#3. A torsion prescription balance has a sensitivity requirement of 4 mg. Explain how you would weigh 5 mg of hydromorphone hydrochloride with an error not greater than 5%. Use lactose as the diluent. #4. An electronic balance has a sensitivity requirement of 3.2 mg. Using lactose as a diluent, explain how you would weigh 8 mg of digoxin with an error not greater than 5%.

#3. A torsion prescription balance has a sensitivity requirement of 4 mg. Explain how you would weigh 5 mg of hydromorphone hydrochloride with an error not greater than 5%. Use lactose as the diluent. #4. An electronic balance has a sensitivity requirement of 3.2 mg. Using lactose as a diluent, explain how you would weigh 8 mg of digoxin with an error not greater than 5%.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter7: Statistical Data Treatment And Evaluation

Section: Chapter Questions

Problem 7.4QAP

See similar textbooks

Similar questions

3. A torsion prescription balance has a sensitivity requirement of 4 mg. Explain how you would weigh 5 mg of hydromorphone hydrochloride with an error not greater than 5%. Use lactose as the diluent
A balance has a sensitivty requirement of 4.0 mg. Explain how you would weigh 15 mg of a substance with an accuracy of ± 5% using lactose as the diluent.
I need help with calculating the standard deviations and percent error- (experimental-theoretical/theoretical)*100.The theoretical values for the unknowns are water- 1.00g/mL, ethyl alcohol- 0.79g/mL and glycerol - 1.26g/mL. The down arrows mean the number is the same for that column
1. Calculate the experimental density of a salt solution and the percent error (same as relative error percent) using some or all the data given below. solubility of NaCl salt in water: 0.357 g/mLmass of empty graduated cylinder: 25.19g mass of graduated cylinder + salt solution: 30.47g total volume of salt solution: 4.98 mLtrue density of salt solution: 1.07 g/mL
a. If 55mg of CaC2O4 is placed in a 250mL pack of H2O nanopure at 25 celcius, how much (in mg) of CaC2O4 remains undesolved? b. If 100mg of CaC2O4 is placed in a 500mL pack of HCl at 25 celcius, how much (in mg) of CaC2O4 remains undesolved? FM: 128g/mol Pksp= 7.90
A prescription balance has a sensitivity requirement of 0.006 g. Explain how you would weigh 0.012 g of a drug with an error not greater than 5%, using lactose as the diluent.
7. A procedure for measuring the amount of creatinine in blood was applied to a standard blood sample and the following results were produced: 0.787, 0.812, 0.796, 0.739, 0.802, and 0.823 mg/dL. a) Can any of the data points be rejected by the Grubbs test? b) What is the 95% confidence interval for the data?
In a gravimetric chloride analysis, it was found that 0.82g AgCl and 0.80g AgCl was obtained from an unknown that had a mass of 0.3g a. What is the mass of CL in the original sample for each b. Percentage chloride in original sample for each c. Average percent chloride d. Standard deviation e. Relative standard deviation expressed as a percent
Seoyeon needs to prepare a 250 mL solution of 0.1000 M Na2CO3. Which glassware should she use to prepare the solution? 250-mL volumetric flask 250-mL graduated cylinder 250-mL Erlenmeyer flask 250-mL beaker For the given data set: [6.7, 7.3, 7.5, 7.2, 7.9, and 7.1] Determine the outlier using Grubbs test. Gcrit = 1.887 6.7 7.9 7.3 7.1 There is no outlier. The results of an analysis for a certain sample are given (in ppm): 20.1, 24.1, 23.5, 22.2, and 21.6. Calculate the 95% confidence interval. 20.3 ppm ≤ x̄ ≤ 24.3 ppm 20.5 ppm ≤ x̄ ≤ 24.1 ppm 20.8 ppm ≤ x̄ ≤ 24.8 ppm 21.0 ppm ≤ x̄ ≤ 24.6 ppm
I am supposed to calculate Average absolute deviation (%). I am not sure if 7.16 is the final answer, or do i need to multiply by 100 because they are asking for percent?
Student A determines the percent acetic acid in their sample to be 4.31% and they report a standard deviation of 0.57. Student B also reports a value of 4.31 % acetic acid, with a standard deviation of 1.2. Which student (A or B) has the more reliable determination? Briefly, 1 - 2 sentences,
A student dissolves a Jefferson nickel to make 100.00 mL of solution in a volumetric flask. The student takes a 5.00 mL5.00 mL aliquot of the first solution and dilutes it to make 100.00 mL100.00 mL of a second solution. The student places a sample of the second solution in a cuvette for analysis using spectrophotometry. The molarity of the copper solution in the cuvette was determined by spectrophotometric analysis to be 2.90×10−2 M Cu.2.90×10−2 M Cu. Calculate the mass of copper in the Jefferson nickel used to make the first solution.