Answered: Q2. For the circuit shown below, sketch…

Q2. For the circuit shown below, sketch the current waveforms is and io and determine the Average and RMS for both currents. is ‚a = 50° TI 50 2 ot Vs = 300 sin 100rt T2 ot 2n

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.22P: The real power delivered by a source to two impedances, Z1=4+j5 and Z2=10 connected in parallel, is...

See similar textbooks

Related questions

Q: n shown in Figure (4); Find the rms value.

Q: Determine the complex power, power, reactive power, and apparent power absorbed by the load in…

Q: A non-sinusoidal voltage eT=15+100sin1000t+75cos2000t- 50sin3000t volt is applied to the circuit…

A: The solution is given below.

Q: FIND THE VALUES INDICATED AND SHOW THE COMPLETE SOLUTION. Phase Instantaneous Value Peak RMS Average…

Q: 5:10 4 Step2 b) The AC waveform have the positive as well as the negative value. in one half cycle…

Q: Q4 (а) Calculate the rms value of waveform in Figure Q4(a). X=1 V(t), Figure Q4(a)

A: Given: They have mentioned continuous time domain signal with having the the amplitude as X.…

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is applied to the circuit…

A: The total current supplied by the source is calculated as iT=eTzT where zT is the total impedance of…

Q: What is the value of real power supplied by the source in the figure? 60 30/0 V rms +120

Q: Calculate the RMS current through R2 in the diagram IR1 = 6.06mA peak, R2 = 2.7 kohms, total…

Q: 15. For the circuit below: • Write the mathematical expressions for the current i and the voltage v…

A: 1. we will Calculate the time constant from above figure τ = LR =120×10-33.9×1000 τ = 30.77μs As we…

Q: Q2 (a) Explain the generation of single phase alternating voltage. Illustrate with a diagram.

A: Introduction: Single phase AC (Alternating current) supply can be generated with single phase AC…

Q: cheggindia.com/#Form:Subject_test?User_Name=3709413000303192252&Number=6 If the rms values of…

A: Solution- Vrms = 120 VI = e-j30° ALet us assume a equation,Acoswt+ϕ⇒A∠0° (with peak value)…

Q: 2. The rms value of the voltage in a 60 cycle is 230 V. What is the equation of the sinusoidal wave?

A: Note: As per our company guidelines we are supposed to answer only one question. Kindly repost other…

Q: Q1. Referring to the Figure Q1, answer the following questions: VA 40 V V(@t) 20 V- Vm 10 A i(ot)…

A: Given: Rms voltage, Vrms=Vmax or Vp2 Figure:

Q: A single-phase ac voltage source has 200 V rms and a system connected consumes an active power of…

Q: Q1. Referring to the Figure Q1, answer the following questions: VI V1(wt) 40 V V(ot) 20 V Vm1 Vm 10…

Q: The waveforms below represent one full cycle of the applied voltage vs and the supply current is.…

A: We can tell phase nature of waveforms by observing their peak positions with respect to time.

Q: Calculate the rms value of a sinusoidal current of maximum value of 20 A

A: Maximum value Im = 20 A RMS value of sinusoidal current IRMS = ?

Q: At time tzo, a to the cireuit. Obtain an exprescion for the transient Current, ilt). when the…

Q: triangle waveform with following specifications in Table B1. Table B1 RMS Voltage 50mV Number of…

A: In this question , we will make triangular waveform with given data and also find secondary current…

Q: 2)With reference to the waveform given below formulate the equation for the average value of DC…

A: Given A three phase supply is connected to bridge rectifier V=180 V R=200 ohm

Q: Which of the following is true in pure inductive circuit? a) Current can be 90 forward or backward.…

Q: What is the peak voltage across R2? b) What is the RMS value of I1?

Q: (c) Calculate the ripple factor for the circuit in Figure Q1(a). A 20:1 B Vpri (rms) D 50 Hz R1 150…

Q: Find the Apparent Power (rounded to 2 significant digits) for the following circuit: VT = 120V RMS,…

A: The solution is given below

Q: a) An alternating current varying sinusoidally with a frequency of 50HZ has an RMS value of 20A.…

Q: If an electrical circuit draws 100W + J100VAR from a sinusoidal source, then what would the circuit…

Q: A voltuge double circuit has Ci(2=0dl and is supplied frome a Us loo kU at frequeney = bolz. If the…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Q3) A 3-phase half-wave controlled supplies a resistive load of 100 2 from a 380V, 50 Hz supply.…

A: A rectifier is a circuit that converts ac input voltage to dc output voltage. FIRING ANGLE: A firing…

Q: ele S. 20020°V |4 L rms - - In the circuit in the figure; • L load draws 15 kVA with lagging power…

A: Two parallel load L1 and L2 Load L1 15KVA with lagging power factor 0.6 Load L2 6KVA with leading…

Q: A sinusiodal voltage having maximum amplitude of 680 V is applied to the terminals of 65 Ohm…

A: Please refer the attached images for the complete answer..

Q: 2)With reference to the waveform given below formulate the equation for the average value of DC…

A: Given A three phase supply is connected to bridge rectifier V=180 V R=200 ohm

Q: 2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b)…

A: In this question, Voltage Vs and current I phasor are given. Find the total impedance Z? We know…

Q: find the following : a) the peak voltage Vp b) the Peak to bottom Vpp c) the Time period d)…

Q: 148 Determine the rms value of the voltage waveform shown in Figure vt) WW 4. 18 24 12

Q: circuit in the figure A) equivalent ohmic, inductive and capacitive resistances B) impedance and…

Q: Construct a graph to represent the recurring nature of partial discharge pulse sequences under…

A: In general principle, Partial Discharge happens in zones of the protection or on the outside of the…

Q: What is the value of real power supplied by the source in the figure? 60 ww 30/0° V rms -j20 42

A: Equivalent impedance can be obtained by,…

Q: Another name for the RMS value of current or voltage is ... the effective value the exact value the…

A: RMS: RMS value is the value at which the heat produced by AC waveform is same as the heat produced…

Q: Voltages de and when operating at resistive load and inc ctive rms Repeat step (3) above, at (a…

Q: Please show the complete solution. Thank you A sinusoidal current wave has an instantaneous value…

Q: Example For tha wanform qinen by (i = Im sin wt ), caleulate the rms valu e.

A: In this question we need to find a RMS value of the given sinusoidal ac current.

Q: (a) Briefly explain the need for power factor correction (PFC). **Please kindly provide 5 points…

A: (a) 5 need of power factor correction is given below. Improved Voltage : When the system has low…

Q: R1 V1 6 Vrms 1500 Hz 0° +

Q: current of 10 A rms results when a single-phase circuit is placed across a 220 V rms source. The…

A: Given that, Source voltage, Vrms = 220 V RMS current, Irms = 10 A Current lags the voltage by 60°

Q: Exercise 1: Resistances connected in Series-Parallel across a Sinusoidal AC Supply Calculate the…

A: In this question , we will find total current , total resistance , current through all resistances,…

Q: 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b)…

A: As per bartleby expert policy, only one individual question is to be answered. Kindly repost…

Q: Exercise 1: Resistances connected in Series-Parallel across a Sinusoidal AC Supply Calculate the…

Q: Solve for 20 V rms supply. Thank you.

A: Given, The circuit is Vrms=20 V

Q: Computed Rms value (V) 100. E1:A to B E2:A to C 150 E3:A to D 220 E4:A to F 220 Vac E5:A to G 330…

A: In this question, We need to calculate the voltage across the different different points. We know…

Question

100%

Q2. For the circuit shown below, sketch the current waveforms is and io and determine the
Average and RMS for both currents.
a = 50°
T1
50 2
ot
Vs = 300 sin 100rt
T2
ot

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5 Average value of currents :

VIEW

Step 6 RMS value of currents :

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 6 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Multiple Order System and Steady State Error

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The instantaneous voltage across a circuit element is v(t)=400sin(t+30)volts, and the instantaneous current entering the positive terminal of the circuit element is i(t)=100cos(t+10)A. For both the current and voltage, determine (a) the maximum value, (b) the rms value, and (C) the phasor expression, using cos(t) as the reference.
Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
The real power delivered by a source to two impedances, Z1=4+j5 and Z2=10 connected in parallel, is 1000 W. Determine (a) the real power absorbed by each of the impedances and (b) the source current.
What is the average power in ghe single phase ac circuit with the purely resistive load? It is sinusoidal steady state excitation.
Calculate the rms values of load voltage and current for the circuit shown below. Please show work
. Determine the capacitance value that, when placed in parallel with this load, would produce a unity power factor. Assume that the source is 230 V at 60 Hz. The Q shown is a positive Inductive reactive power, which would have to be “offset” by the same value of Reactive Capacitance Power.
1. Write down a formula for the three-phase power factor, assuming perfectly sinusoidal and symmetrical conditions, using line-line voltage measurements. 2. Write down a formula that relates three-phase apparent power to active and reactive power. 3. Draw a graph that depict single-phase waveforms for a purely sinusoidal 50 Hz voltage and a lagging current.
Determine the rms value of the current shown in Figure T5.1 and the average power delivered to the 50-Ω resistance.
In U.S. residences, electrical power is generally utilized at a nominal voltage of 120 V rms. What problems would become pronounced if the power distribution system and household appliances had been designed for a lower voltage (say, 12 V rms)? For a higher voltage (say, 12 kV)?
Find RMS value.
For the circuit shown in Figure P7.43, assume thatvg = 120 V rms. Finda. The total resistance seen by the voltage source.b. The primary current.c. The primary power.
derive the RMS formula for the following