Q2) Write the Assembly language instructions required to find: Z-X/Y, where X and Y are 16- bit numbers stored in BX and CX, respectively. Store the result at 91F00H in the data segment, and store the remainder at 55A80H in the stack segment. Assume that X and Y are: 1) Unsigned numbers 2) Signed numbers

Q2) Write the Assembly language instructions required to find: Z-X/Y, where X and Y are 16- bit numbers stored in BX and CX, respectively. Store the result at 91F00H in the data segment, and store the remainder at 55A80H in the stack segment. Assume that X and Y are: 1) Unsigned numbers 2) Signed numbers

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Similar questions

Using a ROM, implement a 1-digit binary to 7-segment display decoder. In vhdl programming language.
Draw the block diagram for a common bus system for 16 registers of 32 bits each. The bus is constructed with multiplexers.
Using the IEEE 754 floating point format, write down the bit pattern that would represent 1/4. Can you represent 1/4 exactly?
Consider two microprocessors having 8-bit and 16-bit wide external data buses, respectfully. The two processors are identical otherwise and their bus cycles are the same speed. Suppose all instructions and operands are two Bytes. By what factor do the maximum data transfer rates vary? Suppose all instructions and operands are one Byte. By what factor do the maximum data transfer rates vary? Discuss your answers.
Q3) A bit word 1010 is transmitted. Construct the even parity 7-bit hamming code for this data? If at receiver end data is received as 1000010, then check and correct the code using even parity scheme. Assume the direction of generation and checking the code from right to left?
3) How many full-adders would be required to construct a 32-bit ripple carry adder?
(200)10 + (60)10=(?)2 numbers are 8 bits, and the addition process is done by using 7 and 8 complement methods. Realize, state the state of the flags at the end of the addition process (C = ?, OF =?)
Scenario: In a biased N-bit binary number system with bias B, positive and negative numbers are represented as their value plus the bias B. For example, for 5-bit numbers with a bias of 15, the number 0 is represented as 01111, 1 as 10000, and so forth. Biased number systems are sometimes used in floating point mathematics. Consider a biased 8-bit binary number system with a bias of 12710 Question: What is the representation and value of the most positive number?
What is the largest binary number that can be expressed with 16 bits? What are the equivalent decimal and hexadecimal numbers?
Find the 64 bit machine number that represents the double precision number fl(25) a)Viewing the 64 bits, the last (rightmost) 1 occurs at which bit number? (Answer will be an integer between 1 and 64. Count from left to right, i.e. bit number one is the leftmost bit.) b)Viewing the 64 bits, the first (leftmost) 1 occurs at which bit number?
1. Assuming the full adder drives a load L=1.5, determine the critical path and its corresponding delay.2. Using this full adder to create an 8-bit ripple carry adder, what is the critical path delay of this 8-bit adder? (Assume unconnected ports are driving L=1.5 load)
3) How many full-adders would be required to construct a 32-bit ripple carry adder correctly?