Q2. Apply the Fourier transform to find V(t) in the circuit presented below. 292 ww e-2¹u(1) V (1) 1F ell 0.5H 28(1) A

Q: 8- The following pole-zero plot belong to (a)stable (b)marginally stable (c)unstable…

A: 8) Given,The pole-zero plot of the system isWe need to tell the system whether it is stable or…

Q: Q3) A 1600-kVA, 13500 V, 50-Hz, Y-connected synchronous generator has Ra=1.5 Ohm, Xs = 30 Ohm.…

A:

Q: A lossless transmission line has a characteristic impedance of Zo= 502, a load impedance of ZR =…

A:

Q: 70) Determine the collector-emitter voltage for the network as shown below. 9 30 V 10μF 360 ΚΩ www…

A: The given circuit diagram is shown below,

Q: 3- Find the z transform of the following two functions: (a) x₁(n) = -na" u(-n-1) (b) x2 (n)= (-1)"…

A: Given dataTo find outWe have to determine the  transform.

Q: 1- Find the z transform of the following sequences: (a) x₁(n) = (0.1)"-3u(n) (b) x2 (n) = (0.1)"…

A: Given discrete sequences are

Q: Fill in the blanks 1. Grounding is connecting …….. of electrical equipment to earth.  2. When a…

A: We need to fill the blank space for given statement .

Q: A 100 W, 250 V lamp is connected in series with a 100 W, 200 V lamp across 250 V supply mains.…

A:

Q: a) It is desired to draw maximum power by connecting a resistor between a an b. What should be the…

A: In this questionWe need to determine the resistance across the a and b to maximum power delivered to…

Q: 2. A transmission line is to be terminated with a resistance of 125 [2] to minimize standing waves.…

A: Step-1->

Q: A 4-pole, 50-Hz, star-connected alternator has 15 slots per pole and each slot has 10 conductors.…

A: Given dataWinding factor, Terminal , To find outWe have to determine the flux per pole and the EMF…

Q: How & Find the transfer function, Center frequency, and bandwidth in figure. what type of filter?,…

A: For the given circuit the transfer function, centre frequency, bandwidth, type of filter and the…

Q: X CLK T A B B' A' J K D C C' -'1' y Current State Input Flip-flop Excitation Inputs A в с X T J K…

A: Given sequential circuit isWe need to create state transition table along with flip-flop inputs and…

Q: 9V Μ R₁ 5 kΩ Ry 2 ΚΩ 0 ww R₁ I₁ | 3 mA 3 R₁ 8 ΚΩ Μ R₁ 8 ΚΩ 8 6V

A:

Q: Et 0.21. V0₁-0.2 |v2=0.2 Voz=0.2 Ik 24- 27 2K + 2k ли 2K 8k 2K- Yx YZ 10k миск 20k lok uy

A: The response of the circuit needs to be obtained and the same can be obtained by analysing the…

Q: Question 2 R(s) + K 114 s(s+1.4)(s+10) L(S) Y(s) Find the root-locus of our given system using the…

A: In this questionWe need to draw the root locus of the given system. P no of polesZ no of zeros.

Q: 3.38 Obtain the impedance Z(s) of the network in Figure 3.35.

A: The total impedance of the circuit needs to be calculated and the same can be calculated by…

Q: In Figure 2, the source is 1 V/sec voltage ramp, i.e. Vin(t) Vin(t) + 192 ww 1F Figure 2: RC…

A: An RC circuit with unit ramp function as voltage source.

Q: 7 disadvantages of Incandescent Lamps, Tungsten-halogen Lamps, Gaseous Discharge Lamps, and…

A:

Q: 2 Ω 4 cos 20t V +21 4.7 Ω 100 mH Μ 2 Ω + Vx | 890 mF 1Ω

A: circuit

Q: 7-A type-1 plant is changed to type-2 feedback system by the following cascade control action (a)PD…

A: Type of the system is the number of poles at origin in the open loop transfer function

Q: a) Determine whether the transfer function is strictly proper or semi-proper. b) Calculate the poles…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.If you have…

Q: Question No.84 Find the output Boolean function for the logic circuit. Ao B Di

A: Given Logic circuit:

Q: In a differential amplifier, we have: Ient(in) = 300nA and Ient(off) = 100nA. Calculate the values…

A: here

Q: Find the Nyquist rate of the following signal (2000) a 300 samples/beconds Ob 400 samples/seconds c.…

A: In this questionWe need to choose the correct option. We knowNyquist frequency ws = 2wm  Where wm…

Q: Q1) B A continuous state-space representation of a sys N-C-A y = [1 0 [x₂] Find the zero order hold…

A:

Q: 0.5 F 0.5m(t) A 10 ΔΙΩ 아날 FIGURE 3.33 For Problem 3.36.

A: Given circuit:To determine:Expression for i0(t)

Q: Q5) A system is given as a) -3, b)-33 considering the root-locus, calculate the location of the…

A:

Q: Determine mesh currents for the circuit shown. Find the voltage V6A for the current source (negative…

A:

Q: Q3.1 Use qualitative analysis to show that the circuit in Figure 3 is a band-reject filter. Q3.2…

A:

Q: 5. A 300 MVA, 20 KV, 3 Phase generator has a reactance of 20%.The generator Supplies load over a…

A: Given Data:A single-line diagram of a power system with,Base voltage Base Power To Find:Impedance…

Q: X CLK J= K= D= T y = B A D A' J B' K derive the following equations: T= с -'1' y

A: Given:A logic circuit, To find:Equations of:T, J, K, D and Y.

Q: In the circuit shown, constructed using 2k resistors and silicon diodes (VD=0.6V), find the current…

A:

Q: Provide the value for the following resistor based on the given color: 1- BROWN RED ORANGE BLUE 2-…

A: For the given resistor color code the equivalent value of resistance needs to be calculated and the…

Q: What logic function is performed by this circuit? VDD A B 나 M₁ M₂ M3 M4 F M5

A:

Q: Solve for the current and voltages across the loads in the circuit below: (show detailed junctions &…

A:

Q: A universal motor has a total resistance of 30 and a total inductance of 0.5 H. When connected to a…

A:

Q: Example 12.59. wo 3-phase, star-connected all at 0-7 tagging p.f. at a line voltage of 6-6 kV. The…

A: Load of 18MVA @0.7Pf lagging with 6.6KV line voltage.Machine 1 is operating at 10MVA @0.8 PF…

Q: 3- A state variable formulation of a system is given by the equations 0 3x]+[u, x₁(0)=0, x₂ (0) = 0…

A:

Q: Solve for f(t), if the Ordinary Differential Equation (ODE) is given as below. Use Laplace transform…

A:

Q: Q5) A system is given as Sm considering the root-locus, calculate the location of the asymptotes and…

A:

Q: 1. The best value for the reflection coefficient p in a transmission line is: a) p=2 b) p=0 c) p=3

A: Step-2->The best value for the reflection coefficient p in a transmission line is b) p=0. This…

Q: Determine the voltage (Vo) 4 ΚΩ Μ a 10 ΚΩ

A: Circuit diagram is given as,

Q: 3. D2 has a Vz of approximately 10 volts. Type in the calculated voltage for TP7 with -5 volts…

A: We need to find out the voltage at given point in the given circuit.

Q: For the circuit below, what are the output voltage and Amp-Hour measurements at the + and terminals?…

A:

Q: in the total solution the part  that says what follows the 0 but i(0)=0 ?

A:

Q: H.W:Calculate the resonant frequency of the circuit in Fig. Vm cos wt 100 mH -m 0.5 mF 20 Ω

A: circuit

Q: R1

A: A JFET voltage-divider bias circuit is given with RD=1 k Ω, RS= 800 Ω, VP=-4 V, R1=390 k Ω, R2=100k…

Q: b. Solve for the source current/s. Ra ΕΓΚΩ + EΞ 20 V R₁ • 2 ΚΩ R₁ • 3 ΚΩ Ho R₂ Μ 3 3 ΚΩ R₂ R₂ ΣΚΩ 3…

A: The given circuit can be drawn like:

Q: Given the circuit below: Iin (w) († jwL ooo Tout (w) R₁ www R₂ 1 - jwC (a) Solve for the frequency…

A: Given Data:An AC three parallel branch circuit with,Input current Output current To Find:Transfer…

Fourier Transform

In mathematics, the Fourier transformation is a mathematical transformation that rotates responsibilities by using region or time into tasks depending on the local or temporal frequency, such as the rendering of a musical track in step with existing volumes and frequencies. The term Fourier amendment refers to each illustration of the frequency range and the mathematical functionality related to the representation of the frequency domain and the function of space or time.