Q7) Which route is the best match for a packet entering a router with a destination address of 172.16.10.2? * a) S 172.16.0.0/16 [1/0] via 192.168.0.2 b) S 172.16.10.0/24 [1/0] via 192.168.0.9* c) S 172.16.0.0/16 is directly connected, Ethernet 0/1 d) S 172.16.0.0/16 is directly connected, Ethernet 0/0

Q7) Which route is the best match for a packet entering a router with a destination address of 172.16.10.2? * a) S 172.16.0.0/16 [1/0] via 192.168.0.2 b) S 172.16.10.0/24 [1/0] via 192.168.0.9* c) S 172.16.0.0/16 is directly connected, Ethernet 0/1 d) S 172.16.0.0/16 is directly connected, Ethernet 0/0

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

A=32, B=33, C=34, D=35 x1, y1, z1 are the interfaces for the router gateway, while x2, x3, y2, y3, z2, z3 are for the router interface Find the Routing Table R1, R2, and R3 using the following table! Destination Next Hop Interface With the Routing Table that you have specified in point a, which path will PC1B take when communicating with PC2B and PC3B In theory there is a routing table for Network Address 0.0.0.0 with a Subnet Mask of 0.0.0.0, explain the function of this routing table? Does the image network require routing at point c? Why?
22. A datagram subnet allows routers to drop packets whenever they need to. The probability of a router discarding a packet is p. Consider the case of a source host connected to the source router, which is connected to the destination router, and then to the destination host. If either of the routers discards a packet, the source host eventually times out and tries again. If both host-router and router-router lines are counted as hops, what is the mean number of a. (a) hops a packet makes per transmission? b. (b) transmissions a packet makes? (c) hops required per received packet?
22. A datagram subnet allows routers to drop packets whenever they need to. The probability of a router discarding a packet is p. Consider the case of a source host connected to the source router, which is connected to the destination router, and then to the destination host. If either of the routers discards a packet, the source host eventually times out and tries again. If both host-router and router-router lines are counted as hops, what is the mean number of a. (a) hops a packet makes per transmission? b. (b) transmissions a packet makes? c. (c) hops required per received packet?
3. (a) The Bluetooth device has a limitation of devices connecting to a network. How to increase the network size of a BT network? (b) In the illustration, the J router updates its routing. Do you know how? If another new router is added to the same network named X and delay from G, H and D is 6, 12,18 respectively. Show the routing table of X.
Implement the Hamming Code error detection and correction algorithm for a group message to be transmitted over a network. Hamming code algorithm allows the receiver to detect errors that may have been introduced due to many factors such as noise, interference, and many others. -> Assume the following: 1. The sender message length is 2 bytes. The data transmitted to the user is the 2-byte data in addition to the parity bits. 2. The receiver must be able to detect and correct 1-bit error. Report :In the report you must include an overview of the Hamming code algorithm and you need to show: 1. The detailed calculation of the minimum number of parity bits needed for a message of 2-byte length. 2. Details on how sender generates the parity bits. 3. Details on how thew receiver detects and corrects a 1-bit error. THANKS., PLEASE GIVE DETAILED DESCRIPTION.
Berkeley Computer Science example (CS-168): Picture this: there are two hosts (A and B). The two hosts are connected by 50 msec of propagation delay. The bandwidth is equal to 106 B/sec. Note that the hosts use a sliding window where (W = 4, and packet size = 1000 Bytes) with (Selective Repeat). We will ignore the size of ACK and assume that the timer value for each packet is set as (send time + RTT) and retransmission occurs immediately after a timer expires. Make sure to assume that the packets are sent in sequence starting at time 0. How long does it take to successfully receive all 4 packets (P_0, P_1, P_2, P_3). Your answer should be in milliseconds. 1. When there is no packet loss. 2. When the P_1 packet becomes lost, but there is no further packet loss
55. The problem with unicast delivery is that the : a. memory allocation is difficult b. server must establish a seperate unicast session for each client c. the routers must support unicasting d. the clients must be close to the server
P27. Host A and B are communicating over a TCP connection, and Host B has already received from A all bytes up through byte 126. Suppose Host A then sends two segments to Host B back-to-back. The first and second segments contain 80 and 40 bytes of data, respectively. In the first segment, the sequence number is 127, the source port number is 302, and the destination port number is 80. Host B sends an acknowledgment whenever it receives a segment from Host A. In the second segment sent from Host A to B, what are the sequence number, source port number, and destination port number? If the first segment arrives before the second segment, in the acknowledgment of the first arriving segment, what is the acknowledgment number, the source port number, and the destination port number? If the second segment arrives before the first segment, in the acknowledgment of the first arriving segment, what is the acknowledgment number? Suppose the two segments sent by A arrive in order at B.…
Computer Science To answer this question, you may need to write a small program. Consider the following case: current cwnd value is 1000 bytes and 1 MSS is 10 bytes (=1 TCP packet carries 10 bytes of payload). With the basic formula, after 1 RTT, the congestion window would be updated to 1010 bytes (1000 + 10). What would be the value of window if ACK clocking is used? It would be a non-integer number, so give value including only two digits after comma
Packet buffering in Go-Back-N. What are some reasons for discarding received-but- out-of-sequence packets at the receiver in GBN? Indicate one or more of the following statements that are correct. Group of answer choices a.The implementation at the receiver is simpler. b.Discarding an out of sequence packet will really force the sender to retransmit. c.If some packets are in error, then its likely that other packets are in error as well. d.The sender will resend that packet in any case.
56. The difficulty with multicasting from a practical point of view is : a. memory allocation is difficult b. server must establish a seperate unicast session for each client c. the routers must support multicasting d. none of the mentioned
A router with IP address 125.45.23.12 and Ethernet physical address 23:45:AB:4F:67:CD has received a packet for a host destination with IP address 125.11.78.10 and Ethernet phys-ical address AA:BB:A2:4F:67:CD. (I) Show the entries (a, b, c, d, e in Figure 1(a)) in the ARP request packet sent by therouter. Assume no subnetting. (II) The packet made in part (I) is encapsulated in a data link frame. Fill in the fields fand g in Figure 1(a). (III) Show the entries (h, i, j, k, l in Figure 1(b)) in the ARP reply packet sent in responseto part (I). (IV) The packet in part (III) is encapsulated in a data link frame. Fill in the fields m andn.