Question During CSMA/CA it is still possible for two nodes' traffic to collide, H both nodes are sensing the communication streams to ensure that another node is not transmitting how can this be possible? Binary Exponential Backoff O Switch Failure O Broadcast Storm O Propagation Delay

Q: Question 4 Multiple Access Protocols are how nodes regulate their transmission into the shared…

A: We have to answer which multiple access protocols is not a category that multiple access protocols…

Q: 14. (Single-choice) Based on the current IP transport network technology, the most important factor…

A: 14) Answer is a) device forwarding delay

Q: Consider the following three possible events that may be highlighted on SOC dashboards: a) A…

A: Step 1Answer a) i): A significant and unusual increase in the number of ARP responses on an internal…

Q: 9. Verify PC3 can ping its default gateway at 10.1.2.1 10. Configure static routes on R1, R2, R3 and…

A: Answer 9

Q: Question 1: what security parameters could be implemented on the following networks to secure and…

A: Q

Q: Consider the following three possible events that may be highlighted on SOC dashboards: a) A…

A: 1.a) i)A significant and unusual increase in the number of ARP responses on an internal network…

Q: 9. What is the default hold-down timer on R1: c. 360 Sec а. 18 Sec b. 240 Sec d. 180 Sec e.90 Sec…

A: 9) Ans: d)180 Because the default timer of R1 is 180 sec

Q: If a packet can't succeed in the crc, the switch in network will cancel it, this can be done by O…

A: If a packet can't succeed in the crc, the switch in network will cancel it, this can be done by:

Q: O d. Area ID Select the purpose of an OSPF router ID? O a. For transition of the OSPF neighbor state…

A: Dear Student, OSPF router ID does not facilitate the transition of OSPF neighbour state to full,…

Q: Which of the following are easy/difficult to handle in Virtual-Circuit and Datagram subnets, and…

A: Answer :-               ISSUES       DATAGRAM SUBNET   VIRTUAL CIRCUIT SUBNET Router…

Q: 3) Subnetting Using Variable size Subnet Masks (VLSM): ou have to subnet the network address…

A: Given IP address: 172.16.0.0/16 The VLSM subnetting scheme: First we make the subnet block for the…

Q: Which of the following sentences reflects the main function of the network tap installed between two…

A: Answer : The main function of the network tap installed between two networks:

Q: You are asked to perform an analysis on the network that will allow you to deduce information from…

A: ANS: - data traffic analysis is the correct option.

Q: 3. (True or False) The RAN centralized unit(CU) is also commonly referred to.as che RAN real-time…

A: Answer is given below .

Q: What is the function of traceroute command? a. Verify path to destination network. O b. Displays the…

A: In this answer I will be discussing about the traceroute command.

Q: What virtual, logically defined device operates at the Data Link layer to pass frames between nodes?…

A: Answer: A device that operates at data link layer for transferring the framers between nodes is…

Q: Node A and Node B are connected via a local area network (LAN) that runs CSMA/CD. Suppose node A and…

A: Answer: Option d Both node A and node B will detect a collision.

Q: Which of the following refers to the reduced quality of service that occurs when a network node or…

A: Network Congestion: Network-congestion occurs whenever a node or connection is transporting…

Q: SUBJECT : COMPUTER NETWORKING (PLEASE PROVIDE COMPLETE RELEVANT SOLUTION) Mr. Hadi sent an email…

A: GivenBandwidth= 1gbpsmessage size= 2.5kbdistance =X km from arid number X=701email speed =2.4 x 108…

Q: a) Refer to Figure 2-1, answer the following questions. State is Active 1 state change, last state…

A: Answer: I have given answer in the brief.

Q: 3) Subnetting Using Variable size Subnet Masks (VLSM): ou have to subnet the network address…

A: Given IP address: 172.16.0.0/16 The VLSM subnetting scheme: First we make the subnet block for the…

Q: Multiple choice in network  To avoids ARP request for every IP datagram Select one: a. Use ARP…

A: ARP cache is a cache memory where ARP entries are stored. Static Routing and DHCP are for…

Q: Server 00 00 E 00 00 E 00 00 E Switch Internet o0000 Router (1) Suggest one failing of this network…

A: 1. Hardware Failures is main reason to reduce the impact of any device failure by building in…

Q: The below network diagram consists of Rustaq, Middle and Sohar networks. Both Sohar and Rustaq…

A: A) Network address of rustaq  --> 10.10.10.0 Network address of Middle --> 193.40.11.0 Network…

Q: Question #4 a) In the below topology explain the situation when i. Computer A sends a frame to…

A: a) i) If computer A sends a frame to computer B and if the switch 1 does not have the MAC address of…

Q: Question Two: Which layer of the OSI Model handle flow control and error control.     Which layer…

A: The Fourth layer of the OSI model i.e TRANSPORT LAYER , it ensures and provide mechanism such as…

Q: Network congestion is manifested by which of the following?   a. packet loss caused by buffer…

A: Network gets congested when the traffic gets too much on the network.

Q: b) A junior network associate Ah Beng had set up multi-switched VLANS configuration as the master…

A: Answer: I have given answered in the handwritten format

Q: Use given Figure 1 to configure a two-router network. All router configurations must be assumed and…

A: Actually, IP stands for Internet Protocol..

Q: Sections 4.5.7 Lab - Build a Simple Network (do it in Packet Tracer) In this lab, you will…

A: GIVEN: Lab - Build a Simple Network (do it in Packet Tracer) In this lab, you will complete the…

Q: Device X. IP: 10.1.3. 161 IP: 10.1.3.175 SM: 255.255.255.240 SM: 255.255.255.240 How many subnets…

A: Explanation answer 1:

Q: four Clarify how congestion control, gradual begin and quick retransmit mechanisms have an effect on…

A: Mechanisms that influence the efficiency of TCP in a mobile environment   Congestion control…

Q: 9. Which of the following statements is true about P PP configuration and deployment? A. PPP can…

A: Which of the following statements is true about P PP configuration and deployment? A. PPP can…

Q: Access to media by multiple senders at the same time lead towards data collision, which particular…

A: In addition to the network topology modeling, we begin by presenting the different solutions that…

Q: a.) Why have the standards makers chosen to specify that requests for Delivery Status Notifications…

A: Answer a. The primary reason for sending requests for Delivery Status Notification via SMTP is…

Q: ode A and Node B are connected via a local area network (LAN) that runs CSMA/CD. Suppose node A and…

A: Node A and Node B are connected via a local area network (LAN) that runs CSMA/CD. Suppose node A and…

Q: DISCUSSION 1. Compare ping command and trace route command in troubleshooting a network. 2. list the…

A: Step 1  The answer is given in the below step

Q: ABC Corporation has been assigned the Class B network address 130.100.0.0. ABC needs to divide the…

A: We have been given a Class B network. We have to divide it into the 50 equal length subnets having…

Q: Consider the RTS/CTS option for B02.11 wireless network's multiple access scheme How doest address…

A: Hidden terminal prolem: Wireless networks may suffer this issue when two nodes are attempting for…

Q: You have a network that needs to be divided into 29 subnets. How many bits are needed for subnet id?…

A: In the given question,  A Network is divided into 29 subnet. No of bit is required ?   For any class…

Q: 1:02 PM QWhat is your question? B Consigerrtne two nOstS A aNa B are connected through a direct…

A: Given data:Bandwidth of the link = 10bits/sec.Propagation speed = 2x10 m/secDistance = 5000…

Q: You have a C network that needs to be divided into 25 subnets. How many bits can be given to host…

A: You have a C network that needs to be divided into 25 subnets. How many bits can be given to the…

Q: 1) What is the purpose of the LLC sub-warehouse? a) Hide differences between different multiaccess…

A: LLC (Logical Link Control):  It is a sublayer that generally provides the logic for the data link.…

Q: A 1-km long, 10 Mbps CSMA/CD LAN (not 802.3) has a propagation speed of 200 m/u sec. Repeaters are…

A: Answer: Solution:

Q: Which statement is false: a. In flow control, receiver's data is prevented from being overwhelmed.…

A: Answer: D. Data link layer and Transport layer handle Congestion control.

Q: 1. each call allocated periodic slot(s), can transmit at maximum rate of (wider) frequency band…

A: As per company guidelines, only first 3 questions need to solve . the answer for first 3 questions…

Q: Answer the all questions... 1. You have bcen allocated a class B network address of 135.1.0.0 and…

A: Answer :    1. You have been allocated a class B network address of 135.1.0.0 and need to create 4…

Q: Answer the all questions... 1. You have bcen allocated a class B network address of 135.1.0.0 and…

A: 1.) Given class B network address: 135.1.0.0 Since it is class B network, therefore, 16 bits are…

Q: Provide the IP configuration of the used PCs by filling the information in the following Table 1.…

A: The given address 192.168.10.0 is the class C address. As we need to subnetworks, the Subnet mask is…

Q: Create an IP address plan as efficiently as possible for the network shown below. The address space…

A: The answer is