Question 1: A current flowing through a resistor is measured as I = 1.5 mA. If the voltage drop V across the resistor is 40.5 V, a/ Calculate the resistance R of this resistor. b/ What is its 4-band color code (with the tolerance %5)?

Q: 12. For the VII characteristic shown in Fig. A, calculate the resistance of the load. V(V)* 60 40 20…

A: The V-I characteristic shown is,

Q: Ex: a Volume charge Pv= 5nc/m³ bounded by 4 Fr 58, OTOFA, 0150152x к околтат Find the Flux density a…

A: A closed spherical surface is given 4<r<8 , 0°<theta<π , 0° <phi<2π Volume change…

Q: Determine the center frequency, maximum gain,bandwidth and type of filter (plot the response figure…

A: Determine the center frequency, maximum gain ,bandwidth and type of filter (plot the response figure…

Q: The plot below is a sketch of the magnitude response of the asymptotic Bode plot of a system G(s).…

A: We need to calculate the G(s) from the given bode plotBode plot:-

Q: Create the K-Map for the logic tables below: a. ABF 000 0 1 0 101 1 1 1

A:

Q: 1. The signal m(t) = 3 cos (2m x 700t) is used to DSB-SC modulate the carrier c(t) = 7 cos(2 x 105t)…

A:

Q: The waveforms in the following figure are applied to the J, K, and clock inputs as indicated. Draw…

A:

Q: A 170 kV 3-phase electric load draws 679 A that has a power factor of 90% lagging. What is the MVA…

A:

Q: 6V 0,2K Τ 0.004 U 251 Find the U value in the circuit. 40K U10K

A: Circuit is given,

Q: Let us observe a car with a mass of m = 8.2300 × 10² kg and driving v = 180 km. If we observe the…

A:

Q: Determine the inverse z-transform of the following: 1 2−1 2 |2|> 21/1/20 1-1/2-2 (a) X(z) =

A:

Q: R(s) + Vi(2) G₁(s) V₁(s) Vo(s) H₁(s) V3(s) V₂(s)+ V7(s) G₂(s) H₂(s) V4(s) + + Vs(s) Vg(s) G3(s)…

A: given here a block diagram and asked to find the transfer function

Q: There is a parallel plate capacitor. The gap between the two conducting plates is filled with a…

A: Given:When the gap between two conducting plates is filled with a vacuum the capacitor capacitance…

Q: 6. A simple capacitor filter fed by a full-wave rectifier develops 14.5 V dc at 8.5% ripple factor.…

A: given here a ripple factor is 8.5% and dc voltage is 14.5V and asked to find the output ripple…

Q: A Single Area consists of 3 generating units (G1/G2/G3) with the following characteristics: G1: 200…

A: In this question we have to find the new generation output for G1.

Q: Determine the voltage (Vo) 4 ΚΩ Μ a 10 ΚΩ

A: Circuit diagram is given as,

Q: Can you tell me what kind of cords use the F connector?

A: F connector: F connector is a coaxial RF connector which is mostly used for over the air. Usually…

Q: Power Flow Analysis 0.01 +0.03 3 Slack Bus V₁ = 1.05/0° 0.02 +0.04 138.6 MW 2 45.2 Mvar 256.6 MW…

A: Given Data:A single-line diagram of a three bus system having,Bus 1 as a slack bus with voltage Bus…

Q: 4. In a series RL circuit current and voltage are expressed as i(t)-545° and v(t)- 15 2 30°…

A: Current is given as  Voltage is given as, Given circuit diagram is,

Q: 2- Find the z transform of the following two functions: (a) x₁ (n) = n(0.5)n-2u(n) (b) x2(n) =…

A: We need to find the given z transform following two…

Q: A straight conducting rod carries an electric charge of6.46nC. The rod is represented by a straight…

A: Electric FieldElectric Charge generates electric field.electric charge =6.46 nC.=6.46*10^-9…

Q: A single-phase load consumes 10 kW at 0.9 power factor lagging from a distributed generation (DG)…

A: Load 1: Power of load 1 Power factor  ( lagging ).Rated voltage V = 220 V.Load 2 :Power consumed…

Q: a) Claude Shannon played an important role in the evolution of modern communications systems. i)…

A: Shannon defined the quantity of information produced by a source--for example, the quantity in a…

Q: For the motor in Fig. Q3, the rated motor torque is 14 Nm, the motor torque constant is 1.2 Nm/A,…

A: Here, we need to solve question (iii)Rated motor torque , Torque constant, Motor inductance,…

Q: One HP-746 Watts. If the above motor consumes 1200 W of true power at full load, what is its power…

A: Output power is given as 1 HP = 746 W.Power consumed by motor = 1200 W.

Q: Question continued. 4 c) In the circuit shown in Figure Q4c), the operational amplifier has an input…

A: input resistanceoutput resistance,open loop gain,

Q: Which would you expect to have the highest effective radiated power (measured at 0.5 metres)? A…

A: Here among the given option the highest effective radiated power devices need to be…

Q: For battery operated high voltage insect killer (i.e. bug zapper) used at home: (a) Summarize types…

A: A battery-operated high-voltage insect killer, also known as a bug zapper, is a portable device used…

Q: The useful full-load torque of 3-phase, 6-pole, 50-Hz induction motor is 242.84 Nm. The rotor emf is…

A: The above question is based on 3 phase induction motor power flow.The results used are mentioned in…

Q: M a R₁ R₂ R3- Figure 2.1a: KVL Series Circuit E A Vab a R₁ VE I b R₂ www R3 (Vbc Ved Figure 2.1b:…

A: The above question is based on DC circuit analysis.Power delivered/absorbed by an element of voltage…

Q: Power Flow Analysis 0.01 +0.03 Slack Bus V₁ = 1.05/0° 3 0.02 + j0.04 0.0125+j0.025 138.6 45.2 MW…

A: Given,A three-bus system having,Bus 1 (slack bus) with voltage Bus 2 (load bus) with Bus 3 (load…

Q: Determine the output Vo1. Write your answer in millivolts. 20 mV 6.8k 68kQ 10kn Vol 100kΩ Voz

A: Circuit diagram is given as,

Q: Given the block diagram of the system below: x[n] Z Ţ -1| N 2 (a) Determine the system function…

A:

Q: Solve first homwork images as two pictures shown below(s)d X Homework 2 200 5³5 + 654 +35²³ +75² +9…

A: For the given system the stability of the system needs to be analysed by using the routh Hurwitz…

Q: Show the Qoutput with relation to the input signals. Assume Q starts LOW. S R EN Q S EN- R Q

A:

Q: 1 Determine GIVEN: ombr a) the equivalent resistance and b) the current in each resister of the ff.…

A: It is given that:

Q: 2. Reduce the block diagram shown in the figure to a single transfer function, T(s) = C(s)/R(s).…

A: In this questionWe need to determine the transfer function of the given system. We are solving this…

Q: For the following discrete-time signals, determine the z-transform, ROC and if they are BIBO stable…

A:

Q: Q.2 For a BJT amplifier shown in Figure Q.2, given ß= 100, VBE = 0.7 V, VCEQ = 3.5V, Rc1=3 Rc2 and…

A:

Q: ELEN 1000: Tutorial 7 (Binary Systems) 1. Express the Boolean expression and the Truth table for the…

A:

Q: Reduce the block diagram to a single transfer function. R(s) + 50 s+1 2/3 S 2 C(s)

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: 5- Find z- transform of the following sequences: (a) x(n)=2"u(-n) (b) x(n)=()"-2 cos(n-u(n-2)

A: Given signals:To determine:Z-transform of the signals

Q: Et 0.21. V0₁-0.2 |v2=0.2 Voz=0.2 Ik 24- 27 2K + 2k ли 2K 8k 2K- Yx YZ 10k миск 20k lok uy

A: The response of the circuit needs to be obtained and the same can be obtained by analysing the…

Q: Problem 2:Find the inverse z-transform of Xz = when ROC is (ii) (iii) |Z| 3 -2<|z|<3 z+2z-3 using…

A:

Q: Use superposition to find the currentio. Additionally, determine the power consumed by the 12 Ohm…

A: Given dataAn electrical circuit contains two independent current sources of and .The independent…

Q: Calculate unilateral Laplace transform of x,₁ (+)= S(+) 1

A:

Q: QI) An inductive Ioad is controlled by an impulse commutation chopper in Fig. I and peak load…

A: To find the maximum instantaneous capacitor voltage in an impulse commutation chopper circuit, we…

Q: 15230° v -130 j5 2 j20 j10 a 150

A: given here a magnetically coupled circuit and asked to find the phasor currents.

Q: Design a transformer coupled class A amplifier with high efficiency to supply an output power of Po=…

A: Transformer coupled class A AmplifierIt is a type of electronic amplifier that uses a transformer to…

Q: 2 In a unit negative feedback system, the system transfer function is given as G(S) = 5(+1) It is…

A: given system transfer function is                                                aimed closed loop…

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.