Question 17 The water surface slope is 0.001 while the bed slope is 0.002 going downstream. Which of the following is true for steady open channel flow? O depth is increasing and velocity is increasing O depth is increasing and velocity is decreasing depth is decreasing and velocity is increasing O depth is decreasing and velocity is decreasing

Question 17 The water surface slope is 0.001 while the bed slope is 0.002 going downstream. Which of the following is true for steady open channel flow? O depth is increasing and velocity is increasing O depth is increasing and velocity is decreasing depth is decreasing and velocity is increasing O depth is decreasing and velocity is decreasing

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A trapezoidal channel with 3 meters bottom width, side slope 2H:1V, channel gradient of 0.002, and n = 0.025, carries a discharge of 200 m3 /min. Compute the normal depth and velocity. Given data Wbottom (b)= 3 meters Slope= 2:1 S= 0.002 n= 0.025 Q= 200 m3 /min= 3. 33 m3 /sec Normal depth=? Velocity=? Formula below:
Compute the critical and normal depths in a trapezoidal channel (bottom width = 20 ft, side slopes = 1.5H : 1V) for a flow of 220 ft3/sec. The bottom slope is 0.00032 and n = 0.022. Is the flow subcritical or supercritical?
The side slope of a trapezoidal open channel are 1 horizontal to 1.75 vertical. The bottom width is 2.5m and length of flow is 3m. The coefficient of roughness n=0.015 and the slope of the channel bed is 0.0004. Calculate the velocity of flow (m/s) using Manning's formula. Round answer to one decimal place.
Flow enters a long, rectangular channel at its upstream end from under a sluice gate. The channel has b = 3 ft, n = 0.013, and S0 = 0.02. The flow depth at the entrance (opening) is 0.6 ft and the discharge is 30 cfs. 1) Find the normal and critical depths and identify them on the Picture2) Classify the slope and identify the transition profile (M1, M2, S1 etc). Sketch the water surface profile by hand (qualitatively) on the Picture.
Critical depth for rectangular channels A rectangular open channel has a bottom width of 6.0 m and a Manning’s n of 0.02. a. For y? =2.0 m and Q =11 m^3/s, find the normal slope. Is the slope steep, critical, or mild? b. For Q =11 m^3/s, find the slope at which critical depth occurs. c. For y? =2.0 m and y? =2.0 m, find the channel slope and corresponding discharge.
Find the base width and water depth of a trapezoidal channel with side slopes of 1.5 horizontal to 1 vertical. Manning's constant n = 0.030. The slope of bed of the channel is 1 in 1666 and discharge (flow rate) is 2.7 m³/s.
Water Resources Engineering: You are given the following information for a triangular channel: Top width, B = 3 m Q = 7.23 m3/s n = 0.016 If the bed slope suddenly changes from 0.01 m/m to 0.0006 m/m, describe the phenomenon that occurs at this sudden change in slope. Determine the normal depths for the two slopes. Draw a sketch of this situation showing the change in slope and whatever change in depth occurs (if any).
Calculus tells us that the most efficient water depth for arectangular channel (such as Fig. ) is y/b = 1/2. Ityields the highest normal flow rate for a given area. But isthis a sharp or a flat maximum? For a flow area of 1 m2 anda clay tile channel with a slope of 0.006, plot the normalflow rate Q, in m3/s, versus y/b for the range 0.3 ≤y/b ≤ 0.7 and comment.
A trapezoidal channel with side slope of 1:1 has a bottom width of 2 m. At a critical depth is 2.24 m, what is the velocity of now?
16. The alternate depth of an open channel section is most dependent on which factor? Group of answer choices A. flow rate B. manning coefficient C. flow slope D. width 17. In a hydraulic jump, aside from depth, which of the following had undergone transition? Group of answer choices A. flow rate B. froude number C. gradeline D. slope
3. A trapezoidal channel has a bed width of 3.0 m and side slope of 1 horizontal: 1 vertical. It carries a flow of 9.0 cms (or m⅔) at a depth of 3.0 m. Find the Froude number of the flow.
A 5-m wide rectangular channel is carrying a flow of 5 m3/s. If the Manning n = 0.013 and the bottom slope, So = 0.001, determine the normal depth. Ans - 0.64 I need explanation how?