Q2: You have an Aluminium cube with 2.00 inches side length. For the cube, calculate the following: a) volume in cm³. b) weight in Newtons. c) Mass in lbm and weight in lbf on moon, knowing that the moon gravitational acceleration is one-sixth of Earth gravitational acceleration.

Q: A certain coal is pulverized and burnt in a burner. Analysis of coal showed 70% C, 10.7% ash and…

A: c) 2272.45 m3 d) 7938.90 mgSO2 / m3

Q: the pressure of the gas in inches Hg.

A:

Q: A Zamboni in Edmonton's new ice hokey arena emits carbon monoxide at a rate of 8.38 mg/s. The arena…

A:

Q: pressure increase

A:

Q: absorption,

A:

Q: When an acid meets your skin, you should immediately wash it with what?

A: When acid meets your skin you should immediately wash it with cold water for 15 - 20 minutes. If it…

Q: Consider the compound, C₂H4O₂. (5 pts each) Using the framework below, draw two possible Lewis…

A:

Q: Q2/a- Derive the integral equation for first order reactions with varying volume batch reactor in…

A: Given that n=1volume batch reactorwe have  to find rate law for given  reaction

Q: What is the maximum number of independent balances that may be written around each subsystem?…

A:

Q: Calculate the pressure ( in atm) at which the freezing temperature of water is -20°C = 253 K H₂O(s)…

A: Given data: Enthalpy of fusion = 6010 J/mol Initial temperature = 273 K Initial pressure = 1 atm…

Q: A group of students are doing an analysis of copper in 1-peso coin. They were tasked to prepare…

A: Types of errors.... 1. Determinate error – also known as systemic error, causes the mean of a data…

Q: Calculate the % relative humidity of air-water vapor mixture having a percent humidity of 21.81 at…

A: Given: The percentage humidity of the air-water mixture is P% = 21.81 at T = 30oC and a total…

Q: Convert the following with whole solution 1. 23 m^2/s^2  to Btu/slug 2. 25 kPa to mbar to inch Hg…

A:

Q: Steam, initially at 700 lbf/in.2, 550°F undergoes a polytropic process in a piston-cylinder assembly…

A: Given thatPi  = 700 lbfin2Ti  =550  FPf  = 3600 lbfin2n =1.5

Q: 3. A 2000-liter tank initially contains 400 liters of pure water. Beginning at t = 0, an aqueous…

A:

Q: An amino acid of interest was produced in a fed-batch culture using glucose in the feed medium. The…

A: Given  VO = 500 L F = 50 L/h XO = 20 g/L µmax= 0.2 h-1 Ks = 0.5 g/L Yx/y = 0.3 g/ g

Q: The equilibrium constant for the dissociation of acetic acid at 25°C is 1.80 x 10-5. If you add…

A: Given that- At 250 C  the equilibrium constant of acetic acid (HAc) is,  Keq=1.80 x 10-5 The…

Q: Describe the science of metrology, what it encompasses, and the knowledge and training required to…

A: Introduction, Many industries, including manufacturing, engineering, science, and technology, depend…

Q: At which temperature will carbon dioxide be in the corresponding state to argon at 32 atm and 340K?…

A: Here, we have to find the temperature and pressure of Carbon dioxide such that both are in the…

Q: Given the figure below, If the barometric pressure is 1.05 bar and the gauge pressure at the bottom…

A: Given barometric pressure = 1.05 bar 1 bar = 100 KPa barometric pressure  = 105 KPa Gage pressure at…

Q: The over-application of ammonia-based fertilizers is toxic to tomato plants; however, a 2014 study…

A: Nitrogen availability is an important limiting factor for plant growth. Although NH(4)(+)…

Q: Derive the equations for G(T,P) from the two equations G=H-TS (pressure fixed) and dG=- SdT+VdP…

A: Given: G=H-TS...1)dG=-SdT+VdP...2)

Q: Consider the equilibrium reaction H2O H2 + 0.5 O2, at 1 atm and 298K. The mass fractions of H2O. H2…

A:

Q: FR&B 3.38. A 5.00-wt% aqueous sulfuric acid solution (p = 1.03 g/ml) flows through a 45-m long pipe…

A: (a) The molarity of the sulfuric acid in the solution is to be calculated.

Q: Refer to the following problem: Barium chloride reacts with sodium sulphate to precipitate barium…

A: Barium sulphate precipitate is obtained by the reaction of  barium chloride and sodium sulphate.

Q: Heat-Transfer Area and Use of Log Mean Temperature Difference. A reaction mixture having a Cpm =…

A:

Q: A differential manometer is shown below. Calculate the pressure difference between points A and B in…

A:

Q: Which of the following occurs in the reaction Cu²+ + Zn → Cu + Zn²+? Select one: O a. Neither copper…

A: The reaction of copper (Cu) and zinc (Zn) given is as follows: Cu2++Zn → Cu+Zn2+ The above reaction…

Q: 2. Determine the titer value of the following compounds: Volume of Titrant Iml Iml Iml Iml Iml 3…

A: The titer value is explained as the volume of the titrant which is required to titrate the definite…

Q: In the photosynthesis assuming an elementary reaction: a. Give the rate equation for the depletion…

A: The photosynthesis reaction assuming it is an elementary reaction is as follows: 6CO2 + 6H2O + light…

Q: One way to synthesize ethylamine (CH₂CH₂NH₂) is from the reaction of ammonia (NH3) with chloroethane…

A: Ethylamine is synthesized from the reaction of ammonia and chlorobenzene. Fraction yield of…

Q: 1718 A computer IC chip consumes 10 W of power, which is dissipated as heat. The chip measures 4 cm…

A:

Q: The average human adult has 0.18 Ibm of potassium distributed in his body. One isotope of 40…

A:

Q: A water solution contains 90.0 g of glucose, C6H12O6. It has a density of 1.10 g/cm³ and a total…

A:

Q: Calculate the mole fraction of He in a gass mxiture of N2 and He, assuming the mass percentage…

A: basis = 100 g mass of nitrogen = 60% of 100 g = 60 g mass of helium = 40% of 100 g = 40 g molar mass…

Q: A liquid mixture contains three components A (MW = 72), B (MW = 60) and C (MW = 55) in which A and B…

A: Given that, Molecular weight of A MA = 72 kg/kmol Molecular weight of B MB = 60 kg/kmol Molecular…

Q: Under constant pressure P = 1 atm an ideal gas of 1.5 mol undergoes cooling from 120°C to 30.0°C,…

A: An ideal gas is cooled in an isobaric process.

Q: percent oil lost in the process.

A:

Q: Please draw the block diagram of the problem

A: Block diagram of the problem is to be drawn.

Q: Two thousand kilograms of a 94% NaNO3 solution in water is at a temperature of 1000C. This is sent…

A:

Q: 11.7. A tubular condenser with 120 2-in. BWG 16 copper tubes & ft long condenses 22,100 lb/h of…

A: Mass flow rate is calculated from density and volumetric flow rate. Heat gained by water is…

Q: What mass flow rate of NH3 in lbm/h is required to produce 2190 lbm of NO per day? (Assume that the…

A:

Q: Determine the molar volume of n-butane at 510 K and 25 bar based on each of the following: a. the…

A: Given data: T = 510 K P = 25 bar

Q: A 4.00 x 104 M solution of aniline in H₂0 has absorbance A = 0.504 at 280 nm, when measured in a…

A: Given that- Concentration of aniline solution 1= 4.0 x 10-4 M Absorbance of aniline in H2O, A=0.504…

Q: 1. The following data refer to the adsorption of butane at 0°C onto tungsten powder (area 16.7 m²…

A:

Q: Instructions: Compute for the following problems stated below. Express your final answer into 4…

A: c. Phosphoric acid (H3PO4) Molecular weight = (3 x M. Wt of H )+ (1 x M.wt of P) +( 4 x M.wt of O )=…

Q: 3.2-4. Convection, Conduction, and Overall U. A gas at 450 K is flowing inside a 2-in. steel pipe,…

A:

Q: 3.8 moles of an ideal gas at 27.0°C expands isothermally from an initial volume of 20.0 dm³ to a…

A: Given that :n  =3.8 molT =27 C =27 + 273.15 =300.15 KV1=20 dm3V2=83.1 dm3constant external…

Q: What effect do different sugars/sweeteners and different quantities of such sweeteners on the…

A: The physical properties of an ice cream refers to it's viscosity, hardness, color, melting rate,…

Q: A treatment system treating 1.0 m3 /s of water includes a filter followed by a  chlorine contact…

A: please find answer below