Refer to the figure below. Identify the part of vernier caliper. O 10 20 30 40 50 60 TO B0 90 100 110 120 13) 140 150 160 A Lower Jaws for Volume Measurement B Lower Jaws for Radius Measurement Upper Jaws for Outside Measurement D) Upper Jaws for Inside Measurement

Refer to the figure below. Identify the part of vernier caliper. O 10 20 30 40 50 60 TO B0 90 100 110 120 13) 140 150 160 A Lower Jaws for Volume Measurement B Lower Jaws for Radius Measurement Upper Jaws for Outside Measurement D) Upper Jaws for Inside Measurement

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter25: Geometric Optics

Section: Chapter Questions

Problem 28CQ: If you wish to see your entire body in a flat minor (from head to toe), how tall should the minor...

See similar textbooks

Related questions

Q: The only force acting on a 4.0 kg body as the body moves along an x axis varies as shown in the figu...

A: Equation of force acting on the body:- F= (-8x + 8) N. (For: (0<x<2)) = -8 N ...

Q: Cardo Dalisay travels north 5 miles and then goes west 3 miles before coming straight back south 2 m...

A: Step1 - Let us draw the diagram of this motion.

Q: The figure below shows a simplified model of a cardiac defibrillator, a device used to resuscitate p...

A: given: Vc=795VV=1270 VC=8.25μF=8.25*10-6 Ft=1.20sec

Q: What is the current through the 10 N resistor in the figure (Figure 1)? Express your answer to two s...

Q: Which angle gives a longer range? 300 or 500

A: Let the initial velocity of a projectile = u Let the launch angle = θ

Q: A uniform electric field of 7.42 V/m west and a uniform magnetic field of 7.78 T west exist in a reg...

Q: 04/ A 350 g block is attached to a horizontal spring and executes simple harmonic motion with a peri...

Q: You are driving a car with a mass 1700 kg at a speed of 25 m/s around a curve of radius 20 m. What i...

A: mass (m) = 1700 kg speed (v) = 25 m/s radius (r) =20 m

Q: Tectonic plates are large segments of the Earth's crust that move slowly. Suppose one such plate has...

Q: figure shows a conical pendulum, in which the bob (the small object at the lower end of the cord) mo...

Q: Practice: Consider a straight current carrying wire with current flowing into the screen as shown in...

A: To find the direction of the magnetic field, we will use right thumb rule.

Q: Determine the amount of charge stored on either plate of a capacitor 4.0x10^(-6) F when connected ac...

Q: Find the magnitude of the force on a 3.06-C charge moving with velocity 2.29 m/s west in a uniform m...

A: Given data: Charge (q) = 3.06 C Velocity (v) = 2.29 m/s towards West Magnetic field (B) = 9.8 T, to...

Q: Can you give several examples of an object's motion in which a great distance is traveled but the di...

A: Displacement is the shortest distance between the final and initial position of the object . ...

Q: Calculate the change in electrical potential energy when a +2.0-C charge moves from a position C to ...

A: We have 3 charges q1=q3=10 C, q2=-20 C and a test charge Q=2 C initially at point C and afterwards i...

Q: From the edge of a cliff, a 0.66 kg projectile is launched with an initial kinetic energy of 1640 J....

Q: A surfer is catching a wave. Suppose she starts at the top of the wave with a speed of 1.4 m/s and m...

A: Given: Mass of surfer(m) = 59 kg vi=1.4 m/s vf=9.4 m/s Vertical height (h)= 2.7 m

Q: Compute the final velocities v1' and v,' after collision of the two cylinders which slide on the smo...

Q: At what separation will two charges, each of magnitude of 6 mC, exert a force of 1.2 N on each other...

A: Given: The magnitude of each charge is 6 mC. The magnitude of the force is 1.2 N.

Q: What is the voltage of the battery if the capacitance is 2.0x10^(-6) F and the charge is 3.0x10^(-5)...

Q: 2. A force system is shown below. a. Determine the magnitude of the resultant of the given forces. b...

A: a) Calculate the resultant force along the horizontal direction. Calculate the resultant force alon...

Q: A block travels up a 25 degree inclined plane with an initial speed of 14 m/s. (a) What is the acce...

A: Given data: Angle, θ=25° Initial speed, u = 14 m/s Solution: (a) What is the acceleration of the b...

Q: Three charged particles are arranged in the xy plane as shown in the figure below, with qa - 6.00 pC...

Q: Vhich of the following is always in the same direction as the acceleration O Frictional force D Disp...

Q: Antarctica is roughly semicircular in shape, with a radius of 2000 km. The average thickness of the ...

A: GivenRadius of semicircular shape, r=2000 kmThickness of ice cover , h=3000 m

Q: The resultant of three vectors is 90.00 cm 34o N of W. If two of these three vectors are 17.89 cm 27...

A: GivenResultant of three vector ,R=90 cm , 34° N of WTwo of these three vectorFirst Vector, A=17.89 x...

Q: which material (aluminum , copper , lead) increase the temperature of water by the greatest amount o...

Q: the positive 6. Find the angle that the tesultant of two forces: A= 150N, acting 60 degrees to left ...

A: As requested by you, i am providing solution of question 6.

Q: 3. A biker travelled 270.0 meters 42° N of E to point A, then 80.0 meters west to point B, and final...

A: Solution:-

Q: Estimate the magnitude and direction of the resultant given the following vectors. A = 10 steps, du...

A: We have two vector A = 10 steps, due East B = 16 steps, 60° South of East

Q: A .22 rifle bullet, traveling at 350 m/s, strikes a large tree, which penetrates to a depth of 0.130...

A: Given: The initial speed of the bullet is 350 m/s. The mass of the bullet is 1.8 g. The stopping dis...

Q: IV. Two forces are being exerted on an object, but in different directions. Find the magnitude and d...

A: Solution 1 :- As first force F = 10 N is along east and second force F' = 4 N is along west. Here F ...

Q: Q3/ A/ what is the difference between potential energy and elastic potential energy? B/ Prove that E...

A: We want to understand the difference between potential energy and elastic potential energy

Q: a. Set up an Integral expression for the total distance travelled by the particle in the first 12 se...

Q: An automobile vehicle has a mare of 15 00 g. what musse be he force befwenthevehiche moliread if he ...

Q: Both bright field and dark field microscopic measurements are commonly applied in the microcrystalli...

Q: 03) The forces, F1, F2, and F3 act on an object of mass m = 2.5 kg as shown %3D below. a) Calculate ...

Q: 8. Find the resultant of the forces: A= 120N, acting 50 degrees to left of the negative y-axis, and ...

Q: Determine the magnitude and direction of the electric force on an electron in a uniform electric fie...

Q: An average human heart beats 67 times per minute. If the average person lives to the age of 73. how ...

A: GivenAverage human heart beat =67 times per minuteAverage life of person=73 years

Q: Location A is 2.40 m to the right of a point charge q. Location B lies on the same line and is 3.90 ...

Q: Question 5 wish to cool the coffee down to 80°C. How much ice, whose initial temperature is -5°C sho...

A: GivenMass of coffee (M) = 1 kgInitial temperature of coffee =950C =368 KFinal temperature of coffee ...

Q: Ry << R2 R2 (not to scale) A thin spherical shell made of plastic carries a uniformly distributed ne...

Q: How do I solve this problem properly in a step by step solution?

A: Given Density = 0.01932 kg/cm3 = 0.01932 × 106 kg/m3 = 1.932 ×104 kg/m3 Mass = 3.54 g = 3.54 ×...

Q: A tennis ball is projected toward a smooth surface with speed v as shown. Determine the rebound angl...

Q: 3. Water flows at the rate of 5 ft³/s through an inclined pipe. At point A, wher the diameter is 12 ...

A: GivenWater flow at rate ,Q=5 ft3/sAt point Ad1=12 inPA=15 psiHeight between point A and B=24 inAt po...

Q: a.) Determine the magnitude of the resultant. b.) Determine the moment about the origin. c.) Determi...

Q: A projectile was launched from the top of a 25-m high building at a velocity of +35 m/s and at an an...

A: Answer:- Given Initial velocity in vertical direction (Vi) = 35 m/s Height (h) = 25 m Angel (A) ...

Q: A rocket-powered sled moves along a track, eventually reaching a top speed of 153 m/s to the east. I...

A: Use the formula of average acceleration to solve for average acceleration. As final speed is 0 m/s ...

Q: The current density in a copper wire of diameter 1.02 mm is 1.75 x 10⁵ A/m². The number of free elec...

Question

Refer to the figure below. Identify the part of vernier caliper.
O 10 20 30 40 50 60 TO B0 90 100 110 120 13) 140 150 160
A Lower Jaws for Volume Measurement
B Lower Jaws for Radius Measurement
Upper Jaws for Outside Measurement
D) Upper Jaws for Inside Measurement

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Q1.) What is meant by the least count of an instrument? Q2.) What is the least count of a meter scale? Q3.) What are the uses of vernier calliper? Q4.) State the principle of vernier calliper? Q5.) In the diagram given below, label the parts of the vernier calliper. Q .6 ) Complete the following table : No. Part of vernier calliper Use of the part 1 Main Scale 2 Vernier Scale 3 Screw 4 Lower jaws or outside jaws 5 Upper jaws or inside jaws 6 Strip Q.7 Calculate the least count of the vernier calliper in the diagram above. Q. 8) What is the observed reading on the vernier calliper in the diagram above? = ---------------------------------------------------------------- Q.8 ) Record the calliper readings given below: i. ) cm 0 1 2 3 4 0 10 ii.) 0 1 2 3 4 cm iii.) 0 10 0 1 2 3 4 cm iv.) 0 10 cm v.)
The answer to (a) is -ve but (b) isn't correct wether +ive or -ive. I'm not understanding (b).
An average eardrum has an area of about 5.0x10-5m2. What is the force in Newton's exered on an eardrum if you are at the bottom of a water filled pool that is 2.39 meters deep? Use g=9.8 m/s2 and assume 3 figures in your answer.
What is the least count of the vernier caliper shown in question 1?0.500.0050.100.01
What is the smallest reading a vernier caliper can have if it has 20 divisions in the vernier scale? a. 0.005 mm b. 0.005 cm d. 0.05 cm
A Vernier Calliper has 1 mm marks on the main scale. It has 20 equal divisions on the Vernier scale which match with 16 main scale divisions. For this Vernier callipers, the least count is.
Can you help me solve this problem and draw a picture of what's happening if possible? I will rate thank you!
help with these pleasee, atleast 3 sentence each. Badly need it. Thank you!
It is said that autistic children perceive their environment differently. Please describe the nature of their perception as it pertains to object and face recognition.
Inner sphere radius: R1 Shell radii: R2 and R3
its a solved question but i cant read handwriting please type it
well that was not help. I gues you guys don't bother reading the beginning, I can't read images and my screen reader won't read them for me. So instead of simply writing it out in html text... you waste my time again and write it up in images. Thanks. I guess I will have to ask this question again...