RINTER VERSION 1 BACK NEX Chapter 10, Problem 083 In the figure, two blocks, of mass m, = 247 g and m2 = 336 g, are connected by a massless cord that is wrapped around a uniform'disk of mass M = 430 g and radius R = 10.8 cm. The disk can rotate without friction about a fixed horizontal axis through its center; the cord cannot slip on the disk. The system is released from rest. Find (a) the magnitude of the acceleration of the blocks, (b) the tension T, in the cord at the left and (c) the tension T, in the cord at the right. M. (a) Number Units (b) Number Units (c) Number Units Click if you would like to Show Work for this question: Open Show Work

RINTER VERSION 1 BACK NEX Chapter 10, Problem 083 In the figure, two blocks, of mass m, = 247 g and m2 = 336 g, are connected by a massless cord that is wrapped around a uniform'disk of mass M = 430 g and radius R = 10.8 cm. The disk can rotate without friction about a fixed horizontal axis through its center; the cord cannot slip on the disk. The system is released from rest. Find (a) the magnitude of the acceleration of the blocks, (b) the tension T, in the cord at the left and (c) the tension T, in the cord at the right. M. (a) Number Units (b) Number Units (c) Number Units Click if you would like to Show Work for this question: Open Show Work

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter8: Rotational Motion

Section: Chapter Questions

Problem 92A

See similar textbooks

Similar questions

A propeller consists of two blades each 3.0 m in length and mass 120 kg each. The propeller can be approximated by a single rod rotating about its center of mass. The propeller starts from rest and rotates up to 1200 rpm in 30 seconds at a constant rate. (a) What is the angular momentum of the propeller at t=10s ; t=20s ? (b) What is the torque on the propeller?
Case Study For each acceleration listed, state the position and velocity of the disk in Crall and Whipples experiment (Figs. 16.316.5). There may be more than one possible answer for each given acceleration. a. ay = 3.8 m/s2 b. ay = 3.8 m/s2 c. ay = 0
A thin rod of length 2.65 m and mass 13.7 kg is rotated at anangular speed of 3.89 rad/s around an axis perpendicular to therod and through its center of mass. Find the magnitude of therods angular momentum.
A 9.94 kg mass is moving in a circle around a center point, attached to the center by a rubber band, with initial angular velocity 1.08 (as pictured below). Initially the length of the rubber band is 2.54, but then the rubber band stretches and its length is 6.08. After this happens what is the angular velocity of the mass? Assume that the system consisting of the mass and rubber band is isolated from any external forces and that the mass of the rubber band is negligible.
The figure shows the Atwood tool with a disk-shaped pulley given as moment of inertia I. Here m = 2 kg of pulley mass and R0 = 20 pulley radius. The masses M1 = 1 kg and M2 = 3 kg, which were initially at rest, are released at time t = 0. The z-axis is defined towards the outside of the screen. a) What is the magnitude of the acceleration of the masses m / s ^ 2? a) 10/3 b)4 c)5 d)2 e)20/3
A system consists of two objects of mass 2m and m, connected by a rod of negligible mass as shown. The system is held at its center of mass with the rod level and released. Which of the following explains why the rod does not rotate? A.The Earth exerts the same gravitational force on both objects, causing them to accelerate at the same rate. B.The Earth exerts a larger gravitational force the object of mass 2m, but that sphere is closer to the center of mass and the torques cancel out. C.The Earth exerts the same gravitational force on both objects, generating torques that cancel out. D.The Earth exerts a larger gravitational force the object of mass 2m, but that sphere has more inertia and the torques cancel out.
In 1980, over San Francisco Bay, a large yo-yo was released from a crane. The 116 kg yo-yo consisted of two uniform disks of radius 32 cm connected by an axle of radius 3.2 cm.What was the magnitude of the acceleration of the yo-yo during (a) its fall and (b) its rise? (c) What was the tension in the cord on which it rolled? (d) Was that tension near the cord’s limit of 52 kN? Suppose you build a scaled-up version of the yo-yo (same shape and materials but larger). (e) Will the magnitude of your yo-yo’s acceleration as it falls be greater than, less than, or the same as that of the San Francisco yo-yo? (f) How about the tension in the cord?
SUBJECT : GENERAL PHYSICS 1 PS : GIVE ME A SOLUTION WHY THE ANSWER IS THAT// 7. Find the angular momentum of a 5-kg object that can complete one revolution around a circular path, with a radius of 10 meters, in 15 seconds. A. 904.22 kgm^2/s B. 750 kgm^2/s C. 200/(3pi) kgm^2/s D. 209.44 kgm^2/s 8. How will the value of angular momentum change if the mass and angular velocity is maintained but the radius of the circular path is reduced to half the original? A. Angular momentum will decrease by a factor of four. B. Angular momentum will be doubled. C. Angular momentum will be halved. D. Angular momentum will increase by a factor of four.
A ring (mass 4 M, radius 1 R) rotates in a CCW direction with an initial angular speed 2 ω. A disk (mass 2 M, radius 2 R) rotates in a CW direction with initial angular speed 4 ω. The ring and disk "collide" and eventually rotate together. Assume that positive angular momentum and angular velocity values correspond to rotation in the CCW direction.What is the initial angular momentum Li of the ring+disk system? Write answer in terms of MR2ω. What is the final angular velocity ωf of the ring+disk system? Write your answer in terms of ω.
A massless, frictionless merry-go-round of radius R has one child of mass M sitting on the outer edge and is spinning with angular velocity ωi. If the child walks towards the center until she is 0.65R from the center, by what factor does the angular velocity increase? (i.e. solve for F where ωf=Fωi)
The centrifuge at NASA Ames Research Center has a radius of 8.8 m and can produce forces on its payload of 20 gs or 20 times the force of gravity on Earth. (a) What is the angular momentum of a 20-kg payload that experiences 10 gs in the centrifuge? (b) If the driver motor was turned off in (a) and the payload lost 10 kg, what would be its new spin rate, taking into account there are no frictional forces present?
Two astronauts, each of mass m , are connected by a rope of length d (assume the rope is massless). They are isolated in space, and are each spinning in a circle with the axis of rotation at the center of the rope. a) At some time, the astronauts both pull on the rope, so that the distance between them becomes less than d . Is the angular momentum of the system (the two astronauts) conserved during this pull? b) Compare the moment of inertia of the system about the axis before the pull and after the pull. Choose one answer from below and clearly explain a. The moment of inertia is larger after the pull than before. b. The moment of inertia is the same before and after the pull. c. The moment of inertia is smaller after the pull than before. c) Compare the angular speed of the astronauts before the pull and after the pull. Choose one answer from below and clearly explain a. The astronauts are rotating faster after the pull than before. b. The astronauts are rotating with the same…