QUESTION 1 A coil of ten turns of area 0.01 m2 and resistance 5Q is placed perpendicularly inside a magnetic field whose intensity and direction changes as given in the figure. What is the magnitude of the flux of magnetic field crossing the area of the coil at time = 6 sec? B(T) 0.1 0.3 0.5 0.8 0.9 t(s) -1 -2 O 2 Wb 0.2 Wb O 20 Wb O 0.02 Wb O none of these

QUESTION 1 A coil of ten turns of area 0.01 m2 and resistance 5Q is placed perpendicularly inside a magnetic field whose intensity and direction changes as given in the figure. What is the magnitude of the flux of magnetic field crossing the area of the coil at time = 6 sec? B(T) 0.1 0.3 0.5 0.8 0.9 t(s) -1 -2 O 2 Wb 0.2 Wb O 20 Wb O 0.02 Wb O none of these

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 42P: The rod shown in the accompanying figure is moving through a uniform magnetic field of strength...

See similar textbooks

Similar questions

Explain why the magnetic field would not be unique (that is, not have a single value) at a point in space where magnetic field lines might cross. (Consider the direction of the field at such a point.)
The right-hand rule is a way to determine the direction of the magnetic field produced by moving charges. Imagine wrapping your right hand around the path of the charges so that the positive charges (or the current) flow from the little finger side of your fist to the thumb side (Figure 8.53). Then your fingers circle the path in the same direction as the magnetic field lines. Use this rule to verify the directions of the magnetic fields shown in Figures 8.8 and 8.10. How would you use the rule to find the direction of the magnetic field lines around a moving negative charge?
Verify the units obtained for magnetic field strength B in Example 24.1 (using the equation B=Ec ) are in fact teslas (T).
A 25-cm nod moves at 5.0 m/s in a plane perpendicular to a magnetic field of strength 0.25 T. The rod, velocity vector, and magnetic field vector are mutually perpendicular, as indicated in tire accompanying figure. Calculate (a) the magnetic force on an electron in tire rod, (b) the electric field in the rod, and (c) the potential difference between the ends of the rod. (d) What is the speed of the rod if the potential difference is 1.0 V?
Explain how magnetic flux can be zero when the magnetic field is not zero.
What is the direction of the velocity of a negative charge that experiences the magnetic force shown in each of the three cases in Figure 22.51, assuming it moves perpendicular to B?
The rod shown in the accompanying figure is moving through a uniform magnetic field of strength B=0.50T with a constant velocity of magnitude v=8.0m/s . What is the potential difference between the ends of the rod? Which end of the rod is at a higher potential? B
Noting that the magnetic field lines of a bar magnet resemble the electric field lines of a pair of equal and opposite charges, do you expect the magnetic field to rapidly decrease in strength with distance from the magnet? Is this consistent with your experience with magnets?
A proton of speed v=6105m/s enters a region of uniform magnetic field of B = 0.5 T at an angle of q = 30° to the magnetic field. In the region of magnetic field proton describes a helical path with radius R and pitch p (distance between loops.) Find R and p.
What force is exerted on the water in an MHD drive utilizing a 25.0-cm-diameter tube, it 100-A current is passed across the tube that is perpendicular to a 2.00T magnetic field? (The relatively small size of this force indicates the need for very large currents and magnetic fields to make practical MHD drives.)
What is the direction of the magnetic force on a positive charge that moves as shown in each of the six cases shown in Figure 22.59?
A conducting sheet lies in a plane perpendicular to a magnetic field B that is below the sheet. If B oscillates at a high frequency and the conductor is made of a material of low resistivity, the region above the sheet is effectively shielded from B . Explain why. Will the conductor shield this region from static magnetic fields?