Que 2 ÷ write the classification of Substations.

Q: A 15kVA, 2400/240, 60 Hz transformer has a primary winding resistance of 4 ohms and a secondary…

A:

Q: Calculate: a) Current in Rx that is Ix. [Ans: I MA) | b) Power dissipated. by. Rx. and R.. [Anss…

A:

Q: Find 11 and 12

A:

Q: Q.5: a) Correct any five of the following sentences using suitable scientific phrases. 1. In series…

A: Resistor, inductor and capacitor are the part and parcel of any circuit.

Q: In an 8-bit 2's complement adder/subtractor circuit, if A=2, B=6, the operation (A- B) results in…

A:

Q: 3. Draw the output voltage waveform of the circuit with explanation: /- 1000 Hz C = 1 µF 10

A: This is positive clamper circuit. It will just shift the signal upto a certain voltage level. The…

Q: 7. The equivalent of two resistors R1 and R2 in parallel a. R1/R2 b. R1+R2 c. R1 R2/(R1+R2) d.…

A: Given, Two resistors R1 and R2 are connected in parallel.

Q: c) Draw the block diagram of delta modulation with a brief explanation of this modulation techniques

A: Delta modulation is a Differential Pulse Code modulation (DPCM) technique in which the difference…

Q: (0 "A two coils are mutually coupled with L₁ = 60μH, L₂=120/J4H, K = 0.65 calculate the maximum and…

A:

Q: An AC voltage an RMS value and average value of 200 Volts and 150 Volts respectively. What is the…

A: Given: AC voltage RMS value, Vrms=200 V AC voltage average value, Vavg=150 V

Q: FB Q.3) The input voltage to a Full-wave rectifier employing a center - tapped step-down transformer…

A:

Q: a) Draw clearly the block diagrams of the coherent and non- coherent detectors that can be used to…

A: a.  coherent detection the same network signal (used to generate a DSBSC signal) is used to receive…

Q: E6.24 Consider the system represented in state variable form x = Ax + Bu y = Cx + Du, where 0 1 0 […

A:

Q: A decoder with 4-bit input signal has outputs 4 O 16 O 1 O none of the mentioned O 20

A:

Q: The minimum number of flip- flops that can be used to construct a Mod-5 counter is none of the…

A: We need to select correct option for number of flip flops for given counter

Q: An ISI free system is to operate with 2 PSK symbols over a 120kHz channel. The minimum required bit…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: F = 2 ( 0 ₁ 1 ₂ 3 ₂ 4 ₂ 8,9,15) 2 16 to 1 Mux

A:

Q: FETs have similar properties to ___. a. Scotty diodes b. NPN transistors c. PNP transistors d.…

A: FET means Field Effect Transistor. A field-effect transistor (FET) is a type of transistor that uses…

Q: the initial content of a 3- bit ripple down counter is 000. After the first clock gger, the counter…

A:

Q: The group of bits 10110111 is serially shifted right (right- most bit first) into an 8-bit

A: Given that Serial In Parallel out initial data in register is 11110000 If Serial Data is 10110111 is…

Q: figure (2) 258 ๑๑.... BIH 42 in & vi E 118 H 000 65 The phasor current 11(t) in figure (2) is -1…

A: To find the phasor currents I1(t) and I2(t) in time domain

Q: The gray code has the property of when going from any number to the next only one bit is flip O none…

A: We need to select correct property of gray code .

Q: ohm per phase. Calculate the synchronizing power per mechanical degree displacement

A: The synchronous generator converts mechanical energy to electrical energy. It works the principle of…

Q: Determine the phasor currents I, and 12 in the circuit of Fig 13.B. 50 129

A:

Q: Which instruction is used to transfer 16-bit data from 8086Mp to an I/O device that has port no.=…

A: Answer:-option 3) OUT AX,61H and remaining options are incorrect because of below explanation.

Q: Q2) Write the Assembly language instructions required to find: Z-X/Y, where X and Y are 16- bit…

A: Memory address Mnemonics 2000 LDA 2050 2003 MOV H, A 2004 LDA 2051 2007 ADD H 2008 MOV L,…

Q: Q18/ Consider the CT signals shown in figure below. Calculate the power and then classify this…

A: In this question, we need to find whether given signal is energy signal or power signal. Also we…

Q: If a 10-bit ring counter has an initial state 1101000000, what is the state after the ?second clock…

A: We need to find out the output state of ring counter

Q: For a JFET, when Vgs is increased beyond the pinch-off voltage, the drain current. a. remains…

A: We need to select correct option for given JFET

Q: Design the fixed bias circuit from the load line given in the figure below. Ic sat. =10mA IB=60UA…

A: We need to find out the value of Rc and RB for fixed bias circuit .

Q: What is the Thevenin resistance external to the resistor R? O 15.4 Q Ο 3.4 Ω 12 Ω

A: Given here a electrical circuit and asked to find the thevenein resistance external to the resistor…

Q: E6.24 Consider the system represented in state variable form x = Ax + Bu y = Cx + Du, where 0 1 0 […

A:

Q: xplain the concept of radiation source in machine vision with different types of lighting.

A: Lighting is one of the most important aspects of the use of machine vision. Failure to properly…

Q: 5.5 V 6.0 Ω Μ M 8.5 Ω 12 V 13 Ω

A:

Q: ohm per phase. Calculate the synchronizing power per mechanical degree displacement

A: The synchronous generator converts mechanical energy into electrical energy. It works on the…

Q: BW of an analog signal is 150 Hz. The sampling rate of ADC which :converts that signal to discrete…

A:

Q: The first flip-flop of a ripple counter is clocked by none of the mentioned the Q' of the last…

A:

Q: Home Work: P1 Two resistors must be selected so that the current in one is four times the current in…

A:

Q: S 2s 1) L {t sin a t} = a) b) c) 2as (s²+a²)² (s²+a²)² (s²+a²)² 2) L(3+e6²)² = a) +56 +5-1₂26) +506…

A:

Q: 4) Consider the feedback system G(s) = K(s+1+j)(s+1-j). The root-locus is which of the s(s+2j)(s-2j)…

A:

Q: Q6: A 750 KVA, 11 KV, 4-pole, 3-phases SG has Zs=1.4+j30 ohm per phase. Calculate the synchronizing…

A:

Q: (a) Derive the logic function for the shown logic diagram. (b) Use K-Map to simplify this function…

A:

Q: A J-K flip-flop with J = 1 and K = 1 has a 20 kHz clock input. The Q output is Constantly HIGH O…

A: We know that flip flop gives the output at the edge i.e flip flops are edge triggered. They may be…

Q: Find 11 and 12

A:

Q: Q2: A) Sketch the block diagram of thermal power station, then state the main parts of the plant and…

A:

Q: =block diagram of the phase locked loop xplain the operation of this circuit?

A:

Q: Maximum dimension of antenna is 0.5m and operating frequency is 9 GHz, thus the the following…

A:

Q: 2. Mention the advantages of indirect method of FM generation?

A: 2) There are various advantages of using indirect method to generate FM signal.

Q: If i(t) = 5u(t-3), this signal in frequency (s) domain is the following: a. I(s) = 5e-3s/S b. None…

A: Given data, Signal in time domain it=5ut-3

Q: An inductive load of 1300 kw at 0.707 pr is supplied by two alternators running in parallel. One of…

A: The active power consumed by the load is P=1300 kW. The reactive power consumed by the inductive…

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.