Question 4 (a) Refer to the transformer shown below and answer the following questions (i) Calculate is the primary voltage applied to the transformer illustrated below?  (ii) Calculate the number of turns in the primary if there were 200 turns in the secondary

Q: Earth is about 12,000 km in diameter. It is therefore how many orders of magnitude wider than you…

A:

Q: An electron was ejected from the surface of cesium metal with a speed of 6.74*10^5 m/s.Given that…

A: Given data :-  speed of ejected electron v =6.74 × 105  ms threshold energy (work function of the…

Q: A stone is thrown upward with an initial velocity just to reach a point 78.4 m above the ground.…

A:

Q: A jet plane has a takeoff speed of Vto = 73 m/s and can move along the runway at an average…

A:

Q: 1. If the following sign weighs 125 lbs., find the tension in the supporting cable and the…

A:

Q: the weight of the body is 9.892 N when the acceleration of gravity is 9.70 m/s^2, what is the weight…

A:

Q: Determine the ff: 1. KCL 2. KVL 1 3. KVL 2

A:

Q: A projectile is shot straight up with a velocity of 58.8 m/s.  (Neglect air friction). 1.Calculate…

A: Given data:  A projectile shot straight up Initial velocity (u) = 58.8 m/s, upward Air resistance is…

Q: This question is a short free-response question. Show your work for each part of the question. Robot…

A:

Q: Using air pressure, the 1.1-kg ball forced to move through the tube lying in the horizontal plane…

A:

Q: A small metal bar, whose initial temperature was 10° C, is dropped into a large container of boiling…

A:

Q: Air with a flow rate of 20 m³/s enters a compressor at 100 kPa and 20°C and is compressed to 400…

A: Given Data: The mass flow rate of air m˙=20  m3s The inlet temperature of the air T1=20° C Inlet…

Q: Under the Equipartition Principle, in the high temperature limit, molecular heat capacity should be…

A: From the equipartition principle, it is known that: The average energy of each degree of freedom…

Q: Suppose a tank contains 636 m³ of neon (Ne) at an absolute pressure of 1.01x105 Pa. The temperature…

A: Given value--- volume = 636 m3. pressure = 1.01 × 105 Pa. The temperature is changed from 293.2 to…

Q: What is the electric force from the rod on the point charge Q? Suppose that Q=16.9 nC and L= 4.27…

A:

Q: At what time is the particle traveling most slowly?

A: Velocity is a vector quantity. It has both magnitude and direction. The SI unit of velocity is m/s.…

Q: You are in a helicopter towing a 129-kg laser detector that is mapping out the thickness of the…

A:

Q: Graph. In a position vs. time graph, what quantity of an object describes the slope of a line…

A: 1) average velocity :  V = ∆x∆t  V = ∆x∆t= x2-x1t2-t1

Q: A certain freely falling object, released from rest, requires 1.95 s to travel the last 29.0 m…

A:

Q: A rifle is fired from the top of a 90 m tall building.  The initial velocity of the bullet is 350…

A:

Q: A car starts from rest and travels for 10.0 s with a uniform acceleration of +1.9 m/s². The driver…

A: For straight-line motions with constant acceleration, we use Newton's equations of motion. The…

Q: A subway train starts from rest at a station and accelerates at a rate of 1.60 m/s2 for 14.0 s. It…

A: We have a train that starts from rest (initial velocity u=0) and accelerates at a rate a1=1.6 m/s2…

Q: Scalar quantities are not complete without .specifying their directions True O False O

A: The scalar quantities are those physical quantities which have only magnitude  . They do not need…

Q: Which of the following statements about the given vectors is FALSE? Please refer to the picture for…

A: According to question we need to choose false statement for given vectors .

Q: A spacecraft is on a journey to the moon. At what point, as measured from the center of the earth,…

A:

Q: sky diver is jumping off a plane, his velocity can be described as v = 20(1-e-3t). v=0 and y=0 at…

A: Given:-  A skydiver  has velocity v = 20(1-e-3t).  v=0 and y=0 at t=0. Find:- the distance he falls…

Q: The mass and velocity of three objects are shown below. The arrow represents the direction of the…

A: Momentum of A = mass of A × speed of A. Momentum of A= 1kg × 9 m/s. Momentum of A = 9 kg-m/s.…

Q: A ball is thrown directly downward with an initial speed of 8.60 m/s, from a height of 30.1 m. After…

A:

Q: What is the X-ray charge? Positive, negative, without charge, negative and

A: Concept: The X ray are electromagnetic radiation. Electromagnetic radiation is the photon. And the…

Q: a uniform thin thread 11.11 m in length carries the total charge of 2 microcoulomb uniformly…

A:

Q: The springs of a pickup truck act like a single spring with a force constant of k = 1.05 × 105 N/m.…

A:

Q: What is the atomic number for an element whose mass number is 92, which contains 52 neutrons per…

A:

Q: A battery will be used to power the room for 8 hours a day. A battery cell is rated at 6V, 2AH with…

A: Given:- A battery call is rated at 6V, 2Ah The maximum depth of discharge  is 80 % A battery will…

Q: An airplane pilot wishes to fly due west. A wind of 72.0 km/hkm/h is blowing toward the south.   If…

A: The wind speed Vw=72 km/h The speed of a plane with respect to air VP/A=305 km/h

Q: 34. On a freeway entrance ramp, you accelerate your 1200-kg car from 5 m/s to 20 m/s over 500 m.…

A:

Q: d Ꮎ\

A:

Q: We will use homework problems of this type regularly in this assignment. I have shown you an…

A:

Q: A ball dropped from the top of a tall building, and one second later a second object is dropped.…

A:

Q: Find the work done in moving crate by distance 0.11 m when applied force is 2 N

A: Given data:  Force (F) = 2 N Distance (d) = 0.11 m Angle (θ) = 0° Required: Work done (W)

Q: A car traveling 30 m/s due east turns a smooth corner and heads northeast. The car maintained a…

A:

Q: Write the vector expression for the acceleration a of the mass center G of the simple pendulum in…

A: CONCEPT:

Q: An electrostatic dust precipitator that is installed in a factory smokestack includes a straight…

A:

Q: article with kinetic energy equal to 300 J has a momentum of magnitude 25.5 kg · m/s. Calculate the…

A:

Q: The drift velocity of electric charges through a material depends on the current flowing through the…

A: the current flowing through the material.

Q: 1. Determine the magnitude and direction of the resultant of the following concurrent forces: 2000…

A:

Q: A very small steel marble is shown rolling at a constant speed on a horizontal table. The marble…

A: From graph we have to answer the time marble took to travel from N to L From graph distance between…

Q: a. Multiply (1.359 x 109 m) by (2.4 x 10-10 m). Express your answer in scientific notation. b.…

A: Given, a  1.359×10-9m×2.4×10-10m b 1.24×10-8m÷0.00020m

Q: A Fresnel biprism has an apex angle 180°-a, where a is very small. The index of refraction is n, the…

A: The Fresnel biprism demonstrates light interference. It is an adaptation of the well-known Young's…

Q: A shot putter releases the shot some distance above the level ground with a velocity of 12.0 m/sm/s,…

A: Part 1 Since the only force acting on the projectile during the flight, is the force of its weight…

Q: ts) Assume a string with length L which is fixed at left side, and the mass, m, and the spring with…

A: Given:The length of the string is LThe stiffness of spring is k. To determine the natural frequency,…

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.