Answered: Q22 111 Poor power factor results in:…

Engineering

Mechanical Engineering

Q22 111 Poor power factor results in: a) Higher energy losses b) Higher load current c) Both a & b d) Neither a or b E

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 21RQ

See similar textbooks

Related questions

Q: A ¾” – 6 external square thread is be to cut on a lathe, calculate the minor diameter of the thread.

A: we have to calculate the minor diameter of the thread

Q: Find the sum of the opposite forces

Q: 1. Which statement is not true for natural gas? a) Composed of 70 to 90% methane b) Can be found…

A: Option d is not true for natural gas. Natural gas causes pollution but lesser in comparison to other…

Q: Describe the T-s diagrams accordingly by filling it the blanks accordingly. Use the sets of words…

A: ◆ A : Carnot vapor cycle ◆ B : Carnot vapor cycle ◆ C : Ideal Rankine cycle ◆ D : Ideal Diesel…

Q: polytropic process?

Q: A) Water at 70 °C flows up a 50-ft-long conical pipe with its centerline sloping at 5° to the…

Q: 3. (17.21) A collar at point C with a mass of 1 kg is rigidly attached at a distance d = 300 mm from…

Q: How can the effects of thermal expansion be controlled so as not to significantly affect integrity…

Q: A shaft capable of transmitting 50 kW of power will spin at 100 revolutions per minute. The maximum…

A: Given Power, P = 50 kW Speed, N =10 0 rpm Length, l = 3 m Angle = 1.5 degree Find Diameter,…

Q: We are going to add a low pressure turbine (5-6) to the system we just analyzed. Before going into…

A: Given that, At P3=15 MPa and T3=400 °C,h3=2975.548 kJ/kg,At P4=2 MPa,hg=h4=2798.3884 kJ/kg,At P5=2…

Q: A) Figure (2) shows the velocity distribution for flow of water between two parallel plates.…

Q: N₂ vapor Tair The boiling temp of nitrogen at 1 atm is -196°C. If the temperature of liquid nitrogen…

A: The thermal resistance of a material is determined by dividing its thickness by its thermal…

Q: A) Figure (2) shows the velocity distribution for flow of water between two parallel plates.…

Q: Fill in the blank (word in bracket) with the appropriate word from the list of words given below.…

Q: Determine the bending stress (in Pa) at the top of the beam at point C for the beam shown below if…

Q: B) The laminar flow velocity profile in pipe for Newtonian fluid is given by: ux = 2ū [1-(2)²],…

Q: Fig shows a U-tube differential manometer connecting two pressure pipes at A and B. Pipe A contains…

A: ρ1= 1.5(1000)= 1500 kg/m3PA= 110 kN/m2= 110000 N/m2ρ2= 0.5(1000)= 500 kg/m3PB= 216 kN/m2= 216000…

Q: The diagram that shows the operation of the system is figure (AE

A: we have to determine the appropriate diagram for the process

Q: A horizontal pipe, originally smooth but due to constant use, was found to be scaling through…

Q: Is the entropy constant during the polytropic process?

Q: Calculate the mass of each sphere. Assume a = 5.1, b = 2.6, 0-33. 1 R aR Ө Titanium Answers:…

A: Given data: RCo=bR=2.6×30=78 mmRT=R=30 mmd=aR=5.1×30=153 mmθ=33° Need to determine the mass of each…

Q: A group of first year students are designing gear reduction system in the Makerspace, consisting of…

Q: For the given vectors V1 and V2, determine V1 + V2, V1 + V2, V1 - V2, V1 × V2, V1 · V2. Consider the…

A: Those physical quantities which have magnitude as well as direction and obeys triangle law of vector…

Q: Calculate the mass of each sphere. Assume a = 3.7, b = 2.1, 0-39. y 1 aR Ꮎ Copper bR -x

Q: (CO₂) It is proposed to have carbon dioxide gas pass through an uninsulated nozzle. The CO2 is to…

Q: Determine the reaction components for the rigid body in the figure. B 6 ft 10 ft 31 4 Figure 2-86 40…

A: When a simply supported beam is loaded then reactions gets developed at the supports of the beam.…

Q: ine the mouth diameter of a parabolic reflector having a beamwidth of 5°, which operates at a…

A: we have to determine the required reflector diameter for beamwidth 5 degree

Q: regenerative Rankin cycle

Q: For nos. 24-37, satisfy the conditions of the given problem below: The truss is loaded as shown in…

Q: rigid container

A: From Refrigrant 134a property tableAt 30oC and 180kPas1=1.0690 kJ/kgKv1=.13248 m3/kg Since rigid…

Q: Two uniform spheres are positioned as shown. Determine the gravitational force F which the titanium…

A: Solution - Given data – R = 55 mm =0.055 m

Q: Which of the following are true for the limitations and impracticalities of the turbine of the…

A: Limitations and Impracticalities of turbine of the Carnot vapor cycle: Quality of steam decreases…

Q: Question 2 You are holding a thin and weightless bar on your head (see figure 2.1). On the extremity…

Q: Find the moment of mass from the x-axis for y = x ln(x) - 3x and y = 1 bounded by x = 3 and x = 6.…

A: Write the given data. f(x)=xlnx-3xg(x)=1limits, x=3 to x=6ρ=0.37 kg/unit2

Q: Q1) A stat of stress is specified in Figure. By using Mohr's circle determine the normal and…

Q: Two coaxial closed coil springs make up a standard compound helical spring. When both springs are…

Q: A refrigerator has a coefficient of performance equal to 5. If the refrigerator absorbs 120 J of…

A: As given in question, Coefficient of performace of refrigerator = COP = 5 Heat absorbed by…

Q: how hydropower turbine is useful and efficient to the environment.

A: Advantages (Environmental benefits) of the hydro power plants are - 1. They are renewable sources…

Q: As shown in figure 4, a combined gas turbine power plant operates with state 5 being an air…

Q: Determine the force in members DF, FG, and Gl of the triangular Howe truss shown in figure below.…

Q: Air enters the compressor of an ideal air-standard Brayton cycle at 88 kPa, 280 K, with a volumetric…

Q: 5 kN 1m 2 m A E 2m 3 kN D B 2 m

Q: 2m A 2m D B 2m

A: Ans: 34: Option A is correct. Length Ans : 35: option B is correct. Force Ans: 36. Option D is…

Q: Which of the following are true for the limitations and impracticalities of the compressor of the…

A: Given questions are related to thermodynamics and heat engines.

Q: A high-pressure gas cylinder contains 50.0 L of toxic gas at a pressure of 1.40×10^7 N/m^2 and a…

A: Given Volume, V = 50 L = 0.05 m3 Pressure, P1 = 1.4 x 107 N/m2 Temperature, T1 =…

Q: what is the problem in designing steam system? steam system like in industry of alcohol

A: the most common problem as we design steam system is- water hammer, pressure drop, freeze up, air…

Q: Q3: Find Req. between points (A&B) in the network in fig.(3). (25 mark) 2√2 $6₁ 4.2² lon 8r Fig.3 A…

Q: Air enters the compressor of an ideal air-standard Brayton cycle at 100 kPa, 300 K, with a…

A: we have t discuss which diagram is correct.

Q: 3.) A 3 inches diameter 5-tooth cemented-carbide-tipped face milling cutter is to use for milling a…

A: (a) The feed rate in inch per minute is 15.28 in/min. (b) The cutting time omitting the over travel…

Q: 10) In the following figure, if h2-10" and h1=5", then, the angle of taper equa 10" ng O a 60° O b.…

Concept explainers

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.

Question

Q22
155
Poor power factor results in:
a) Higher energy losses
b) Higher load current
c) Both a & b
d)
Neither a or b

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A retail flower shop in Metro Manila, called Floreau, sel ls arranged flowers. The shop can make beautiful arrangem ents that consists of 12 flowers for a cost of P1,800. Thi e cost of materials of each bouquet is P2,500. and other cost is P650. The shop has a fixed cost of P6900 includin g the rents and miscellaneous. If a bouquet costs P69,00 0, how many pieces of flowers must be sold to break even?
CHOICES: a. 2.81 m/s^2 b. 0 c. 1.25 m/s^2 d. 1.95 m/s^2
The maintenance cost for a new heavy-duty diesel engine is P20,000 two years after its purchase, P40,000 at the end of the fourth year and P80,000 at the end of the eighth year. Determine the semi-annual maintenance cost if money is worth 10% compounded annually Please show the cash flow diagram.Thank you very much
A certain machinery costs P40,000.00 will last 12 years with a salvage value of P5,000.00. Money is worth 4%. If the owner decides to sell it after using it for 5 years, what should his price be so that he will not lose or gain financially in the transaction? Use the sinking fund method.
Annuity: Problem 8 A trust fund will pay you P5000 per month for life once you turn 18. You are currently 10. Interest rates are expected to be 6.0% compounded quarterly. What is the current value of your trust fund?
A runner wants to run 10.0 km. She knows that her running pace is 7.5 miles per hour. How many minutes must she run?
Deposited P110,000 for 31 days. The net interest after deducting 20% withholding tax is P 795.67. Find the rate of return annually.
A man has deposited ₱50 000 in a retirement income plan with a local bank. This bank pays 8.75 % per year, compounded annually, on such deposits. What is the maximum amount the man can withdraw at the end of each year and still have the funds last for 12 years?
At 6 % compounded quaterly , tax free for 9 yrs and 3 months. How much interest was earned at the end of the period , if the investment is P 60,000.00.
CHOICES: a. 30 deg b. 45 deg c. 67.5 deg d. 22.5 deg
Determine the principal remaining after 38 monthly payments have been made for a 5-yearloan of P40,000? Rate of interest is 8% compounded quarterly. Show the cash flow diagram and complete solution Subject : Engineering Economy
Mona Persian is considering a new investment fund with a semiannual interest rate of 2.5%. Any money she invests would have to be left in it for at least five years if she wanted to withdraw it without a penalty. (a) What is the nominal interest rate? (b) What is the annual effective interest rate? (c) If Mona deposits $10,000 in the fund now, how much should it be worth in five years?