Pls find the Question attached Questions 21 and 22 are based on the following physical situationA plank of mass 1.5 kg is placed on a horizontal floor that is lubricatedwith oil. Top of the plank is in level with a platform as shown in thefigure. Force of viscous drag on the plank due to layer of lubricating oil,Plankwhen the plank slides is given by equation / = -kü , where i is in N, iis velocity of the plank in m/s and k = 2.0 kg/s. A small block of mass 0.5kg lands from the platform on the plank with a velocity 10 m/s and aftersliding some distance on the plank, the block stops on the plank.21. How far does the plank slide on the floor?(b) 1.5 m(d) 3.0 m(a) 1.0 m(c) 2.5 m22. Which of the following graph best describes relation between magnitudeof frictional force F between the block and the plank with time t?(a)(b)F4F4(c)(d)

From the momentum conservation between the plank and the block.

Questions 21 and 22 are based on the following physical situation A plank of mass 1.5 kg is placed on a horizontal floor that is lubricated with oil. Top of the plank is in level with a platform as shown in the figure. Force of viscous drag on the plank due to layer of lubricating oil, when the plank slides is given by equation † = -kü , where † is in N, ū is velocity of the plank in m/s and k = 2.0 kg/s. A small block of mass 0.5 kg lands from the platform on the plank with a velocity 10 m/s and after sliding some distance on the plank, the block stops on the plank.

Questions 21 and 22 are based on the following physical situation A plank of mass 1.5 kg is placed on a horizontal floor that is lubricated with oil. Top of the plank is in level with a platform as shown in the figure. Force of viscous drag on the plank due to layer of lubricating oil, when the plank slides is given by equation † = -kü , where † is in N, ū is velocity of the plank in m/s and k = 2.0 kg/s. A small block of mass 0.5 kg lands from the platform on the plank with a velocity 10 m/s and after sliding some distance on the plank, the block stops on the plank.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The relative density of oil is 0.8 (relative to water). Determine your weight specific.
A oil of specific gravity 085 determine the density of the oil. Fluid question.
PLEASE ANSWER QUESTION # 2 ONLY, DISREGARD THE OTHER PROBLEMS GIVEN. SHOW COMPLETE SOLUTION. THANK YOU. Intravenous infusions usually are driven by gravity by hanging the fluid bottle at sufficient height to counteract the blood pressure in the vein and to force the fluid into the body (fig. below). The higher the bottle is raised, the higher the flow rate of the fluid will be. An 8 ft diameter by 16 ft height vertical tank is receiving water (? = 62.5 lb/ft3) at the rate of 295 gal/min and discharging through a 4-in ID line with a constant speed of 6 fps. At a given instant, the tank is half full. QUESTION #1: the mass change in the tank (sample answer: 20,287.65 lb. round off to 2 decimal place QUESTION #2: the water level in the tank 15 min. later (sample answer: 20,287.65 ft round off to 2 decimal place QUESTION #3: the volume change in the tank (sample answer: 20,287.65 cu ft round off to 2 decimal place
QUESTION 35 A syringe (X), forces air, at a high velocity, over a straw (Y). The air in the water chamber (Z) is not moving. Using Bernoulli's Principal, pick the best answer, that describes what will happen to the water in the chamber. Remember that things are always pushed from high pressure areas to low pressure areas. a. The high velocity air at (Y) will have the SAME PRESSURE as the low velocity air over the water at poing (Z), so the water will neither move up or down the straw. b. none of these are true. c. The water in the straw will be forced down into the chamber because the high velocity air at (Y) has a HIGH PRESSURE compared to the air over the water in the chamber at point (Z). d. The high velocity air at point (Y) will have a LOW PRESSURE. As a result, the slow air in the chamber (Z) will have a high pressure, thus forcing water up the straw.
A car tire has a volume of 3730 cubic inches. at a pressure of 32 psig and a temperature of 80°F (a) What is the volume of air in the tire? (b) The air temperature rises to 145°C during operation. In the event that the tire is rigid. What is the percentage increase in guage pressure as a result of this? (c) How much of the 145°F air must be drained away to restore the pressure to its original level?I need a complete solution with sketch
Consider the sealed containers (same fluid and on the same ground level) below with heights given in ? and ? values.Provided that ? = 2?, answer the following items. (refer to a.jpg) What container has the greatest pressure at the point indicated? Which point experiences the least pressure? Suppose the bottom pressure is evaluated, what container experiences the second highest pressure?
What is the general formula for calculating the number of days allowed for fishing in oil and gas ?
Three types of fluids stack in an open tank as shown in the plot. Select the expression of the gage pressure at location 2, P2(gage)=______ A. B. C. D. patm
[Buoyancy] The weight of an irregular object in air was found to be 75 lbs. When immersed in water, the weight is 47.5 lbs. Calculate the approximate specific weight of the object. find the: specific weight = ________ lb/ft3
27. The space between two square flat parallel plates is filled with oil. Each side of the plate is 560 mm. the thickness of the oil film is 10 mm, the upper plate, which moves at 2.8 m/s requires a force of 92 N to maintain the speed. Determine a) the dynamic viscosity of oil in poise, b) the kinematic viscosity of the oil in stokes if the specific gravity of the oil is 0.75. And also draw the neat sketch. i) Dynamic viscosity of oil =________________ Poise. ii) Kinematic viscosity of oil =__________________ Stokes.
PART A Using the graph to the right, what would Air Pressure be (mb) at an altitude of 10 km? What is the approximate altitude where the air pressure is 400 mb? PART B At an altitude of 0 km, what is the air pressure in mb?
Consider the sealed containers (same fluid and on the same ground level) below with heights given in ? and ? values.Provided that ? = 2?, answer the following items. (refer to a.jpg) If ? = 2 in, and the density of the fluid is 60 lbm/ft3, what is the pressure at point B in psia? (round off four decimal places on the final answer only)