Question 004: Complete the following question involving the graphs of vectors. A circuit has a voltage of 5 Vand a phase angle of 120 °. Which of the following graphs most closely matches the given informat 4324 4324

Q: A conducting bar moves along a circuit with a constant velocity. A constant magnetic field is…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Find the total current of the following circuit. R1 R2 R3 36 V 12 2 12 0 120 O 1) (36+36)amps 2) 36…

A: Given data: Three equal resistors are connected in parallel combination R1 = R2 = R3 = 12 Ω Battery…

Q: The time taken by the alternating voltage function in reaching the peak value from zero is 2.7x103…

A:

Q: Branch circuits from a normal system are permitted to be installed in the same conduit with circuit…

A: Branch circuits from a normal system is not permitted to install in the same conduit from emergency…

Q: Refer to diagram 3 In the circuit, V is a 81.7 V battery, C is a 6.71 µC capacitor, L is a 6.99 mH…

A:

Q: Figure shows a circuit with an area of ? = 0.060[m2] containing a ? = 1.0[Ω] resistor and a ? =…

A:

Q: The current in a long solenoid of radius 7 cm and 17 turns/cm is varied with time at a rate of 6…

A:

Q: An inductance of 1 henry and a resistance of 10 ohms are connected in series with an electromotive…

A: L = 1H  R = 10 Ohm  V0 = 120 Volt  Now,  by kirchoff law  V0 - Ldi/dt - i R = 0  By solving this…

Q: A horizontal conducting bar is free to slide along a pair of vertical bars, as shown below. The…

A: According to Faraday's Law, when there is a change in magnetic flux passing through a closed loop…

Q: Find the equivalent inductance seen at the terminals of the circuit 1 H 2 H Leg 5 H 3 H O 3.5 H O…

A: L5 is connected to L2 and L3 in parallel where L2 and L3 are connected in series…

Q: the num turns Table 1. Fill the blanks from the graphs. (1Tesla 1 x10* Gauss) Variable Value Number…

A: solution is given as

Q: there's a man working on a circuit in this diagram. what is criterion as result of time E=5v R R1=2…

A:

Q: The current in a long solenoid with 20 turns per centimeter of radius 3 cm is varied with time at a…

A:

Q: For the following circuit R1 = 55 2, R2 = 120 Q, R3 = 160 consumed by R1· [6] R2

A: GivenR1=55 ΩR2=120 ΩR3=160 ΩVsource =22 V

Q: The values for the components of the circuit shown in the figure are V = 15 V, C = 3.5 μF, and L =…

A:

Q: Oscilloscopes can display ___________________________.   (A) just about any electrical signal (B) AC…

A: Oscilloscopes can display ___________________________.   (A) just about any electrical signal (B) AC…

Q: Using applications of Differential Equations. If the circuit is moved to position 2, find the…

A:

Q: Figure below shows a conductor moving with a velocity v = 7.1 m/s to the left in the presence of…

A:

Q: In which of the following systems does Ampere's law apply? Consider that a constant total current I…

A: In which of the following system does ampere law apply.

Q: At what speed (in meters per second) must the sliding rod in the figure below move to produce an emf…

A:

Q: Which is the Kirchhoff Voltage equation for the left hand loop in the circuit 12 30 - 118V 30 27V 1…

A: Kirchhoff's Voltage Law says that work done around a close loop is zero by the conservative field.

Q: Which of the following correc circuit with a switch, powered by a capacitor?

A: As per guidelines only first question is solved here. Option 1 consists of circuit with switch,…

Q: Copper conductors can withstand one ampere (rms current) for ____ seconds for every 42.25 circular…

A:

Q: Determine the frequency of the given instantaneous equation e=10(1000t - 69 degrees) V O 159.1Hz O…

A:

Q: In the figure, R- 14.0 Q, C- 6.87 uF, and L-51.0 mH, and the ideal battery has emf 31.0 V. The…

A: R=14.0 Ω C=6.87 μF L=51.0 mH emf=31.0 V

Q: Calculate the total inductance at the terminals a-b, for the circuit shown in FigureQ2(b). 10 mH ll…

A:

Q: In electromagnetic induction, explain the principle why the voltmeter behave the way we observe it?

A: The voltmeter has a large resistance. So, the low current flows in the circuit because the…

Q: A conducting bar slides over two circular rails while rotating around a straight wire as shown in…

A: Faraday's law When the magnetic field is varied around a conductor, an EMF is induced across it…

Q: Determine the induced emf around a small circle of brain tissue of radius 1.2×10^−3m. The B⃗ B→…

A: Expression for induced emf -  εin=NA∆Bcosθ∆t.....(1) Given values -  Initial magnetic field=Bi =0.64…

Q: resistor R is connected between two parallel conducting rails separated by 39 cm, as shown in the…

A:

Q: Consider a solenoid with a diameter 0.04 m, length 7.6 m, 55 turns, and total resistance 0.6 Ω. The…

A:

Q: Write Maxwell's equation for harmonically varying field. Which law is related to induced emf in a…

A: Maxwell's equation for harmonically varying fields are: ∇.D→=ρv ∇×E→=-dB→dt ∇.B→=0 ∇×H→=J+dD→dt…

Q: Find the total current of the following circuit. R1 R2 R3 36 V 12 0 12 Q 12 Q O 1) (36+36) amps 2)…

A: To find the current in the circuit.

Q: When you push the South end of a magnet into a solenoid, it creates a negative voltage. If you push…

A:

Q: Q 2. In the fra, shown below. Resolve the fore l00lb into faio Components one abng AB and the other…

A:

Q: 4. Calculate the total. Itotal and Ptotal of this circuit. 900 ΚΩ 17.5 k 58.50 750 0 ww 15 KO +15V…

A:

Q: V = 3.2V I= 2.4 Elkctnc motor %3D a, (denver) = 9.796MISIS 2.1 23 dy = 1.66 m 2.06 Power Sorce time:…

A: given m = 0.1074 kg g = 9.796 m/s2 h = 1.66m time = (2.1+2.3+2.06)/3 t = 2.153 v = 3.2v i = 2.4 A

Q: Para llel Circuit R, = 452 R3 62

A: The circuit is given as  Now The resistance R1= 4 ohm,R2 = 5 ohm, and R3 = 6 ohm  The Voltage V =…

Q: (Figure 1) shows a circuit with an area of 0.070 m? containing a R = 1.0 2 resistor and a C = 230 µF…

A:

Q: which of the following systems does Ampere's law apply? Consider that a constant total current I…

A: As We know that , According to Ampere's Law, the electric current enclosed in a closed loop channel…

Q: The current in a long solenoid of radius 7 cm and 17 turns/cm is varied with time at a rate of 6…

A:

Q: Suppose you have a long, skinny conductor that is oriented with its long axis parallel to a uniform…

A:

Q: R a 4. A rectangular circuit containing a resistance R is pulled at a constant velocity v away from…

A:

Q: 5. A 500 turns solenoid develops an average induced voltage of 60 V. Over what time interval must a…

A: Answer:- (c) 0.5 s  Given  Number of turns (N) = 500  Induced voltage (E) = 60 V  Magnetic flux (d…

Q: For E = E2 = E = 1.8 V, R1 = R2 = R3 = R = R, = R = 1.1 2, %3D find the value of is. Notice that the…

A:

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.