Remove the 50 resistor in the given circuit and assume an operating frequency of 50 Hz and a load of 100 connected between terminals a and b. In the given circuit /x = 8.000° A. j60 Q رووو 50 Ω 802 1x o a b Compute the instantaneous power absorbed by the inductance at t = 2 ms. (Round the final answer to three decimal places.) The instantaneous power absorbed by the inductance at t= 2 ms is 2351.611 W.

Remove the 50 resistor in the given circuit and assume an operating frequency of 50 Hz and a load of 100 connected between terminals a and b. In the given circuit /x = 8.000° A. j60 Q رووو 50 Ω 802 1x o a b Compute the instantaneous power absorbed by the inductance at t = 2 ms. (Round the final answer to three decimal places.) The instantaneous power absorbed by the inductance at t= 2 ms is 2351.611 W.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Similar questions

AC electrical circuit is below: (refer picture below) a. Determine the current flowing in the load. b. If it is desired that the system power factor be 0.9. With system frequency = 50 Hz. Determine how large the capacitor is must be installed? Which one is correct? A/B/others answer A. C = 7.7015 mF B. C = 35.243 µF c. Please Draw all the phasor. Please give complete, details, and correct answer. Please do step by step, draw the phasor Please using handwriting (not typing ). THANK YOU, I WILL GIVE MANY THUMBS UP.
1-Alternators can be overloaded by 10 percentage for 10-15 minutes, this a. Steady state voltage stability will get affected b. may reduce the stability limit c. may disturb Nose point d. may lose Angular stability 2-Often, the network is referred as an infinite bus when a change in input mechanical power or in field excitation to the unit does not cause an appreciable change in a. system frequency or terminal voltage b. system frequency alone c. system frequency and terminal voltage d. Total production cost
For a 152 kV, 60 Hz system, the capacitance up to the location of the circuit breaker is 0.020 micro Farad and the frequency of oscillation is 15 kHz respectively. Calculate the following : (i) inductive reactance of the line (ii) The maximum value of restriking voltage across the contacts of the circuit breaker. (iii) The maximum value of RRRV. ( expected time 10 minutes)
A lightning strikes a 30-m unshielded over-head transmission line tower Which has the following parameters Surge impedance of the tower= 100ohms Surge impedance of lightning channel at tower top =500ohms Tower-footing resistance=10ohms Tower height =30 m Cross-arm height=27m The lightning strike current is assumed to be a constant 30 kA for a duration of 20 µs. The raveling wave propagation speed in the tower is 1.2* 108 m/s. i) Determine the voltage reflection coefficients at tower top and tower foot. ii) Ignoring the phase voltage, determine the insulator voltage after 2µs.
A lightning strikes a 30-m unshielded over-head transmission line tower Which has the following parameters Surge impedance of the tower= 100ohms Surge impedance of lightning channel at tower top =500ohms Tower-footing resistance=10ohms Tower height =30 m Cross-arm height=27m The lightning strike current is assumed to be a constant 30 kA for a duration of 20 µs. The raveling wave propagation speed in the tower is 1.2* 108 m/s. i) Determine the voltage reflection coefficients at tower top and tower foot. ii) Determine the time of travel from tower top to tower foot. iii) Determine the time of travel from cross arm to tower foot. iv) Draw the voltage lattice diagram with proper labels of the time. v) Ignoring the phase voltage, determine the insulator voltage after 2µs. b) The insulator voltage approaches a constant value after 2 µs. If the basic impulse insulation level (BlL) of the insulator for phase conductor is 150 kV, evaluate the condition of the…
A 3 phase 10 pole 600 rpm delta connected alternator has 12 slots/pole with 8 conductors per slot. The windings are short chorded by 2 slots. The flux per pole contains a fundamental of 100 mwb, the third harmonic having an amplitude of 33% and fifth harmonic of 20% of the fundamental. Determine the rms value of the phase ,line voltages and Circulating Current Please answer in typing format please
Two equal voltages are out of phase with respect to each other by 90 electrical degrees. If the resultant is 311 Volts, what is RMS value of each one?-write legibly-show the complete solution
3.The voltage generated across one inductor of an alternator is 8.11V. There are 120 slots and 4 turns in every coil. The conductors are all in series and connected in double layer lap windings distributed sinusoidally in several slots. The coil pitch is 10 slots, frequency is 60 Hz and synchronous speed is 720 rpm. Calculate the line-to-line generated voltage if the alternator windings are connected wye. a. 2400Vb. 4160Vc. 4800Vd. 856V
Three sinusoidal alternating currents of RMS 5, 7.5, and 10 A are having the same frequency of 50 Hz with the phase angle 30, -70, and 45 degrees respectively. Find the average value in amperes. choices: a. 4.5, 6.76, 9.0 b. 5, 7.5, 10 c. 5.56, 8.83, 11.11 d. 6.0, 8.0, 10.0 Refer to previous problem, write the equations for their instantaneous current in ampere values. choices: a. i1 = 7.07 sin(314t + 30), i2 = 10.61 sin(314t + 70), i3 = 14.14 sin(314t + 45) b. i1 = 7.07 sin(314t + 30), i2 = 10.61 sin(314t - 70), i3 = 14.14 sin(314t + 45) c. i1 = 7.07 sin(314t - 30), i2 = 10.61 sin(314t - 70), i3 = 14.14 sin(314t + 45) d. i1 = 7.07 sin(314t - 30), i2 = 10.61 sin(314t + 70), i3 = 14.14 sin(314t + 45)
Q2: An impulse generator has 12 capacitors of 0.12 μF, and 200 KV rating. The wave front and wave tail resistance are 1.25 KΩ and 4 KΩ respectively. If the load capacitance including that of the test object is 1000 pF, find: (1) the wave front time , (2) the wave tail time, and (3) the peak voltage of impulse wave produced, and (4) the regulation of this generator? Ift1=3R1C1C2 / (C1+ C2) and t2=0.7(R1+R2) (C1+ C2)(Use Exact Method)
Three conductors of a 3-phase overhead line are arranged in a horizontal plane 6 m apart. The diameter of each conductor is 1·24 cm. Find the capacitance of each conductor to neutral per 100 km of the line. [0·785 μF]
Kindly help me with my assignment: 1. A three phase motor can be regarded as Balanced "Wye " load. A three motor draws 5.6 KW when the voltage is 225 V and the line current is 18.5 Amperes. Determine the apparent power and the power factor. 2. A single phase circuit with a given load 5 ohm resistance and capacitive reactance of 2 ohms as well. The voltage is being supplied 120Volts with a reference angle of 30 degrees at 60 Hertz frequency. Solve for P, Q, S. and power factor.