consider a circuit-switched network that connects computers in two remote offices of a private company. The offices are connected using a T-1 line leased from a communication service provider. There are two 4 × 8 (4 inputs and 8 outputs) switches in this network. For each switch, four output ports are folded into the input ports to allow communication between computers in the same office. Four other output ports allow communication between the two offices. Figure shows the situation

consider a circuit-switched network that connects computers in two remote offices of a private company. The offices are connected using a T-1 line leased from a communication service provider. There are two 4 × 8 (4 inputs and 8 outputs) switches in this network. For each switch, four output ports are folded into the input ports to allow communication between computers in the same office. Four other output ports allow communication between the two offices. Figure shows the situation

Operations Research : Applications and Algorithms

4th Edition

ISBN:9780534380588

Author:Wayne L. Winston

Publisher:Wayne L. Winston

Chapter20: Queuing Theory

Section20.10: Exponential Queues In Series And Open Queuing Networks

Problem 8P

See similar textbooks

Similar questions

If a two port bridge was used in a heavy load standard Ethernet network such that the traffic is going through it. If each station is theoretically given a capacity of5Mbpsand the number of stations in each LAN segment is equal, then the number of stations in each LAN is:
Assume that there is a shared connection (for example, an Ethernet bus) with a speed of 1 Mbps. How much time (in microseconds) is required to send a frame with a length of 1000 bits over this link?
Suppose a router has n input ports each with identical line speeds, n output ports each with identical line speeds, and the line speed of an output port is at least n times as that of an input port. Further suppose that the switching fabric speed is at least n times as fast as an input line speed. Then A. queuing can occur in an input port.B. queuing can occur in the switching fabric. C. queuing can occur in an output port.D. there is no queuing delay in the router.
draw the diagram to establish a network for a computer labrotarory with 5 computers having internet facility using the following devices 1)switch2)router
Below is example simulation based on Cisco Packet Tracer! Try to make an interconnection between 3 pieces of network that are connected to a router. Innetwork-1 has a DNS Server and 1 workstation, on network-2 there is an HTTP Server(.com domain) and 1 work station, on network-3 there is an HTTP Server(on the domain .com) and 1 work station. Do such a configuration so that each work station can access the existing server services on the three those networks?
Consider a TCP connection with the following parameters: a) Initial ssthreshold = 4 segmentsb) Round Trip Time (RTT) = 10 millisecondsc) Timeout period = 40 millisecondsd) Segment size = 3900 bytesThe TCP connection was used to transfer 17 data segments. While sendingthe segments, data segment 7 and data segment 15 were lost the first timethey were sent (but arrived at the receiver properly when retransmitted).There were no other segment losses apart from the aforementioned. Assumethat data segments received out-of-order are buffered at the receiver. Whatis the average throughput obtained in sending all the data segments (inbytes/sec)? Draw a diagram to show the communication process in detail.
Consider a TCP connection with the following parameters: a) Initial ssthreshold = 4 segmentsb) Round Trip Time (RTT) = 10 millisecondsc) Timeout period = 40 millisecondsd) Segment size = 3900 bytesThe TCP connection was used to transfer 17 data segments. While sendingthe segments, data segment 7 and data segment 15 were lost the first timethey were sent (but arrived at the receiver properly when retransmitted).There were no other segment losses apart from the aforementioned. Assumethat data segments received out-of-order are buffered at the receiver. Whatis the average throughput obtained in sending all the data segments (inbytes/sec) including draw a diagram to show the communication process in detail.
A TCP connection is using a window size of 8,000 bytes and the previousacknowledgment number was 10,001. It receives a segment with acknowledgment number 12,001 and window size advertisement of 7,000 bytes. Draw a diagram to show the situation of the window before and after.
Is that so, or not? Consider a TCP connection where the most recent SampleRTT was 1 second. It is recommended that the TimeoutInterval be set to more than one second.
Follow this and make a python code? You need to simulate a network just like real-time network (Figure 1), where each node (device) is connected to its neighbors based on its transmission range.
An evaluation of TCP and UDP Give two instances of applications where, in your position as a software architect, you would prefer to use TCP over UDP.
Write a program to simulate the behavior of the CSMA/CD protocol over Ethernet when ther are N stations ready to transmit while a frame is being transmitted. Your program should report the times when each station successfully starts sending its frame. Assume that a clock tick occurs every slot time (51.2 microsec) and a collison detection and sending of a jamming sequence takes one slot time. All frames are the maximum length allowed.