Question 2: The circuit below is a synchronous sequential circuit based on D-type flip-flops (DFFs): X clock D1 DQ D2 Q1 DQ Q2 Z (a) Write the excitation and state equations for the two DFFs. (b) Express the output equation for the output z. (c) Determine the present and next state table of the circuit. (d) By using the result obtained in (c), sketch the circuit using JK flip-flops (JKFFs).

Q: A wire carrying a current of 3.8 A is located inside a magnetic field of constant magnetic flux…

A: Current is given  I = 3.8 A Flux density is given  B=14.1 T. Angle between conductor and magnetic…

Q: Classify this signal: A color movie, according to whether they are: one dimensional or multi…

A: Given, Classify this signal:- A color movie. According to whether they are,1. one dimensional or…

Q: The below power triangle is given for a single-phase load, S-1200 j1200 VA. The voltage across the…

A: Given that,  Single phase load complex power S=1200+j1200 VA. Vrms=80v If we improved the power…

Q: 3. Given the bridge-type full-wave rectifier circuit shown 220V 60Hz 220V:Es Es D1 D2 D3 D4 The load…

A: Given data, Load resistance RL=22 Ω. Average current Iavg=300 mA.

Q: Does the non-inverting voltage amplifier exhibit a predictable and stable voltage gain?

A: Need to brief whether the non-inverting amplifier exhibits a predictable and stable voltage gain.

Q: 3+4i volts and the impedance through the element is 6-8i Ohms, determine:- (1) Current through the…

A: It is given that: V=3+4iZ=6-8i

Q: Problem 4.7: A small training ship Kings Pointer designed to travel at 10 knots needs 2000 kW,…

A: A small training ship Kings Pointer designed to travel at 10 knots needs 2000 kW, propulsion power…

Q: Convert the above drawing into a wiring diagram using the numbering method, then connect the squares…

A: According to the question, for the given ladder diagram as shown below, (1) (2)  (3)  We need to…

Q: What did the transistor have going for it over vacuum tubes?

A:

Q: The diodes in the circuit are all Silicon with forward voltage of 0.7 V. If R1 = 60 and R2 = 140,…

A:

Q: UPSs have two main kinds.

A: The given statement is written below. UPSs have two main kinds. We need to mention the types and…

Q: Problem 4: All the MOS transistors in the feedback transconductance amplifier (series-series) of the…

A: Given data Vov=0.2 V Vt=0.4 V VA=20 V To find out (a) DC voltage of the output, DC voltage at Q1 and…

Q: P.3-3 Two point charges, Q, and Q₂, are located at (0, 5, -1) and (0, -2, 6). CHAPTER 3 STATIC…

A: We need to find out relationship between charge particles for given condition .

Q: 1. What is the most probable problem, if any, in each circuit of the following figure? Assume BDC=…

A: The BJT circuit is given with the voltage at the base terminal and the collector terminal of the BJT…

Q: 3. Find V, using Norton's theorem for the network. 440°A jin ell -j3N 452 + Vz 2V₂ www www 192 20 Vo

A:

Q: Bonus Problem: If the JFET in the circuit to the right has lds = 5mA and V₂ = -2V, predict Vour as a…

A:

Q: use Second Approximation (B = 100) RB 186k 9 +1DV Calculate Ic. (Sat) ⒸVCE (cut off) (3) VB (4) VE…

A: In these questions We need to determine the all unknown parameters.  We know VBE = 0.7V VCE sat  =…

Q: A balanced three-phase load demands 150 kVA with a leading pf of 0.9, and is fed at a voltage of…

A:

Q: 3. Is the following balanced? If not, what value of R4 would cause the circuit to be balanced? What…

A:

Q: An over-current relay has a Time Multiplier Setting of 0.4 is required to work in 1.2sec, and is…

A: To determine the current setting for the overcurrent relay, we need to use the following equation:…

Q: Sketch the structure and symbol of a p-n junction diode and apply voltage so that to be reverse…

A: The pn junction diode is a basic semiconductor device which is formed by joining one  P type…

Q: Examine the discrete-time system: y (n) = x(n) I then determine which of the following properties…

A: Given Data: A discrete-time system of, yn=xn To Verify: Static or Dynamic Linear or Non-Linear TIV…

Q: 1. For figure 9-4 a. Does the above figure show an inductive, capacitive or resistive circuit? b.…

A:

Q: Question 1 a) What is the inverse Laplace transform y(t) of in your answer. Y(s): = Y(s) = 1 S-3 +…

A: In this question We need to determine the inverse Laplace transform.  We are solving this problem…

Q: a. Convert the voltage source to a current source. b. Reduce the network to a single current source,…

A:

Q: 9. 10 Hilm 3.6 V -5 + -10 Vi 2 K 500 Ω Diodes D1, D2 and D3 are identical diodes with forward…

A:

Q: Design and draw the QPSK demodulator.

A: A fundamental technique for encoding digital data in the phase of an analogue carrier is called…

Q: 1 LTI System The discrete-time Linear Time-Invariant (LTI) system represented in Figure 1 is…

A: it is asked to find y(n) for given discrete time system

Q: In the Internet of Things, which of the following is responsible for translating an electric input…

A: Solution: The component responsible for translating electrical input into a tangible result in the…

Q: s+1 The D.C. gain and steady state error for step input for G(s) = s²+8+1 are:

A: Given that, Transfer function, Gs=s+1s2+s+1

Q: Describe vector network analysis? S parameters? SS1 parameters? And how vector network analysis can…

A: According to the question, we need to describe vector network analysis? S parameters? SS1…

Q: 1.2 Magnetic Circuits The figure shows a ferromagnetic core whose mean path length is 40cm. There is…

A:

Q: Find the voltage Vc at t = 100 ms 5 mA 10 ΚΩ t = 0 10 ΚΩ Copyright ©2018 Pearson Education, All…

A: We need to find out voltage across capacitor for given circuit at given time instant .

Q: On graph paper, sketch a graph of "Voltage output (v) versus Time (s) for the output of the…

A: Generator output current I=3VIcosϕ Assuming power factor=1 ( unity) I=48.4×1063×24.2×103=1154.7A…

Q: voltage for the circuit belom 5V O 1V

A: Given data, Circuit diagram is given as,

Q: Use voltage division to find the steady-state expression for vo(t) in the circuit in if vg = 100 cos…

A: input voltage to the circuit Vg =100cos(8000t) V   - in polar form = 100 ∠0° V. Resistance R = 260 Ω…

Q: What is matching impedance? What does short circuit with matching impedance mean?

A: Solution: Impedance is a measure of the opposition that a circuit or device offers to the flow of an…

Q: If the JFET in the circuit to the right has I and V=-2V, predict Vor as a function of V<0. The…

A: Answer : given that  operational amplifier with  n-JFET…

Q: The loop shown in the figure moves away from a wire carrying a current I₁ = 10 A at a constant…

A: A loop as shown with, Total Resistors, RT=2R RT=20 ? Current I1=10 A The velocity of the…

Q: what is the ac resistance per km of the conductor on my last question at temperature and 60 Hz…

A:

Q: Design the sequential circuit based on the state transition diagram and state table shown below.

A: According to the question, for the given state diagram and state table as shown below We need to…

Q: Determine the value of R₁ such that the transistor is biased at the center of the load-line. Assume…

A: In this question We need to determine the value of resistance R1  such that transistor is biased at…

Q: 6.8 Generate magnitude and phase plots for the following voltage transfer functions. Use Fig. 6-7 as…

A:

Q: The signal V1=100 cos(500t - 30°) and the signal V2=20 sin (500t +45°) compared in phase would be…

A: Given Data: Signals of, V1=100 cos(500t - 30°) V2=20 sin (500t +45°) To Find:   Leading and…

Q: 10 Α 1 ΜΜ 3 Ω Μ 2 Ω 2 4Ω 4ix 3 6Ω

A: Given a circuit diagram with current sources. Since there are current souurces apply mesh analysis…

Q: Give an example problem of "SECOND ORDER PASSIVE BAND PASS FILTER"

A: Example for "SECOND ORDER PASSIVE BAND PASS FILTER" :- In passive filter only passive components…

Q: 1) Determine the input impedance of the circuit below

A: The required parameter can be calculated by applying Kirchhoff's current law to the input terminal…

Q: Question 3 Given R1=50, R2=11 0, R3 = 14 0, and L = 5 H, for the circuit shown in the figure shown…

A:

Q: 1. A 150 KVA, 2080/208-V, 3 PHASE, delta-wye transformer with the following: R₁=450mQ R₁=4.5mQ…

A:

Q: (1) Given that Z₁ = 30<(-40°) № and Z₂ = 50<15° , find the (a) apparent power, (b) real power :)…

A: The problem has been solved below using basic laws of circuit

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.