Question 1.) Find the subsequent charge of the capacitor of an RLC circuit connected in series that has R=185 ohms, C=1/300 farad, L=22 henries, and an applied voltage of 12sin(t). Assume that there is no initial charge on the capacitor, but an initial current of 1.5 ampere at t=0 when the voltage is first applied.

Question 1.) Find the subsequent charge of the capacitor of an RLC circuit connected in series that has R=185 ohms, C=1/300 farad, L=22 henries, and an applied voltage of 12sin(t). Assume that there is no initial charge on the capacitor, but an initial current of 1.5 ampere at t=0 when the voltage is first applied.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 3CQ: The ignition circuit of an automobile is powered by a 12-V battery. How are we able generate large...

See similar textbooks

Similar questions

Check Your Understanding In considering the following schematic and the power supplied and consumed by a circuit, will a voltage source always provide power to the circuit, or can a voltage source consume power?
A short circuit in a 120-V appliance cord has a0.500- resistance. Calculate the temperature rise of the2.00 g of surrounding materials, assuming their specific heat capacity is 0.200cal/gC and that it takes 0.0500 sfor a circuit breaker to interrupt the current. Is this likely to be damaging?
The ignition circuit of an automobile is powered by a 12-V battery. How are we able generate large voltages with this power source?
Discuss possible practical applications of RL circuits.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . If AC in a circuit can be thought of as a wave, which kind is it, longitudinal or transverse?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . A simple electric circuit consists of a constant-voltage power supply and a variable resistor. What effect does reducing the resistance have on the current in the circuit and on the power output of the power supply?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Describe Ohm’s law.
A 0.50-W, 220- resistor carries the maximumcurrent possible without damaging the resistor. If the current were reduced to half the value, what would be the power consumed?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . A power supply is connected to two bare wires that are inserted into a glass of saltwater. The resistance of the water decreases as the voltage is increased. Sketch a graph of the voltage versus the current in the water showing this type of behavior.
Use Lenz’s law to explain why the initial current in the RL circuit of Figure 14.12(b) is aero.
Check Your Understanding Circuit breakers in a home are rated in amperes, normally in a range from 10 amps to 30 amps, and are used to protect the residents from harm and their appliances from damage due to large currents. A single 15-amp circuit breaker may be used to protect several outlets in the living room, whereas a single 20-amp circuit breaker may be used to protect the refrigerator in the kitchen. What can you deduce from this about current used by the various appliances?
Integrated Concepts Derive an expression for the current in a system like that in Figure 23.11, under the following conditions. The resistance between the rails is R, the rails and the moving red are identical in cross section A and have the same resistivity . The distance between the rails is l, and the rod moves at constant speed v perpendicular to the uniform field B. At time zero, the moving red is next to the resistance R.