Question 28 In an acid-base titration, an indicator is used to purify the sample so percent yield is as close to 100 as possible determine when buffering has been accomplished visually show when chemically equivalent amounts of acid, H3O+, and base, OH", have been mixed determine when the volume of the base is equal to the volume of the acid Previous Page Next Page Page 28 of 30

Question 28 In an acid-base titration, an indicator is used to purify the sample so percent yield is as close to 100 as possible determine when buffering has been accomplished visually show when chemically equivalent amounts of acid, H3O+, and base, OH", have been mixed determine when the volume of the base is equal to the volume of the acid Previous Page Next Page Page 28 of 30

Chemistry

9th Edition

ISBN:9781133611097

Author:Steven S. Zumdahl

Publisher:Steven S. Zumdahl

Chapter15: Acid-base Equilibria

Section: Chapter Questions

Problem 9RQ: What is an acidbase indicator? Define the equivalence (stoichiometric) point and the end point of a...

See similar textbooks

Similar questions

A 10.00 mL sample of acetic acid (CH3COOH) and a few drops of phenolphthalein indicator are addedto a conical flask. From burette, 0.75 M NaOH is slowly added. When phenolphthalein indicator turns a lightpink, reading noted was 8.3 ml. Calculate the concentration of acid present in flask. Also write equation.
A bottle of acid in the lab is found. It is labelled as oxalic acid (H2C2O4). There is no concentration given and you don’t have reagents to carry out titration. What other measurement(s) can be made todetermine concentration of the acid?
Prepared buffer solution GivenAmmonia Volume = 68 mL | Ammonia Concentration = 0.17 MAmmonium Chloride Volume = 42 mL | Ammonium Chloride Concentration = 0.13 MDissociation Constant of Ammonia: 1.8x10-5What is the total vol. of buffer
This is about determinition of acid content in vinegar through titration, please answer the questions. Please answer only the items nummber 4-5. i only put other questions for guide. 1. What is the purpose of standardization? 2. What is the primary standard used (name and formula)? ANS: KHP 3. Suppose that the KHP is not completely dry. Will the reported molar concentration of the sodium hydroxide solution be higher, lower, or unaffected? Explain. 4. In preparing the buret for titration the final rinse is with the NaOH titrant rather than with distilled water. Explain. 5. The procedure suggests the addition of only 2 drops of phenolphthalein. What will be the effect to the analysis if larger amount of phenolphthalein is added?
A student prepares a weak acid solution by dissolving 0.2400 g HZ to give 100. mL solution. The titration requires 30.0 mL of 0.1025 M NaOH. Calculate the molar mass of the acid. (a) Would the molar mass be too high, too low, or unaffected if the student accidentally used 0.1400 g in the calculation? Explain. ex. too high/too low/unaffected and directly proportional/inversely proportional/ unrelated (b) Would the molar mass be too high, too low, or unaffected if the student accidentally used 20.0 mL instead of 30.0 mL? Explain. ex. too high/too low/unaffected and directly proportional/inversely proportional/ unrelated
When 20.00 ml of sulfuric acid of unknown concentration is titrated with 0.1249 M NaOH, 32.50 ml of titrant are needed to reach the end point. What is the molarity of the sulfuric acid? Please give calculator answer and sig fig anwser
It is important to achieve as light a pink color as possible during the titration so that the most accurate volume of the sodium hydroxide solution required to reach the end point can be obtained. Question 1 options: True False
The student Louise continued the analysis of acetic acid using half - neutralization technique. She titrates this acetic acid solution using 0.984 M NaOH titrant solution. When volume of NaOH reaches 14.34 mL, she stopped titration. The averaged pH value is measured to be 4.75. Determine the acid dissociation constant Ka.
Choose the equation that correctly describes the relationship between the volume during the end point (Vend) and the volume during equivalence point (Veq) of titrimetric analysis of CH₃COOH (acetic acid) using a phenolphthalein indicator? Vend ≤ Veq The information is insufficient Vend = Veq Vend ≥ Veq
QUESTION 4. A biochemist wants to use X-ray diffraction to determine the structure of a protein. The biochemist must isolate crystals of the protein from solutions buffered to pH 5.20. Acetic acid/acetate ion would be a good choice for the buffer. What would the ratio of [acid]/[conjugate base] need to be in this buffer?
Pls help me answer the following: The 2 options for each are buret or erylenmeyer Match the following reagents to their location in the titration apparatus.... Analyte ["",""] Titrant ["", ""] Indicator ["", ""] Solution of known concentration ["", ""] Solution of unknown concentration ["", ""]
What is an acidbase indicator? Define the equivalence (stoichiometric) point and the end point of a titration. Why should you choose an indicator so that the two points coincide? Do the pH values of the two points have to be within 0.01 pH unit of each other? Explain.