Answered: Required information In a refrigerator,…

Required information In a refrigerator, 1.60 mol of an ideal monatomic gas is taken through the cycle shown in the figure. The temperature at point A is 714.0 K.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter15: Thermodynamics

Section: Chapter Questions

Problem 43PE: Suppose you want to operate an ideal refrigerator with a cold temperature of 10.0C, and you would...

See similar textbooks

Related questions

Q: A square steel bar of side length w = 0.19 m has a thermal conductivity of k = 15.3 J/(s⋅m⋅°C) and…

A: Given data: Side length of the square steel bar, w=0.19 m Thermal conductivity, k=15.3 J/(s.m.C0)…

Q: Components: Vector A is along the +x-axis and vector B is along the +y-axis. Which one of the…

A: Given A→ is along positive x axisB→ is along positve y axisthereforeA→ donot have any y component,…

Q: How far apart are a proton and electron if they exert an attractive force of 3 N on one another?

Q: Cart 1 of mass m = 0.50kg fastened to a spring of spring constant k = 14N/m is pushed 15 mm in from…

A: Given: The mass of cart 1: m1=0.50 kg the spring constant: k=14 N/m Initial displacement: x=15…

Q: An automobile cooling system holds 18 L of water. How much heat does it absorb if its temperature…

A: Given data: Volume (V) = 18 L Initial temperature (T0) = 15°C Final temperature (T) = 95°C…

Q: What is the angular momentum (in kg*m*m/s) of a 350 g symmetrical rotating bar which is 4.50 m long…

A: Given, Mass of symmetrical bar (m) = 0.350kg Length of bar (L) = 4.50m Bar is rotating about…

Q: A rock is tossed to the right at 40 degrees above the horizontal (on Earth of course) at 10 m/s.…

Q: A particle of matter is moving with a kinetic energy of 9.56 eV. Its de Broglie wavelength is 1.53 x…

Q: 1. Which force diagram represents the correct magnitudes and directions of the electric forces (F)…

Q: Round the following measurement to the nearest hundredth: 35.147089m.

Q: Please refer again to Figure 2. This time, the incident ray is coming in from water (n=1.33) rather…

A: Given data: The angle θ=56.5° y = 27.7 cm h = 1.62 cm n1 = 1.33 The glass(n2) = 1.5

Q: 4. A 5.0 kg cat and a 2.0 kg bowl of tuna are at opposite ends of a 4.0 m long seesaw. How far to…

A: Draw the free-body diagram of the system.

Q: Point charges q1 = 10 µC and q2 = −8 µC are placed .14 m apart. What is the force on a third charge…

Q: Metric System: The metric system is preferred over the British system in science for the following…

A: We need to find why the metric system is preferred over the British system.

Q: For the calculation, where does '32kBT+12kBT+12kBT+12kBT+12kBT+12kBT+12kBT' come from

A: A linear triatomic gas has three translational degrees of freedom. The contribution for each…

Q: 6. The force on an object as a function of position is shown. Determine the amount of work done by…

Q: The magnetic field through a single loop of wire 14.0 cm in radius and of 11.5 Ω resistance changes…

Q: A 5.00 m–long uniform diving board that weighs 250.0 N is supported by two pillars. One pillar is at…

A: The free-body diagram of the board is shown below.

Q: An airplane flying 500mph flew over a monument at the same time that a second arplane also flew over…

A: Given: The speed of the first airplane: v1=500 mph The speed of the second airplane: v2=600 mph The…

Q: 2. KLE 1. t t 3. t

A: 1st graph This is a uniform motion in a straight line which means the speed(slope) is constant…

Q: A string has a linear density of 9.9 x 10^-3 kg/m and is under a tension of 210 N. The string is 2.4…

Q: A gas undergoes a change of state described by the pV diagram shown in the figure below. 4.00- pi10²…

A: Work done is area under PV diagram. from the figure area=12(3-1)×102×(3-1)+2×102×1 =400 J…

Q: 1. This graph is a stress-strain diagram that is of the type often studied by mechanical engineers…

A: We need to find the physical meaning of the area under the stress-strain curve.

Q: Two blocks as shown in the figure below are connected by a string of negligible mass passing over a…

Q: Two equal particles of mass at rest m0 move with speed 0.6C in opposite directions to make an…

A: Given particle masses,=mo eachinitial velocity, u=0.6c (moving in opposite direction)

Q: A 3 m- long ladder, as shown in Figure leans against a frictionless wall. The coefficient of static…

Q: Displacement: Which of the following quantities has units of a displacement? (There could be more…

A: to choose : the choice having the possible units of displacement

Q: The refractive index of the fibre optics and cladding of endoscopy is 1.923 and 1.412…

A: It is given that, the fiber optics and endoscopic cladding have refractive indices of n1=1.923 and…

Q: A spinless particle of mass m and with electric charge q is moving in a uniform magnetic field. The…

Q: Compute the density for copper at 480C given that its room temperature (20C) density is 8.89g/cm3.…

Q: How would range change if you shoot a projectile at 50 degrees compared to 20 degrees?

A: Given data The angle at which the first projectile is shooted is given as θ1=50°. The angle at…

Q: Two +1 C charges are separated by 3000 m. a) Draw a sketch of the scenario. b) What is the magnitude…

A: Given data: Two charges q1 = q2 = +1 C Distance (r) = 3000 m Required: The magnitude of the…

Q: Tornado Siren. The frequency of a tornado siren is 920 Hz. If a cyclist is moving toward the siren…

A: Given data: The frequency of the stationary source (f) = 920 Hz Speed of the cyclist (vo) = 10 m/s,…

Q: A quartz watch contains a 3 V battery. If the resistance of the watch is 20 Ohms, how many electrons…

A: Given data: Battery voltage (V) = 3 V Resistance (R) = 20 Ω Time (t) = 1 h Required: The number of…

Q: A lens with two convex surfaces, both with radii of curvature of 0.25 meters, is used to focus…

Q: The cable AB prevents bar OA from rotating clockwise about the pivot O. If the cable tension is 900…

Q: In order to move the rectangular stones which built the pyramids the ancient Egyptians used a system…

Q: 4. Three identical point charges +Q are placed each at a distance a from the origin as shown in the…

Q: A 4.00×10-2 Ω square wire loop 35.0 cm on a side has its plane normal to a uniform magnetic field of…

A: a) Calculate the area of the square. A=a2A=(35 cm×1 m100 cm)2A=0.1225 m2

Q: What is the mass of an object that weighs 420N?

Q: sample of gas in a cylinder with a piston is in thermal contact with a heat reservoir at a…

Q: What is the shape of the tolerance zone of the TOP control? Fill in the chart below. Position…

A: Given: Slot size = 10.010.6 mm Perpendicularity tolerance = 1638252277365_blob 0 @ MMC w.r.t Datum-…

Q: It is generally a good idea to gain an understanding of the size of units. Consider each object and…

A: We need to find the momentum for each given case.

Q: Modern commercial airliners are largely made of aluminum, a light and strong metal. But the fact…

A: Given, r1 = 6.5 m L = 70.7 m Total volume of metal that the fuselage is made up of is V = π(r22 -…

Q: Angular and Linear Quantities: An electrical motor spins at a constant 2695.0 rpm. If the rotor…

A: Given data The angular speed is given as ω=2695 rpm. The rotor radius is given as r = 7.165 cm.…

Q: A mass m1 rests on a frictionless horizontal table. Attached to it is a string which runs…

Q: A professional golfer is examining a video of a practice swing. The high-speed footage shows that…

Q: A 2.00kg mass is swung on the end of a rope that is 1.20m long at a speed of 3.00m/s. What is the…

A: Givenlength of rope, r=1.20 mmass, m=2 kgspeed , v=3 m/sFormula for centripetal forceF=mv2r

Q: A merry-go-round is a common piece of playground equipment. A 3.0-m-diameter merry-go-round, which…

A: Given Mass of the merry-go-round is M=280 kg Mass of John is m=30 kg Diameter of the merry-go-round…

Q: The drawing shows a 18.0-kg ball being whirled in a circular path on the end of a string. The motion…

Question

!
Required information
In a refrigerator, 1.60 mol of an ideal monatomic gas is taken through the cycle shown in the figure.
The temperature at point A is 714.0 K.
P
P2
1.30 kPa
K
What is the temperature at point D?
A
BI
D
I
1
1.50 m³ 2.25 m³ V
IC

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A Carnot engine employs 1.5 mol of nitrogen gas as a working substance, which is considered as an ideal diatomic gas with =7.5 at the working temperatures of the engine. The Carnot cycle goes in the cycle ABCDA with AB being an isothermal expansion. The volume at points A and C of the cycle are 5.0103 m3 and 0.15 L, respectively. The engine operates between two thermal baths of temperature 500 K 300 K. (a) Find the values of volume at B and D. (b) How much heat is absorbed by the gas in the AB isothermal expansion? (c) How much work is done by the gas in the AB isothermal expansion? (d) How much heat is given up by the gas in the CD isothermal expansion? (e) How much work is done by the gas in the CD isothermal compression? (f) How much work is done by the gas in the BC adiabatic expansion? (g) How much work is done by the gas in the DA adiabatic compression? (h) Find the value of efficiency of the engine based on the net and heat input. Compare this value to the efficiency of a Carnot engine based on the temperatures of the baths.
As shown below, calculate the work done by the gas in the quasi-static processes represented by the paths (a) AB; (b) ADB; (c) ACB; and (d) ADCB. `
An ideal gas expands isothermally along AB and does 700 J of work (see below). (a) How much heat does the gas exchange along AB? (b) The gas then expands adiabatically along BC and does 400 J of work. When the gas returns to A along CA, it exhausts 100 J of heat to its surroundings. How much work is done on the gas along this path?
Suppose you want to operate an ideal refrigerator with a cold temperature of 10.0C, and you would like it to have a coefficient of performance 7.00. What is the hot reservoir temperature for such a refrigerator?
It is unlikely that a process can be isothermal unless it is a very slow process. Explain why. Is the same true for isobaric and isochoric processes? Explain your answer.
There is no change in the internal of an ideal gas undergoing an isothermal process since the internal energy depends only on the temperature. Is it therefore correct to say that an isothermal process is the same as an adiabatic process for an ideal gas? Explain your answer. `
Two moles of a monatomic ideal gas such as helium is compressed adiabatically and reversibly from a state (3 atm, 5 L) to a state with pressure 4 atm. (a) Find the volume and temperature of the final state. (b) Find the temperature of the initial state of the gas. (c) Find the work done by the gas in the process. (d) Find the change in internal energy of the gas in the process.
An ideal monatomic gas at a pressure of 2.0105N/m2 and a temperature of 300 K undergoes a quasi-static isobaric expansion from 2.0103 to 4.0103 cm3. (a) What is the work done by the gas? (b) What is the temperature of the gas after the expansion? (c) How many moles of gas are there? (d) What is the change in internal energy of the gas? (e) How much heat is added to the gas?
Five moles of a monatomic ideal gas in a cylinder at 27 is expanded isothermally from a volume of 5 L to 10 L. (a) What is the change in internal energy? (b) How much work was done on the gas in the process? (c) How much heat was transferred to the gas?
. (I) What is the change in entropy of 1.00 m3 of water at 0°C when it is frozen to ice at 0°C?
The temperature at state A is 20.0ºC, that is 293 K. During the last test, you have found the temperature at state D is 73.0 K and n = 164 moles for this monatomic ideal gas. What is the change in thermal energy for process D to B, in MJ (MegaJoules)?
"Two moles of an ideal monatomic gas go through cycle abc. For the complete cycle, 800 J of heat flows out of the gas. Process ab is isobaric while process bc is isochoric.Ta = 200 K and Tb = 300 K. What is the work for process ca?"