Select the statement that is false. UTP cable is unshielded. Twisting two pairs of wires results in both wire being less affected by external noise. Cat 5 cable is composed of four shielded twisted pairs of insulated wires. O Increasing the number of twists per meter in the Cat 3 cable reduces crosstalk.

Select the statement that is false. UTP cable is unshielded. Twisting two pairs of wires results in both wire being less affected by external noise. Cat 5 cable is composed of four shielded twisted pairs of insulated wires. O Increasing the number of twists per meter in the Cat 3 cable reduces crosstalk.

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 2PE

See similar textbooks

Similar questions

If the signal at the end of a 6km cable has a power value of 2, if you knew that this cable loses 0.5 dB per km (i.e. -0.5 dB/km), then the power of the signal at the beginning of the cable was ..............
From the IEEE Standard Notation, state the notation of each Ethernet System. For example, the notation 10Base-5 means 10-Mbps transmission rate, baseband mode of transmission, with a maximum segment length of 500 meters. Will give thumbs up after, thanks
As another example, consider a circuit-switched network that connects computers in two remote offices of a private company. The offices are connected using a T-1 line leased from a communication service provider. There are two 4 × 8 (4 inputs and 8 outputs) switches in this network. For each switch, four output ports are folded into the input ports to allow communication between computers in the same office. Four other output ports allow communication between the two offices. Figure shows the situation
A 3000 km long trunk operates at 1536 Mbps and is used to transmit 64 byte frames and uses SWP. If the speed is 6 usec/km, how many bits should the sequence numbers be? Solve it correctly , else i will downvote.
Consider an ethernet with length of the cable is 1800 meter and speed of the signal cable is 3 x 10^8 m/s, transmission time is 45 microsec, the (%) of time channel remains idle. (Upto 2 decimal place) Correct answer get upvote. Incorrect get downvote
Computer Networks Find the netid and the hostid of the following IP addresses. Explain the complete logic? a. 114.34.2.8 b.132.56.8.6 c. 208.34.54.12
STP and Etherchannel Consider the below topology, noting that all the switches have the same priority 32768
What will be the call Blocking of the switch in a switching network the channel capacity was given as 5 and the traffic intensity of 3 Erlang.
In a full duplex communication by using UTP cable, Pr power is measured as 15 mw and Adb as 10,79 dB. If the received signal is correctly interpreted, which of the values are correct? a. maksimum Pc 15 mw NEXTdB : 0 ACRdB : 15,79 dB b. maksimum Pc: 5 mw NEXTdB : 10 dB ACRAB : 10,79 dB c. maksimum Pc 15 mw NEXT SB0 d8 ACRDB : 10.79 dB d. minimum Pc 12 mw NEXTdB : 7.78 dB ACCDB : 7,78 dB e minimum Pc: 5 mw NEXTdB: 10 dB ACRdB : 15,79 dB
When an Ethernet NIC has been configured by the OS to use half-duplex, the transmit pair of the twisted-pair cable uses _________transmissions, the receive pair in the cable uses _________transmissions, and the twisted-pair cable uses _________- transmissions.a. Simplex, half-duplex, half-duplexb. Half-duplex, simplex, simplexc. Simplex, simplex, half-duplexd. Simplex, half-duplex, simplex
A factor in the delay of a store-and-forward packet-switching system is how long it takes to store and forward a packet through a switch. If switching time is 10 usec, is this likely to be a major factor in the response of a client-server system where the client is in New York and the server is in California? Assume the propagation speed in copper and fiber to be 2/3 the speed of light in vacuum.
1)If the probability pk of a message is 1/8 then the information in bits is ____________ 1 bit. 3 bits. 2 bits. None of them. 2) Bipolar RZ line codes ensures both zero DC, and synchronization at every bit. FALSE TRUE 3) In _______, a receiver can use an error-correcting code that automatically corrects certain errors. FEC Huffman coding ARQ Line coding 4) Coaxial cable is more susceptible to external noise than fiber optics cable. FALSE TRUE 5) Which of the following requirement must be met for fast communication? High channel capacity. High sampling rate. High transmitter power. Large signal bandwidth.