Answered: Question 7. In the figure calculate the…

Question 7. In the figure calculate the battery charging current. Supply voltage is 80 v, the resistance is 5 £2 and the battery is 15 v KH KH

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter15: Alternating Current

Section: Chapter Questions

Problem 2PA: You are a journeyman electrician working in a large office building. The fluorescent lighting system...

See similar textbooks

Related questions

Q: Using Mesh analysis, find i1 in Amperes if Vs = 12.1 V and R = 1.8 Ohm. Give answer in 2 decimal…

Q: When running on its 11.4 V battery, a laptop computer uses 8.3 W. The computer can run on battery…

Q: A 350 km transmission line has the following parameters: z = 0.0195 +j0.35 Ω/km y = j4.5 μS/km If…

A: Given parameters: Transmission line length (L) = 350 km Line impedance per unit length (z) = 0.0195…

Q: i need DRAW answer(D), FIRST DRAW SPECTREM , SECOND STEP DETERMINE THE POWER AT THE FILTER INPUT AND…

A: Given data:

Q: Remove the 10 V source, and then find I1, I2, I3, V1, and V2 in the circuit

A: In this questionWe need to determine the current I1 , I2 and I3 as shown the circuit. Also…

Q: 1/ Consider a system transmitting 5 Mbps in baseband. a/ Determine the theoretical minimum bandwidth…

A: Given bit rate value as 5Mbps

Q: A long shunt compound motor supplies a load current of 60A. It has an armature resistance of 0.1…

Q: A 460 V, 25 hp, 60 Hz, four pole, Y-connected induction motor has the following impedances: R1 0.641…

A: It is given that:,,,,

Q: Q. 1 A discrete sequence x(n) is given by x(n) = {-1,3,-3,-1, 4, 2, -2,4} ↑ Find the following and…

Q: A prototype active filter (R = 122, C = 1 F, wc = 1 rad/s) has a gain of -160 dB at @ = 0.01 rad/s…

A: Given data:

Q: 100/0° V/ (+21) Μ 2Ω 10 Ω 3Η 4H m 2Η 5Ω

A: Given Circuit:Frequency To determine:The currents I1, I2, and I3.

Q: If the terminal voltage of a circuit is 100 sinot + 50 sin(3wt + 45°) and the current is 10sin(wt +…

A: They have given terminal voltage and current and we have to find reactive power for the values

Q: Q1. Determine lp and Vo for the following circuit.

A: It is given that:

Q: If R = 44.00 2, calculate the power dissipated in the 44.00 2 resistor and the voltage labeled vc in…

A: The above question is based on the transient response of an RC circuit.The voltage vc(t) is given by…

Q: Suppose you are designing a TDM system to serve 30 standard voice channels (8 kHz sampling rate)…

A: To determine the minimum transmission bandwidth required for the TDM (Time Division Multiplexing)…

Q: True or false A) One disadvantage of the catheter tip pressure sensor is that it is more expensive…

A: (A) True. The catheter tip pressure sensor is considered more expensive compared to other types of…

Q: 12 V 692 1₂ 592 3902 4 Ω www 12 92 O-512 + 2013 - 12i4 The mesh-current equation of mesh 3 in the…

A: Given Data:A four-mesh DC resistive circuit with,Mesh currents To Find:Mesh equation at mesh 3.

Q: Calculate the current through 6 ohm resistance in the circuit shown in Fig below, using Norton's…

A: In this questionWe need to determine the current in the 6 ohm resistance using the Norton theorem.

Q: P 2.4-2+A current source and a resistor are connected in series in the circuit shown in Figure P…

A: It is given that:

Q: 19. Let v₁ (t) = -8 cos(1000nt +80°) and v₂ (t) = 4 sin(1000nt - 120°). By how much does v₁ (t) lag…

Q: A rectangular waveguide of dimensions a=1.5 cm and b=0.8 cm is filled with a lossless dielectric…

A: Waveguide dimension; and .The two field components are;,,

Q: For the following transmission system, taking into consideration a base power of 40 MVA and a base…

A: To transform the system into a single-line diagram of impedances (reactances) in per unit, we need…

Q: for a common emitter amplifier shown (beta=100) (R1=15k, R2 = 8.2k) Compute for Zin, Zout, Bre,…

A: In the given questions we need to calculate the DC and ac parameters of the given amplifier circuit.

Q: Q. 4 Determine whether the following signal is energy-type or power-type. x(n) {5, 3, 3,-1, 3, 2,…

Q: P 2.4-5+ A voltage source and two resistors are connected in parallel in the circuit shown in Figure…

A: It is given that:

Q: In the following circuit obtain: (a) the voltages V1 and V2 (b) the complex power for the impedance…

A: In this questionWe need to determine the voltage V1 and V2 as shown the circuit. And also need to…

Q: 12 V 4Ω Μ www Μ 4A 3Ω 10 Ω R If R =3 ohms, use the superposition principle to find i, in the above…

A: Given dataThe source voltage is .The source current is .The value of resistance is .To find We have…

Q: Let h(t) be the impulse response function of an ideal Filter whose response in frequency is given by…

A: To find the impulse response function h(t), we can use the inverse Fourier transform of the…

Q: Given that Ico - 2 mA and VCEQ = 10 V, determine R₁ and Rc

A: It is given that:

Q: 1. For the following circuit, switch is closed at t=0. a. Write a differential equation in i(t). b.…

A: “Since you have posted question with multiple sub parts,we will provide the solution only to the…

Q: If the voltage sources in the circuit shown are converted to current sources and then combined, what…

Q: 3. In the following circuit, va 18 cos(4000r -90°) V and vs = 12 cos(4000r) V. a) Construct the…

A: Given:A network, with,To do:a) We have to construct the frequency domain equivalent circuit of the…

Q: A 350 km transmission line has the following parameters: z = 0.0195 +j0.35 Ω/km y = j4.5 μS/km Part…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: Q.3 For each of the following systems, determine whether the system is (1) causal or non-causal (2)…

A: Given:Two discrete time systems,To find:whether the given systems are i) causal or non-causal ii)…

Q: What is the difference between gates and circuits?

A: It is asked to explain the difference between gates and circuits.

Q: 4-21 Determine the Boolean functions for outputs F and G as a function of four inputs, A, B, C, and…

A: 1. Not gate - If the input to Not gate is A then output will beY = A'2. AND gate - If the inputs to…

Q: What is the value at out if: a-1001 b-0100 Cin-0 $150-01 A) 1001 B) 0100 C) 1101 D) 0000. What is…

A: According to the question, we need find the output

Q: Required information The switch above the 12 V source in the circuit has been closed since just…

A: The above question is based on the time constant of an RC circuit given by T = RC where R is the…

Q: Derive the Boolean expression for the logic circuit shown below:

A: The given logic circuit is drawn below:

Q: A radio can tune over the frequency range of a portion of MW broadcast band: (800 kHz to 1200 kHz).…

A: It is given that:

Q: The illumination given out by a lamp is not necessarily the same in all directions. The candlepower…

A: The candlepower measured directly downward direction is C.P.The candlepower measured degrees to…

Q: MSP432 Code Composer Studio using ARM-Cortex M4 Assembly. Make a linear congressional generator…

A: According to the question, we need to write MSP432 Code Composer Studio using ARM-Cortex M4…

Q: A TV signal has a bandwidth of 4.5 MHz. The signal is sampled according to the Nyquist theorem,…

A: To determine the transmission rate in baud (symbols/second), we need to consider the different…

Q: Find i(t) of this circuit.

A: The given circuit isWe need to determine the current, i(t).

Q: ive an example of open loop and closed loop system (one example each). Also state the input, control…

A: System:It is nothing but the interconnection between the number of components to form a specific…

Q: Refer to this figure. Find the value of lE. Vino 1 μF не R₁ 22 ΚΩ R₂ 5 ΚΩ express answer in mA. +20…

Q: Using Mesh analysis, find vo (in Volts) if Vs = 18.1 V and R = 4.2 Ohm. Give answer in 2 decimal…

A: Given:A circuit, with,To find:The value of V0.

Q: For an active low Set and reset waveform, how do you find the output waveform?

A: As per the question, we are asked How do we find the output waveform for an active low Set and reset…

Q: d- If a BPF filter is to be used at the output of the FM modulator with a transfer function H(f) as…

A: Given:FM modulated signal equation, To determine:a) Modulation index. b) Phase deviation .c)…

Q: What is transformer?

A: Transformer :-A transformer is the most basic device used to transmit electrical energy from one…

Concept explainers

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Summarize the given data

VIEW

Step 2: Determine the output voltage of the given rectifier circuit

VIEW

Step 3: Determine the battery charging current

VIEW

Solution

VIEW

Step by step

Solved in 4 steps with 18 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

a 1.5 volt cell delivers 600 mA to a residtive load. if the internal resistance is 0.09 ohms, what is the terminal voltage
A 14-volt battery is connected to a series circuit in which the inductance is 1-henry and the resistance is 4-ohms. Determine the current after 5 seconds if the initial current is 1.4-ampere. (answer only, no need for the units, use 3 decimal places) Round your answer to 3 decimal places.
Find the diameter in inches of 3000ft of copper wire that has a resistance of 77.78Ω
A battery is connected to a load resistor R. When its value is1.8Ω , the current value is 0.7 A. When the load resistor value is 2.3Ω, the current value is 0.56A. Find the short-circuit current.
Q: A wood panel containing 16 solar cells. Calculate the total open circuit voltage and short circuit current coming out of the board and draw the relationship between current and voltages in the following cases 1- If you connect each two cells in series and connect the groups in parallel. 2- If all four cells are connected in parallel and the groups are linked in succession, noting that each cell has the following characteristics: Vos = 0.75V, Isc = 2 mA
7.a. Calculate the current passing through each battery in a charging hookup of four parallel strings of threebatteries in series when the total current is 24 A?A. 24AB. 6AC. 12AD. 2A 7.b. What is the watthour efficiency of a battery that was discharged 150 Ah at an average voltage of 1.90and was then recharged at an average voltage of 2.45 for 175 Ah?A. 85.71%B. 66.5%C. 68.5%D. 65.3%
with the increase of lamps connected across the PV modules, which of the following variable will increase a. output voltage of PV Module b. output current of PV Module c. Output power of PV Module d. Area of PV Module
3. A 19-volt battery is connected to a series circuit in which the inductance is 1-henry and the resistance is 5-ohms. Determine the current after 10 seconds if the initial current is 0.8-ampere. (answer only, no need for the units, use 3 decimal places) Round your answer to 3 decimal places. with solution please, thanks
A battery consists of four cells connected in parallel, each having an emf of 24 volts and resistances of 0.40, 0.45, 0.42, 0.46 Ohm. A resistance of 1.50-Ohm is connected across the terminals of the battery. Determine: current; terminal voltage; current in each cell; Efficiency of the system.
1. upload a solution and draw a figure
Theoretically, calculate all the currents and the voltages for the circuit shown in Figure 11.
If a string of suspension insulator has three units, each can withstand a maximum 11 kV and total string can withstand 7.72 kV. What is the string efficiency