Ex. 752. See Figure 752. D=1. The Bode gain and phase plots for a RC circuit areshown in the fig. Determine gain (dB), phase (deg), and frequency(rad/sec) for the points labeled A and B. Also find the otherexponents.Answers: GDBA,phA,wA,GDBB,phB,wB,C,E,F.Gain in dBBode Gain and Phase Plots-5-10-12.64-15-20-251010Frequency in rad/sec10510Phase in deg908070605040302076.5104.7640.1010Frequency in rad/sec10E10Figure 752

Given that D=1. So on a semilog paper corresponding values of C=0, E=2, F=3 As per the given data,…

Answered: See Figure 752. D=1. The Bode gain and…

Engineering

Electrical Engineering

See Figure 752. D=1. The Bode gain and phase plots for a RC circuit are shown in the fig Determino

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: R, R R-10 kOhm, C-10 mF, the shunt resistor is 1 MOhm What are the magnitude and the phase of the…

Q: In a series RLC circuit, the power cou lumed at resonance The cireait is conne cted accools 1 V…

Q: 3. A series circuit has a resonant frequency of 10 kHz. The resistance of the circuit is 5 ohms, and…

Q: A parallel RLC circuit has 15 kilo ohms, L = 8 milli henry and C = 60 micfrofarad, the bandwidth is,

A: We need to calculate the bandwidth of a parallel RLC circuit.

Q: Part 1: According to the following schematic diagram of a series RLC Filter, you were requested…

A: consider the given question;

Q: i4 For the circuit in figure below, the upper critical frequency due to the output * RC circuit…

Q: K(s+1) The cross-over frequency of the system with transfer function and phase margin equal to 50°…

A: From given transfer function write the equation for phase margin and equate with given phase margin…

Q: In the circuit shown in Figure 3, let R1 = 22, R2 = 2N, C1 = 0.2F, C2 = 0.5F, L = 0.5H, Vb = Vo, s=…

A: Note: As per our company guidelines we are supposed to answer only first 3 sub-parts. Kindly repost…

Q: Some linear system has a transfer function 1(s+6)/(s+7). Determine the Bode plot gain (dB) and phase…

Q: For the circuit in figure below, the upper critical frequency due to the output * RC circuit…

A: Given: Rc=2.2k ohm,rl=5.6k ohm, Cbc=4pf, re=10 ohm

Q: The inductance coil in the series resonant circuit is 0.2 H, and the resistance coil is 50 Q. At…

Q: A series connected circuit has R= 4 Ω and L= 25 mH. Calculate (A) The value of C that will produce a…

A: Let, Frequency, f = 50 Hz. Vm = 100 V. Given data, R = 4 Ω. L = 25 mH = 0.025 H. Quality factor,…

Q: Create a Bode plot of the circuit. 田 Component: Value 1 Resistor R1 500 Q Resistor R2 1 kQ Resistor…

Q: A series circuit consists of a 0.5 µF capacitor, a coil of inductance 0.32 H and resistance 40 Q and…

A: We need to find resonance frequency and voltage across capacitor, inductor and resistor

Q: When the bandwidth is high, the circuit is said to have a high quality factor True False A Moving to…

A: Given If band width is high then quality factor is also high True or false

Q: Forthe circut shown Find the XC at the resonance )Z7 al the resonace A The value ofLC at resonace…

A: Write the expression for the total impedance of the circuit.

Q: For the RLC series circut Figure 5, fs-20 vrms, R s00 a,C00u, L-30m. Which of the bode graph belongs…

A: Consider a series RLC circuit. We can consider the circuit in the question. We have to find out the…

Q: 30. A parallel tank circuit operating at its resonant frequency has an impedance of 10,000 2. At the…

A: For parallel tank circuit , when operating at resonance impendance is called as dynamic impedence…

Q: Question 4 A system has the following open loop transfer function, G(s) = (s+4Xs2+5s+9) (s+1) then…

A: In this question, Open loop transfer function is given. Fill the blank of the given Statment.

Q: (s / A+1)(s+6× B) G(s) = (s+7x A)(s / B+1)

A: Here I have drawn the bode plot.

Q: A series RLC resonator with an external load is shown below. Find the resonant frequency, the…

A: For the given series RLC Circuit Resonant frequency, loaded and Unloaded Q is calculated as shown…

Q: Design a series resonant circuit with an input voltage of 5 V 20° to have the following…

A: Given that Vin=5∠0° VoltIp=500 mAIrms=5002 mAB=120 Hzfr=8400 Hz Fig:…

Q: Below you see a Bode diagrams and a Nyquist diagrams of the same systems G2. Mark the correct…

A: From the analysis of the bode plot and Nyquist plot, we can understand the stability of the system…

Q: Which command is used to sketch Bode diagram of the following transfer function in MATLAB: 32 - 1…

A: Need to write matlab command for bode plot

Q: Q4(a) A coil of resistance 100 Q and inductance 100 uH is connected in series with a 100 pF…

A: Resonant frequency Fr =12×πLC. current at resonance =VR. Quality factor Q=WLR.

Q: A parallel circuit has R = 1 kN , C = 50 µF and L = 10 mH. The quality factor at resonance is %3D…

A: Impedance is represented as Z=R+jX where R represent resistance , and X represent reactance . The…

Q: Q3] Obtain the Transfer Function Vo (s)/Vi(s) of the circuit in Figure below and draw the Bode plot…

A: In the network, RLC consists. Find the transfer function of the circuit. V(s) /Vi (s) ? Draw the…

Q: Know the RLC circuit configurations that act as bandpassfilters Using the circuit , compute the…

A: Calculating capacitor value from the bandwidth expression β=1RCβ=1R×2πfβ=1250 Ω×2π×500…

Q: 2F) Transfer functron at dominant low- frequency component that Is 150 H(150) = It s2m (150)…

Q: K(s+1) The cross-over frequency of the system with transfer function A6*) and phase margin equal to…

A: Phase margin of the system is 500. Now we know phase margin of a system is obtained by adding 180…

Q: Vo(s) For the circuit of shown figure. The Transfer function is: Vi(s) 4Ω + + V; 3Ω 0.33F =Vo

A: Using nodal analysis,…

Q: 6. Design a series resonant circuit to have a bandwidth of 600 Hz using a coil with a Q of 20 and a…

Q: I want the answer in detail and as quickly as possible please Q/ Using resistors and capacitors if…

Q: Q2. A series circuit consists of a 0.5 µF capacitor, a coil of inductance 0.32 H and resistance 40 2…

A: Series RLC circuit have inductance capacitance and resistance. Calculate the resonance frequency,…

Q: HI C(s) R(s) G

Q: III. Reduce the block diagrams below to a single transfer function. А. R(s) C(s) 115

A: Here we discuss the signal flow graph concept of control system.

Q: A circuit consists of a resistor R=4500 Ohm and a capacitor C = 2.22E-11 F and has the voltage…

A: We are given parameters of a filter circuit: Value of the resistance (R) = 4500 ohm; Value of the…

Q: Consider the following open loop transfer function: 10 G(s) = K- s(금+1)(금+1) 2.5 8) Choose a of the…

Q: Q3] Obtain the Transfer Function Vo (s) Vi(s) of the cireuit in Figure below and draw the Bode plot…

A: This network have RLC in the series. Find the transfer function Vo/Vi And draw bode plot. i.e…

Q: Obtain the Transfer Function Vo (s)/Vi(s) of the circuit in Figure below and draw the Bode plot of…

A: Need to find transfer function and bode plot

Q: Vo(s) V;(s) A The circuit shown in figure below. The transfer function C A+ Bs+s" 0.5k 8H 50µF Vo Vị

A: the Given circuit is a series RLC circuit

Q: b) Find the transfer function V./V, of the circuit in Figure Q3 (c). Show that the circuit is a…

Q: The Bode plot of a control system is shown in Fig.2. Find the: 60 40 20 Fig.2 S iv--3dB frequency…

A: For the above given question we need to calculate the values of 3db frequency, gain and phase…

Q: Draw the Bode Plots and calculate the gain margin and the phase margin for the following transfer…

A: Consider the given expression,

Q: QUESTION 4 Create the magnitude and phase slope contribution from each pole and zero for the…

Q: Transfer Function= (s+179.24)(s+1133.26) Design lead-lag compensator to improve the settling time of…

Q: Vo Slope = -1 Slope = 1 Vs -VD VD

A: Discuss about the given figure related to which circuit characteristics.

Q: Design a component values for RLC series circuit with center frequency of 4KHz and quality factor of…

Q: I want the answer in detail and as quickly as possible please Q/ Using resistors and capacitors if…

A: Given: Bandpass filter using resistor and capacitor.C1=C2=10μF

Q: B) Solve for the transfer function H(f) = and calculate the cut-off frequency for the circuit in…

A: We need to find a transfer function and cut-off frequency of the given circuit.

Question

Ex. 752. See Figure 752. D=1. The Bode gain and phase plots for a RC circuit are
shown in the fig. Determine gain (dB), phase (deg), and frequency
(rad/sec) for the points labeled A and B. Also find the other
exponents.
Answers: GDBA,phA,wA,GDBB,phB,wB,C,E,F.
Gain in dB
Bode Gain and Phase Plots
-5
-10
-12.64
-15
-20
-25
10
10
Frequency in rad/sec
105
10
Phase in deg
90
80
70
60
50
40
30
20
76.5
10
4.764
0.
10
10
Frequency in rad/sec
10E
10
Figure 752

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Resonance and Different Parameter

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In the circuit diagram shown, if V_BE = 0.7 V, what is the value of the input resistance R_in (base) at mid frequencies?( NEED only handwritten solution please otherwise downvote)
Consider a gain Bode plot with slope of -20 dB/decade. If the frequency increases from 15 Hz to 47 Hz, what is the change in the gain in dB? Keep 3 significant figures.
a) from the rootlocus fig , Write the open loop transfer function of the system,b) What is the value of K for critical damped response?c) What is the range of K for stable closed-loop system?d) Determine damping ratio and ( Wn ) of the closed loop system for K=10.e) Sketch the approximate graph of the Bode magnitude of the transfer function (use K=100).
Answer in detail: Consider that the SNR in dB is equal to 30 dB, what is the actual SNR value (not in dB) ?
Obtain the transfer function Vo (s) / Vi (s) for the electric circuit given in the figure.You can find the amplitude value of the transfer function at high frequencies of the circuit.If it works, calculate approximately. System-owned transferDraw the Bode diagram of the function.
Given the parallel RLC circuit below, (a) derive the expression for the resonantfrequency, the half power frequencies, the bandwidth, and the quality factor for the transfer function of Vout/Iin in terms of the circuit parameters R, L and C, and (b) Compute the quantities in (a) if R = 1kohm, L = 10mH and C = 100uF.
Find the low frequency input and output impedence exprrssions for the circuit below
for the following given circuita) find Avs mid = Vs/ Vi.b) define the values fLS, fLC and fLE.c) determine low cutting frequencies. d) bode curves using the cutting frequencies you find defined in stylish edraw asymptotes.h) draw the low frequency response of the amplifier using the results you find in stylish F.
For the network of figure below: a. Find Avmid = Vo / Vi. b. Determine fs, fic. and fig. c. Determine the low cutoff frequency. d. Sketch the asymptotes of the Bode plot defined by the low cutoff frequency of part (c). e. Sketch the low-frequency response for the amplifier using the results of part (d) 20V
. Determine fLS , fLC, and fLE . e. Determine the low cutoff frequency. f. Sketch the asymptotes of the Bode plot defined by the cutoff frequencies of part (d). g. Sketch the low-frequency response for the amplifier using the results of part (e).
What is the cutoff frequency for the low-pass circuit shown if R1 = 1 k , R2 = 100 k , and C = 200 pF?
An R–L–C series circuit has a resonant frequency of 1.2 kHz and a Q-factor at resonance of 30. If the impedance of the circuit at resonance is 50 ohm determine the values of the inductance, and the capacitance. Also find the bandwidth, the lower and upper half-power frequencies and the value of the circuit impedance at the half-power frequencies.