physical digitized quantity come from port…

A: This question is related to the assembly language programming of 8085 microprocessor In this…

Q: 2. Assume that the STM32L475 is running with a 4 MHz clock, write a sequence of C statements to…

A: Answer is given below:

Q: 2. Assume that the STM32L475 is running with a 4 MHz clock, write a sequence of C statements to…

A: The handwritten answer is available :

Q: 2. Assume that the STM32L475 is running with a 4 MHz clock, write a sequence of C statements to…

A:

Q: Q3) Write an assembly language program to monitor the physical digitized quantity come from port 08h…

A: It is defined as a low-level programming language for a computer or other programmable device…

Q: B- Represent the following control statement by two register transfer function: At time T2 if P or Z…

A: REGISTER TRANSFER FUNCTION : tells about micro-operations transfer among registers.   Required :…

Q: 5. Give the instructions to achieve the following expressions If (Ss30)) { $s2--;}

A:

Q: 5. Give the instructions to achieve the following expressions If (Ss30)) { $s2--;}

A:

Q: 2) Perform the following function in a simple program steps a) DX = (07H) b) Invert bits b1, b4 and…

A: a) DX = (07H)^2 MOV DX, #07H    MUL DX, 07H

Q: 4. Rewrite the following code and add NOP instructions to resolve the hazards. 1. w $t0, 0($s5) 2.…

A: Rewrite the following code and add NOP instructions to Resolve  the hazards..

Q: Problem 5 Write the entire VHDL code for a 64-bit synchronous counter that has a synchronous reset…

A: Write the entire VHDL code for a 64-bit synchronous counter that has a synchronous reset and an…

Q: 4. It is desired to configure a PWM Output Pin on an ATmega328P. Write the AVR Assembly code that…

A: ATmega328p It is a 8 bit microcontroller based on AVR RISC architecture. Since, advanced RISC…

Q: Question 2: The program needs 323 µsn delay. Plan this delay program and write using assembly.…

A: Code :   Instructions T-states for execution   Move BX, Count 4 L1: DEC BX 2   NOP 3…

Q: Q4) Write assembly program to generate a square wave of 2 kHz with 25% duty cycle on pin RD4 using…

A: Assembly program is given below:-

Q: 8086 circuit, assume that the connection of ports A and B is as follows. An information parallel to…

A: The 7 segment LED display is very common. It can display the digits from 0 to 9 along with a few…

Q: Open Atmel Studio and write an assembly program for the AVR to transfer the letters 'a', ‘b’, and…

A: AVR instructions LDI This instruction load an immediate , 8 bit value to register R16 - R31 Syntax-…

Q: 2) Write a C routine using INTO and Timer0 interrupts to measure time to 100ns. Using this routin…

A: It is defined as a general and nearly synonymous terms for any sequence of code that is intended to…

Q: Q3:(A) To perform the operation R3 R: +R: +1 what are the selector that must be choose by control…

A: Answer : A). The central processing unit (CPU) is the part of the computer that performs major of…

Q: 2) A) write an Assembly language program to i) To load the Port A register with 0XAA ii) and…

A:

Q: QS/ Write ALP to control four traffic lights of four streets intersection by 8255 chip when the red…

A: here we write 8086 subroutine for traffic  control: figure 1:

Q: 12.25 The following binary counter increments on cach rising clock edge unless the exter- nal clear…

A: Using 4 bit counter we can implement a modulo 12 synchronous counter by ensuring that all the flip…

Q: 12.25 The following binary counter increments on cach rising clock edge unless the exter- nal clear…

A: Using 4 bit counter we can implement a modulo 12 synchronous counter by ensuring that all the flip…

Q: The content of 12H Register after executing the following code is : MOVLW 3H MOVWF 12H DECF 12H, F…

A: DECF File Reg. Address,D ->it tells the cpu to decrement the content of fileReg and places the…

Q: he following sequence of 16-bit control words are presented to the datapath. For each, identify the…

A: This falls under Computer Architecture. The following sequence of 16-bit control words are presented…

Q: (6) Running a certain function through timeit on input sizes of 10, 100, 100 produced the following…

A: Time complexity of the given function

Q: Atmel Studio and write an assembly program for the AVR to transfer the letters 'a', ‘b’, and ‘c’…

A: It is defined as a low-level programming language for a computer or other programmable device…

Q: plz tell me the verilong hdl code...   Display the output value of the 4-bit up counter on a…

A: The solution for the above given question is given below:

Q: -2) a) type a double-loop delay subroutine part. b) in this double-loop delay subroutine, calculate…

A: Q-2) a) type a double-loop delay subroutine part. b) in this double-loop delay subroutine, calculate…

Q: 11. Show the steps involved in the following MOV BX,91CFH :BX = 91CFH MOV CL,3 SHR BX,CL shift right…

A: BX = 91CFH  ;BX=91CFH CL  = 3  ; three time looping SHR  BX,CL  ;value of BX is shifted right 3…

Q: Read 2 numbers a and b from serial monitor and write function that will compare them and return -1…

A: Given, Read 2 number a and b compare ab print result

Q: is desired Problem: Assume that memory location BINARY contains a 32-bit pattern. to display these…

A: First, the hexadecimal digits are converted to ASCII characters by using a table lookup into a…

Q: QS/ Write ALP to control four traffic lights of four streets intersection by 8255 chip where the red…

A: Given:

Q: Q5/ Write ALP to control four traffic lights of four streets intersection by 8255 chip where the red…

A: Write ALP to control four traffic lights of four streets intersection by 8255 chip where the red…

Q: Q5/ Write ALP to control four traffic lights of four streets intersection by 8255 chip where the red…

A:

Q: Q5/ Write ALP to control four traffic lights of four streets intersection by 8255 chip where the red…

A: Intel 8255 is a fringe interface (PPI) chip which is programmable. It is utilized for the…

Q: Q5/ Write ALP to control four traffic lights of four streets intersection by 8255 chip where the red…

A:

Q: What will be the content of AL after the following instructions execute DATA DD 049AH, 10СВН, 1300H,…

A: The 8086 microprocessor supports 8 types of instructions − Data Transfer Instructions Arithmetic…

Q: Write a C function Init that configures the pins of a LPC1769 MCU as following: Port0 - pins O and 7…

A: Here, we have to write a C function for the above question.

Q: List of interrupts is attached. Display the output of INT 15h and INT 16h with the combination of…

A: INT 15h / AH = 86h - BIOS wait function. input: CX:DX = interval in microseconds Note: .5 million in…

Q: I need to write code in MIPS that will swap the two word data labeled as x and y that is stored in…

A: I have written the main function two swap two data words without the temp variable.…

Q: 2) Perform the following function in a simple program steps 3080 a) DX = 70 b) Invert the last 4…

A: below are the code to implement the given problem

Q: Q.3 a) Four EPROMS are connected together, each one has 11 address input and 8 data outpu. What is…

A: a) Memory of EPROM = 2^(input) * output     Here we have 4 inputs , hence Memory = 4* 2^inputs  *…

Q: 8051 microcontroller C program to toggle only pin P1.3 continuously every 250 ms. Use timer 0, mode…

A: 8051 microcontroller has two independent timer which can be used as timer(to generate…

Q: 2) Perform the following function in a simple program steps DX a) DX = BL b) Set the first 6 bits of…

A: Given: DX=DX/BL Set the first 6 bits of CX Register

Q: 3. Find out the MIPS instructions for the following code: A = B - X[4]; If(A >= C){ C - 800; D =…

A: SUMMARY: - hence, we got the desired output.

Q: PROBLEM STATEMENT Write a program to generate a continuous square wave with the period of 500 µs.…

A: The alternate pattern of 0/1 bits can be provided by loading the accumulator with AAH(10101010) and…

Q: What will be the content of AL after the following instructions execute? a) DATA DD 049AH, 10CBH,…

A: DATA DD 049AH, 10CBH, 1300H, E11FH MOV BX,OFFSET DATA      #BX=049Ah MOV AL, 10…

Q: Q2-Write tiny model assembly program to generate the following periodic signal as in the figure…

A: Given:

Q: Use Indirect addressing to write a PIC24 assembly code that complements and adds 5 and multiply by 2…

A: Assembly code is used to directly tell the computer that what should the computer do. Assembly code…