Q3) Select the proper part number with the matching letter statement in the following table: ( following the solved example. ) Part number Matching Statement Statement 1-g Example A frame made of metal or wood or plastic, in a 1 Shrinkage cavity which the mold is formed. Slight taper given to a pattern to allow 2 Flask or molding box 3 Sprue 4 Chaplets b drawing from the sand. The top half of a horizontally parted mold A passageway through which the molten d metal enters the mold cavity. Draft e to support the cores inside the mold cavity The passage through which the molten metal flows from the pouring basin, and reaches the mold cavity Solidification shrinkage that restricts the amount of molten metal available in the last 6 Cope 7 Gate region to freeze

Q3) Select the proper part number with the matching letter statement in the following table: ( following the solved example. ) Part number Matching Statement Statement 1-g Example A frame made of metal or wood or plastic, in a 1 Shrinkage cavity which the mold is formed. Slight taper given to a pattern to allow 2 Flask or molding box 3 Sprue 4 Chaplets b drawing from the sand. The top half of a horizontally parted mold A passageway through which the molten d metal enters the mold cavity. Draft e to support the cores inside the mold cavity The passage through which the molten metal flows from the pouring basin, and reaches the mold cavity Solidification shrinkage that restricts the amount of molten metal available in the last 6 Cope 7 Gate region to freeze

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

For the casting of the part, whose perspective pictures are given below, take into account the surface of the section, the model design, if necessary, the core design, all the molding stages and finally the mold in the most suitable form for casting, and name all the mold elements by showing them on the figure (Note: The hole shown in the figure, full hole.)
A grey cast iron block of dimension 200 mm × 100 mm × 10 mm is produced by sand casting . Pattern making allowance is 10 %. What is the ratio of volume of the parttern to volume of the casting.
Q1. A mold sprue is 20 cm long, and the cross-sectional area at its base is 2.5 cm2 .The sprue feeds a horizontal runner leading into a mold cavity whose volume is 1560 cm3. Determine:(A) velocity of the molten metal at the base of the sprue(B) volume rate of flow(C) time to fill the mold.
(4) An electric motor weighs 1,800lbs & is provided with an eyebolt screwed in to the cast iron frame for lifting purpose. (a) What size of the bolt with coarse thread should be used; (b) How far should the bolt extend into the casting?
10) The Bottom part of the molding box is called _______. a. Cope b. Drag c. Mold d. Core
Answer with diagram if possible. Complete solutions
Question 3 pls. Complete solution. Thanks
Pls answer 2a and 2b with complete solution based on the choices provided. Thank you
In a green sand moulding process, uniform ramming leads to (a) less chance of gas porosity (b) uniform flow of molten into the mould cavity C)greater dimensional stability of the casting (d) less sane expansion type of casting defect
Identify the casting process in which the liquid metal is forced under pressure to fill the mold cavity. A- Sand casting process B- Cold chamber pressure die casting process C- Gravity die casting process D- Pit molding process
2. Define mould.
Stepwise solution please.