RLC Circuit You have a series RLC Circuit that is being powered by a generator. This generator is providing voltage with a sinusoidal pattern and a peak value of the voltage of Ɛo = 10.50 V. The generator is powering this system with a frequency of f = 45.0 Hz. This circuit has a resistor (R = 40.0 Ohms), a capacitor (C = 687.0 UF) and an inductor (L = 27.50 mH). What is the Phase Angle of the system? Make sure to give your answer in units of degrees and with an appropriate number of significant figures.

RLC Circuit You have a series RLC Circuit that is being powered by a generator. This generator is providing voltage with a sinusoidal pattern and a peak value of the voltage of Ɛo = 10.50 V. The generator is powering this system with a frequency of f = 45.0 Hz. This circuit has a resistor (R = 40.0 Ohms), a capacitor (C = 687.0 UF) and an inductor (L = 27.50 mH). What is the Phase Angle of the system? Make sure to give your answer in units of degrees and with an appropriate number of significant figures.

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter33: Alternating Current Circuits

Section: Chapter Questions

Problem 33.56P: Consider the Filter circuit shown in Figure P33.56. (a) Show that the ratio of the amplitude of the...

See similar textbooks

Similar questions

In a series RLC circuit with a maximum current of 0.250 A, an AC source with Vmax= 115 V operating at 60.0 Hz is connected to a 325-mH inductor, a 7.50-F capacitor, and a resistor with unknown resistance R. Draw a phasor diagram for this circuit, including the current, the potential difference across each of the circuit elements, and the source emf. Draw your diagram with the current phasor pointing upward along the vertical axis.
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
An RLC circuit connected across an AC voltage source at frequency f has resistance R, capacitive reactance XG and inductive reactance XL. If the frequency is doubled so that fnew = 2f, find the ratios (a) Rnew/R, (b) XC,new/XC, and (c) XL,new/XL.
Neon signs require 12-kV for their operation. A transformer is to be used to change the voltage from 220-V (rms) ac to 12-kV (rms) ac. What must the ratio be of turns in the secondary winding to the turns in the primary winding? (b) What is the maximum rms current the neon lamps can draw if the fuse in the primary winding goes off at 0.5 A? (C) How much power is used by the neon sign when it is drawing the maximum current allowed by the fuse in the primary winding?
An RLC series circuit has a 2.50 (resistor, a 100 (H inductor, and an 80.0 (F capacitor. (a) Find the circuit's impedance at 120 Hz. (b) Find the circuit’s impedance at 5.00 kHz. (c) If the voltage source has Vrms = 5.60 V, what is Irms at each frequency? (d) What is the resonant frequency of the circuit? (e) What is Irms at resonance?
An RLC circuit connected across an AC voltage source at frequency f has resistance R, capacitive reactance XG and inductive reactance XL. If the frequency is doubled so that fnew = 2f, find the ratios (a) Rnew/R, (b) XC,new/XC, and (c) XL,new/XL.
Calculate the reactance of a 5.0F capacitor at (a) 60 Hz, (b) 600 Hz, and (c) 6000 Hz.
A 60.0-ft resistor is connected in series with a 30.0-F capacitor and a source whose maximum voltage is 120 V, operating at 60.0 Hz. Find (a) the capacitive reactance of the circuit, (b) the impedance of the circuit, and (c) the maximum current in the circuit. (d) Does the voltage lead or lag the current? (e) How will adding an inductor in series with the existing resistor and capacitor affect the current? Explain.
A capacitor and a resistor are connected in series across an AC source as shown in Figure OQ33.3. After the switch is closed, which of the following statements is true? (a) The voltage across the capacitor lags the current by 90. (b) The voltage across (lie resistor is out of phase with the current. (c) The voltage across the capacitor leads the current by 90. (d) The current decreases as the frequency of the source is increased, but its peak voltage remains the same. (e) None of those statements is correct.
Consider the Filter circuit shown in Figure P33.56. (a) Show that the ratio of the amplitude of the output voltage to that of the input voltage is to that of input voltage is VoutVin=1/CR2+(1C)2 (b) What value does this ratio approach as the frequency decreases toward zero? (c) What value does this ratio approach as the frequency increases without limit? (d) At what frequency is the ratio equal to one-half?
A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?
The resistor in Figure P32.49 represents the midrange speaker in a three-speaker system. Assume its resistance to be constant at 8.00 . The source represents an audio amplifier producing signals of uniform amplitude Vmax = 10.0 V at all audio frequencies. The inductor and capacitor are to function as a band-pass filter with Vout/Vin=12 at 200 Hz and at 4.00 103 Hz. Determine the required values of (a) L and (b) C. Find (c) the maximum value of the ratio Vout/Vin; (d) the frequency fo at which the ratio has its maximum value; (e) the phase shift between vin and vout at 200 Hz, at fo, and at 4.00 103 Hz; and (f) the average power transferred to the speaker at 200 Hz, at f0, and at 4.00 103 Hz. (g) Recognizing that the diagram represents an RLC circuit driven by an AC source, find its quality factor. Figure P32.49