Answered: Question -If a particular pavement…

Question -If a particular pavement fails with 98 number of repetitions of 4500 kg load and the same pavement fails with W number of repetitions of load 2855. Then vale of N is

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter20: Design Of Rigid Pavements

Section: Chapter Questions

Problem 17P

See similar textbooks

Related questions

Q: A bracket connection shown in figure, consists of a joist cutting welded to the flange of a column…

Q: - 2. A horizantal curve of R-500 m has a point of curvature PC : Km: 0+500, elevation: +60.00.…

A: Horizontal curve radius, R = 500 m Point of curvature, PC = 0+ 500 km Elevation = + 50.00 km…

Q: Qus - A masonry dam is founded on pervious sand. A factor of safety of 4 is required against…

Q: d) Assemble the system stiffness matrix (movable DOFs only)

A: Find: System stiffness matrix (movable DOF only)

Q: A metallic rod of diameter do is subjected to the tensile test. The engineering stress and the true…

Q: The bearing of a back tangent of a simple curve is N 65°00' E, while the forward tangent has a…

Q: ▪ Determine the Rankine active force, Pa, per unit length of the wall and the location of the…

A: Rankine's active force is given by the area of active pressure diagram. In order to draw the active…

Q: A 24x 48 (BxL) mat foundation causes a bearing pressure of 240 kPa. The footing is to be constructed…

A: B = 24 m L =48 m bearing pressure = 240 kPa Footing is 4 m below the surface Dry unit weight = 17…

Q: Estimate the maximum flow of leachate from the bottom of a landfill lined with a 0.2 m thick clay…

A: To estimate the maximum flow of leachate from the bottom of a landfill, we can use Darcy's law.…

Q: Example 9.13 Solution: Find slope at A and deflection at E just below the load. Use area moment RA…

A: Simply supported beam of span L with point load P acting at distance 2L3 from left support

Q: How should the value of synergy be apportioned between the bidder and target firms? Do not pay for…

A: When considering the apportionment of synergy value between the bidder and target firms in a merger…

Q: Determine the magnitude of the force which member CD exerts on the pin at C. A B 125° 0.70 m Answer:…

Q: 4.in /Inside diameter Flow 2-in Inside diameter h Murcary (sg=13.54)

A: Diameter at A = 4 in Diameter at B = 2 in Height, h= 28 in

Q: Figure Q2 shows a 2-dimensional truss. The area of each member is equal to A. The modulus of…

A: Find: (a) Degree of freedom (b) Transformation matrix (c) Global stiffness matrix

Q: A truss is supported by a pin support at H and a roller support at G. For the given loading,…

Q: Determine the current PCR for this section. PCR Now, assume a new roughness measurement is expected…

A: Formula given for pavement condition rating, PCR = 99.3 - 5.515.0-Rough - 1.59LNALL -0.221AVGOUT…

Q: A concrete dam retaining water is shown. If the specific weight of the concrete is 23.5 kN/m³.…

Q: Use the method of joints to determine the internal forces in each member of the truss. The structure…

Q: compression loads in the first interior column of the structure shown are: 95 kN (dead load), 50 ve…

A: Given:- dead load=95kN live load=50kN wind load=75kN k=0.65 To find:- remaining allowance

Q: Problem- If axle load of a vehicle is 25 tonnes on a road, then Vehicle Damage Factor is (Standard…

A: Axle load A=25 tonnes, Standard load S=9 tonnes, To Find- The value of Vehicle Damage Factor VDF.

Q: All are incorrect, can you re-work?

A: The degree of the curve = Da = 5°0' The intersection angle = 20°30' The station of the PI = 63+25.53…

Q: escribe (a) how public transportation facilities have influenced urban form and land development in…

A: Urban transportation refers to the movement of people and goods within urban areas with high…

Q: A horizontal force of P = 45 kN is applied to joint Cas shown in (Eigure 1). Each pin has a diameter…

A: Shear stress is the force that tends to cause deformation of a material by sliding along a plane.…

Q: In fine sand aquifer region, design a well to get 10 l/sec yield under the depression head of C 2.5…

Q: -7. Locate the centroid of the parabolic area. ax Prob. 9-7 h ·x

A: A Locate the centroid x bar

Q: Find KN derivation Y = K m²³

A: We have to prove that the unit of unit weight is kN/m3.

Q: SITUATION F. A reinforced concrete beam 250mm wide and 450mm high carries an ultimate moment of 202…

Q: Problem VII. A simply supported beam of length 7 m. has a concentrated couple of 10 kN m applied…

Q: why did you choice 40% and 60% Please explain this part deeper

A: 40% of aggregate A is blended with 60% aggregate B

Q: A sample of clay soil of volume 1x10^-3 m^3 and mass 1.762 kg, after being dried out in an oven had…

A: Volume of sample (V) = 1 × 10-3 m3 Mass of sample (M) = 1.762 kg Dry mass of the sample (Md) =…

Q: Air moves over a 10 m long flat plate. The transition from laminar to turbulent flow takes place…

Q: Determine the force in each member of the loaded truss. All triangles are equilateral with side…

Q: Determine the reactions at the supports and draw the bending moment diagram for the following…

A: To find the reactions at the supports and to draw the Moment diagrams.

Q: A laboratory study models the flow around the pier of an off-shore wind turbine with a scaled model…

Q: It is proposed to use a two-stage plant instead of the single stage plant. The total volume of…

A: The total volume of filter medium = 0.082 ha-m The flow rate = 3.79 mld The influent BOD = 240 mg/l…

Q: The 490-N force is applied to the 97-kg block, which is stationary before the force is applied.…

Q: A hydraulic jump occurs at the foe of a spillway. The depth before jump is 0.2 m. The sequent depth…

A: Depth before jump- y1=0.2 m, Sequent depth y2=2 m,

Q: Determine the value of the critical load for the column, consider that the top end is adapted to an…

A: A column and a truss are given.The Young's modulus of elasticity, E = 70GPa To determine the…

Q: 6.46 Identify which element would have a force of 0 under the presented loads. 4 KN +KN A=Pin 4 KV H…

A: Determine the member having zero force.

Q: The results of 15 compressive strength tests for a 20 Mpa requirement are detailed in the table…

A: Using the results of 15 compressive strength tests for a 20 MPa requirement given, the standard…

Q: An image of a hilltop is 87.5 mm from the centre of a photograph. The elevation of the hill is 665 m…

A: Given - Height of image, r = 87.5 mm Elevation of the hill, h = 665 mm Flight altitude, H = 4660 mm…

Q: The velocity of a particle is given by v = {16t2 i + 4t3 j + (5t + 2)k} mis, where t is in seconds.…

A: Velocity of particle v=16t2i^+4t3j^+5t+2k^ To find The magnitude of particle's acceleration when t=…

Q: Uniform flow occasionally occurs in a 5-m-diameter circular concrete conduit but the depth of flow…

A: Given data- diameter D= 5mn=0.013slope S=0.0005

Q: A & C are incorrect, please re-work

A: As per question , I solve here only a and c. Find out - (a) Radius of curve (c) Tangent length

Q: A. Determine the reactions to the structure B. Plot the shear and moment diagrams W = 0 kips/ft. A…

Q: 9-7. Locate the centroid of the parabolic area. Prob. 9-7 ·X

Q: The index of wetness at a place is noted as 40%. What is the rainfall deficiency at that place?

A: Index of wetness IW=40%, To Find- The value of rainfall deficiency.

Q: In a certain irrigation project and in a given year, 72% and 56% of the culturable command area…

A: An irrigation project- 72% of the culturable command area (CCA) remained without water during Kharif…

Q: What are the geocentric coordinates in meters of a station which has a latitude of 50°25'33.71631"…

A: ϕA=Latitude of station=50°25'33.71631''NλA=Longitude of station=121°49'53.68672''WhA=Height of…

Q: Which of the following best defines asphaltic cement? Multiple layers of a material used as…

A: Context: Asphaltic cement

Concept explainers

Drainage of Pavements

Pavement Drainage holds ample significance, as it prevents the accumulation of water or any liquid on the surface of pavements and ensures proper drainage system. With proper design and gradual slopes provided, the water gets easily removed from the surface into the drains, which are essential during heavy rains and unusual weather conditions keeping it less prone to accidents and increasing the durability of the pavement structure.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given

VIEW

Step 2: To Find

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A dual wheel having a load per tire of 5000 Ib, 70 psi pressure and μ = 0.5. Calculate thetotal pavement deflections due to the dual wheel by one-layer theory at the followingradial distances from the centerline of one tire: r=0, 3.5,10.5. (Use Pavement Thickness= 8in).
3) Differentiate function of bound and unbound layer of flexible pavement.
A pavement element along Thika road of 100x150x200 mm was subjected to an equalall round pressure of 120kn/m2 and axial load of 2.5KN in the X-direction. The changesin length are 0.92mm in X-direction, 0.27mm in the Y-direction and 0.18mm in the Z direction. Calculate thei. Elastic theory ratio, Eii. Poisson’s ratio,iii. Bulk Modulus, K
answer with complete solution. Asap 1. determine the safe thickness of rigid pavement if the wheel load is 85 kN and f'c = 32 MPa
Given a concrete pavement with a thickness of 8 in. (203 mm), a kvalue of 100 pei (37.1 MN/m³) doweled joints, and no concrete shoulders, determine the allowable repetitions under a 54-kip (240-kN) tridem-axle load based on erosion enteria. The Question is related to Highway and transportation Engineering.
13. Refer to Figure 3.1 attached. In the flexible pavement design example illustrated in the figure, what would be the required structural number if designing for W18=2,000,000 instead?a. 1.5b. 4.3c. 6.1d. 7.3
Ex/ Comparison Between Flexible and Rigid Pavements ? Comprehensive comparison
Please solve the below question and give the solution in m3/day/m2 only not in feets. please solve it as early as possible. Determine the ground water infiltration rate for a new four-lane pavement with the following characteristics: Lane width = 3.6m Shoulder width = 3m Length of contributing transverse cracks (Wc) = 12m Rate of infiltration (Kp) = 0.015 m3/day/m2 Spacing of transverse cracks = 12m
Determine the required structure number of the pavement based on the following information: . . ESAL= 5 million Reliability = 99% Standard deviation = 0.45 • Pi = 4.5, Pt = 2.5 . Subgrade Mr=9,000psi
A concrete pavement is to be constructed for a four-lane urban expressway on a subgrade with an effective modulus of subgrade reaction k of 100 lb/in3. The accumulated equivalent axle load for the design period is 3.25 x 106. The initial and terminal serviceability indices are 4.5 and 2.5, respectively. Using the AASHTO design method, determine a suitable thickness of the concrete pavement if the working stress of the concrete is 600 lb/in2 and the modulus of elasticity is 5 x 106lb/in2. Take the overall standard deviation So as 0.30, the load-transfer coefficient J as 3.2, the drainage coefficient as 0.9, and R = 95%.
Q2: The traffic on the design lane of a proposed four-lane rural interstate highway consists of 40% trucks. If classification studies have shown that the truck factor can be taken as 0.45, design a suitable flexible pavement using the 1993 AASHTO procedure if the AADT on the design lane during the first year of operation is 1150, pi = 4.5, and pt = 2.5 . Growth rate = 3% Design life = 20 years Reliability level = 95% Standard deviation = 0.45 The pavement structure will be exposed to moisture levels approaching saturation 20% of the time, and it will take about one week for drainage of water. Effective CBR of the subgrade material is 7. CBR of the base and subbase are 70 and 22, respectively, and Mr for the asphalt mixture, 3102 MPa (450,000 lb/in2).
Determine the safe thickness of rigid pavement if the wheel load is 85 kN and f'c=32 MPa.