Answered: Resolve a force of 100 N into two…

Resolve a force of 100 N into two components which lie on opposite sides of the force and each of which makes an angle of 300 with the force.

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter1: Introduction And Vectors

Section: Chapter Questions

Problem 59P

See similar textbooks

Related questions

Q: Find the resultant of the two forces 130 N and 110 N respectively , acting at an angle whose tangent…

A: The figures shows the sides of an angle. cosθ=adjhyp=5122+52=513

Q: A push of 180 N and pull of 350 N act simultaneuously at a point . Find the resultant of the forces…

Q: Two boys raising a bucket pull it at an angle 0 to each other. If each exerts a force of 20 N and…

Q: A measure of the effectiveness of the force in producing rotation about an axis

A: Torque gives the measurement of the effectiveness of the force in producing rotation about an…

Q: The horizontal force F (affecting the axis) required to drive a wheel weighing W and a radius R over…

A: To drive the wheel over the wedge, the minimum horizontal force must be sufficient enough to…

Q: is 24 m, at what angle, relative to the vertical, must she lean

A: Given;- If a cyclist is going v=6 m/s a circle whose radius is r=24 m, Find:- at what angle,…

Q: A force of magnitude 89 N is applied to a door. The lever arm is given at 0.859 m. Find the torque.

Q: Find the angle necessary to balance the following 2 masses in a plane. The first mass is 0.17 kg at…

Q: The equilibrant force is 5500 Dynes in magnitude and in the direction of 30 degrees South of East.…

Q: Determine the resultant R of the two forces applied to the bracket. Write R in terms of unit vectors…

A: Given Determine the resultant R of the two forces applied to the bracket. Write in terms of unit…

Q: how does the angle between two forces affect the magnitude of the resultant?

A: From question: The magnitude of the resultant is affected by the angle between two forces; when the…

Q: The three forces 24.6N , 36.8N, and 41.8N are in equilibrium. Find the angle between the 36.8N and…

Q: Determine the magnitude of the resultant force acting on the bracket and its direction measured…

A: GivenF1=200 lbF2=150 lb

Q: If the resultant force acting on the bracket is to be Fr= 800j N . Determine the magnitude and…

A: Write the force F in cartesian vector form. Write the force F1 in cartesian vector form.

Q: Two rods and one cable are attached to the supports at O. If two of the forces are as shown,…

A: GivenTwo rods and one cable are attached to the supports at 0as shown in given figure

Q: Find the resultant of the following forces using the polygon method. A = 30N at 45° B = 25N at 125°…

Q: Forces of 23 N and 41 N act at a point and are inclined at 90 degrees to each other. Find the…

Q: As you are sitting, draw the FBD of your right foot. How would the FBD of your foot change if…

A: Given:- As you are sitting and you are standing on the right foot Find:- The free body diagram for…

Q: A horizontal beam weighs 451 N, and its center of gravity is at its center. Find the vertical…

Q: IS attached to the ceiling and is s holding up a board. with the given data, Find The coeffi cient…

A: Given that: l=117 cm h=30.75 cm θ=10° T=7.0 N M=1.473 kg

Q: Two forces of 100 N and 150 N are acting simultaneously at a point . What is the resultant of these…

A: Data: Let, F1=100N F2 = 150N Angle between F1 and F2, θ=45°

Q: 3. A bridge is 36.5 m long and weighs 2,56 x 10 N. A truck weighing 5.25 x 10* N is 10.2 m from one…

A: As per company policy, we are restricted to solve one question at a time. Please ask other question…

Q: A train travels at 160 km.h*1 and has a rolling resistance of 0.0006 and a drag coefficient of 0.31.…

A: Given : Velocity of the train, v = 160 km/h Rolling resistance, μr = 0.0006 Drag coefficient, μc =…

Q: If the resultant force acting on the bracket is to be directed along the positive x-axis, determine…

Q: A 7.1 N was applied to a 7.2 kg block, find the normal force if the angle 0 = 9.1 degrees.

Q: Resolve the force F = 20i + 30j +50k lb into two components-one perpendicular to plane ABC and the…

Q: Can you please answer this question and show all of the steps

A: Horizontal cosine components cancel each other. The vertical sine components get added up.

Q: The magnitude of the resultant force acting on the bracket is to be 400 N. Determine the magnitude…

Q: Calculate the tension in each cable.

A: T1 and T2 can be considered as the tension acting on the left and right cable.

Q: done whe the point of application of the Force F is given a displacement d is A dxF B Fxd c |F]d|…

A: The definition of work in physics reveals its relationship to energy – whenever work is done, energy…

Q: two forces of 90N act on an object. the forces make an angle of 48 to each other. calculate the…

Q: Find the tension in the two cords shown in the figure. Neglect the mass of the cords and assume that…

Q: A 392 N force parallel to the plane is required to support a body on an inclined plane of the height…

Q: 20 N 30N (-6,5) (4,4) (-2,2) (3,-3) 10N 55N

Q: A bridge is 36.0 m. long and it weighs 2.50 x 10^5N. a truck weighing 5.20 x 10^4 N is 10m. from one…

Q: Andy and bob are carrying chuck on a 6.50 meter long uniform horizontal plank which weights 250 N.…

Q: Determine the magnitude and coordinate direction angles of the resultant force acting on the…

A: Given that: To determine the magnitude and direction angles of resultant force.

Q: The hook is subjected to three forces A,B,and C as shown. A= kN. a) If the resultant of the forces…

A: We have given a figure as The force A = 35 kN [ -x axis ] The force B = 45 kN [ 60o with +axis…

Q: 4ON 6ON 6ON Fi

A: Equilibrium of forces: When an object under the action of multiple external forces, and still…

Q: 2/16 Determine the resultant to the bracket. Write R in terms of unit vectors along the x- and…

Q: Find the resultant of the following forces using the polygon method. A = 30N at 45° B= 25N at 125° C…

A: Using Polygon law of vector addition we draw the vectors as a polygon. Here,…

Q: Two forces are applied to the ring of a force table, one at an angle of 20.00, and the other at an…

Q: A 32.8 ft ladder weighing 400 N leans against a frictionless vertical wall such that it makes an…

A: Given : Length of ladder L = 32.8 ft = 9.99 m Weight (mg) = 400 N

Q: The two forces shown act at point A of the bent bar. Determine the resultant R of the two forces.

A: Write the given values of the problem- Forces- F1=3 kipsF2=7 kips

Q: If the magnitude of the resultant force acting on the bracket is to be 80 lb directed along the u…

A: Given data: The resultant force along u axis is R=80 lb. The forces and angles are given in diagram.

Q: A force of 500 nt is measured with a possible error of 1 nt. Its component in adirection 60◦ away…

A: Given: Force, F=500 nt Possible error in force, dF=1 nt Force direction, θ=60° Error in angle,…

Q: The force of 500N is the resultant of the forces P and 260N acting as in the figure a. Give the…

Q: A 185 N sign is supported by two ropes. One rope pulls up and to the right ?1=29.5∘ above the…

A: Given Weight of the sign boardW=185Nθ1=29.5°θ2=42.5°

Q: Q1\ ABD consists Isosceles triangle. The AB and AD help support pole AC. Known that the tension in…

Question

Resolve a force of 100 N into two components which lie on opposite sides of the force and each of which makes an angle of 30⁰ with the force.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Diagram :

VIEW

Calculation & Result :

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

At what angle Θ must the 800-lb force be applied in order that the resultant R of the two forces have a magnitude of 860 lb?
Two forces act on the hook. Determine the magnitude of the resultant force
Consider the 50 N force and an unknown force P acting on a hook. The resultant of these forces is 45 N, directed horizontally to the left. Which of the following is the most ideally constructed vector triangle relating the two given forces and their resultant R?
Two forces are applied to the ring of a force table, one at an angle of 20.00, and the other at an angle of 80.00. Regardless of the magnitudes of the forces, describe which quadrant the resultant and equilibrant can be located.
Suppose the magnitude of tension force #1 is 25 N and is oriented at 265 degrees. Next, suppose the magnitude of force #2 is 5 N and oriented at 195 degrees. What is the angle correspoding to the direction with which the equilibrium force is oriented?
A bridge is 36.0 m. long and it weighs 2.50 x 10^5N. a truck weighing 5.20 x 10^4 N is 10m. from one end of the bridge .calculate the force that must be exerted by each pier to support these weighs
A 185 N sign is supported by two ropes. One rope pulls up and to the right ?1=29.5∘ above the horizontal with a tension ?1, and the other rope pulls up and to the left ?2=42.5∘ above the horizontal with a tension ?2, as shown in the figure. Find the tensions ?1 and ?2.
A person whose mass is m=77.0 kg steps on a mechanical bathroom scale placed on an inclined plane that makes the angle α=12.3∘ with the horizontal. What is the reading on the scale?
Find the resultant of the following forces using the polygon method.A = 30N at 45°B = 25N at 125°C = 15N at 220° Show analytical method
Find the tension in the two cords shown in the figure. Neglect the mass of the cords and assume that the angle θ is 33° and the mass m is 190-Kg.
If the resultant force acting on the bracket is to be directed along the positive x-axis, determine the magnitude of Force F.
A communications tower is located at the top of a steep hill, as shown. The angle of inclination of the hill is 62°. A guy wire is to be attached to the top of the tower and to the ground, 163 ft downhill from the base of the tower. The angle formed by the guy wire is 10°. Find the length of the cable required for the guy wire.