Refer to the figure provided in Question 26 for this question. Mukha mo diagram. Suppose the inductor is connected in series with a resistor and a capacitor. If V₁, represents the phasor of the voltage of the inductor as shown, which of the following correctly describes the phasor of the voltages of the resistor VR and the capacitor Vc? V₂ V₁ 2 27 V₂ OA. V₁: Vc, V₂: VR OB. V₁: VR, V₂: Vc OC. V₁: Vc, V3: VR OD. V₁: VR, V3: Vc V3 3

Refer to the figure provided in Question 26 for this question. Mukha mo diagram. Suppose the inductor is connected in series with a resistor and a capacitor. If V₁, represents the phasor of the voltage of the inductor as shown, which of the following correctly describes the phasor of the voltages of the resistor VR and the capacitor Vc? V₂ V₁ 2 27 V₂ OA. V₁: Vc, V₂: VR OB. V₁: VR, V₂: Vc OC. V₁: Vc, V3: VR OD. V₁: VR, V3: Vc V3 3

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 69CP: An RLC series circuit consists of a 50 resistor, a 200F capacitor, and a 120-mN inductor whose coil...

See similar textbooks

Similar questions

In a series RLC circuit with a maximum current of 0.250 A, an AC source with Vmax= 115 V operating at 60.0 Hz is connected to a 325-mH inductor, a 7.50-F capacitor, and a resistor with unknown resistance R. Draw a phasor diagram for this circuit, including the current, the potential difference across each of the circuit elements, and the source emf. Draw your diagram with the current phasor pointing upward along the vertical axis.
Calculate the reactance of a 5.0F capacitor at (a) 60 Hz, (b) 600 Hz, and (c) 6000 Hz.
A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?
Problems 71 and 72 paired. Figure P33.71 shows a series RLC circuit with a 25.0- resistor, a 430.0-mH inductor, and a 24.0-F capacitor connected to an AC source with Vmax = 60.0 V operating at 60.0 Hz. What is the maximum voltage across the a. resistor, b. inductor, and c. capacitor in the circuit? FIGURE P33.71 Problems 71 and 72.
A 60.0-ft resistor is connected in series with a 30.0-F capacitor and a source whose maximum voltage is 120 V, operating at 60.0 Hz. Find (a) the capacitive reactance of the circuit, (b) the impedance of the circuit, and (c) the maximum current in the circuit. (d) Does the voltage lead or lag the current? (e) How will adding an inductor in series with the existing resistor and capacitor affect the current? Explain.
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
For the cucu3t shown below, what are (a) the total impedance and (b) the phase angle between the current and the emf? (C) Write, an expression for i(t).
An RLC series circuit consists of a 50 resistor, a 200F capacitor, and a 120-mN inductor whose coil has a resistance of 20. The source for the circuit has an tins emf of 240 V at a frequency of 60 Hz. Calculate the tins voltages across the (a) resistor, (b) capacitor, and (c) inductor.
A 1.5k resistor and 30-mH inductor are connected in series, as below, across a120-V(rms)ac power source oscillating at 60-Hz frequency. (a) Find the current in the circuit. (b) Find the voltage drops across the resistor and inductor. (C) Find the impedance of the circuit. (d) Find the power dissipated in the resistor. (e) Find the power dissipated in the inductor. (1) Find the power produced by the source.
One application of an RL circuit is the generation of lime-varying high voltage from a low-volt age source as shown in Figure P32.82. (a) What is the current in the circuit a long time after the switch has been in position a? (b) Now the switch is thrown quickly from a to b. Compute the initial voltage across each resistor and across the inductor. (c) How much time elapses before the voltage across the inductor drops to 12.0 Y?
A 40-mH inductor is connected to a 60-Hz AC source whose voltage amplitude is 50 V. If an AC voltmeter is placed across the inductor, what does it read?
Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?