6-6A one-story warchouse 36 m by 18 m is to be added to an existing plant. An asphalt pavementservice area 18 m by 9 m will be added adjacent to the warehouse. It will also be necessary toput in 150 linear m of railroad siding to service the warehouse. Utility service lines are alreadyavailable at the warehouse site. The proposed warehouse has a concrete floor and steel frame,walls, and roof. No heat is necessary, but lighting and sprinklers must be installed. Estimatethe total cost of the proposed addition. Consult App. B of the 4th ed. for necessary cost data.

Given:- 36m x 18m service area=18m x 9m 150 m linear arm To find:- total cost

service area 18 m by 9 m will be added adjacent to the warehouse. It will also be nece put in 150 linear m of railroad siding to service the warehouse. Utility service lines are available at the warehouse site. The proposed warehouse has a concrete floor and stee walls, and roof. No heat is necessary, but lighting and sprinklers must be installed. F

service area 18 m by 9 m will be added adjacent to the warehouse. It will also be nece put in 150 linear m of railroad siding to service the warehouse. Utility service lines are available at the warehouse site. The proposed warehouse has a concrete floor and stee walls, and roof. No heat is necessary, but lighting and sprinklers must be installed. F

Steel Design (Activate Learning with these NEW titles from Engineering!)

6th Edition

ISBN:9781337094740

Author:Segui, William T.

Publisher:Segui, William T.

Chapter2: Concepts In Structural Steel Design

Section: Chapter Questions

Problem 2.2P

See similar textbooks

Similar questions

Q1(d) Water flows in a 20000-m long smooth-asphalt trapezoidal channel at 55 m^3/s with side slope of 2.5(H):1(V). Elevations at the beginning and end of channel are 400 m and 376 m, respectively. Analyse its efficient-chandel section.
You are the geotechnical engineer for a proposed office building in a densely clustered city. The office building will be constructed adjacent to an existing office complex. The soil at the site is a deposit of very dense sand with E = E’= 45 MPa and v = v’ = 0.3. The sand rests on a deep deposit of dense gravel. The existing high-rise complex is founded on a concrete slab, 100 m 3 120 m, located at 2 m below ground surface, and transmits a load of 2400 MN to the soil. Your office foundation is 50m x 80m and transmits a load of 1000 MN. You also intend to locate your foundation at 2m below ground level. The front of your building is aligned with the existing offi ce complex, and the side distance is 0.5 m. The lesser dimension of each building is the frontal dimension. The owners of the existing building are concerned about possible settlement of their building due to your building. You are invited to a meeting with your client, the owners of the existing building, and their technical…
Assume gw= 10 kN/m3 or 62.5 pcf and Gs=2.7 unless stated otherwise for all the problems in this test.
ASAP USE P=4
The unheated storage facility shown is located on flat open terrain in southern Illinois, where the specified ground snow load is 15 lb/ft2. Determine the design snow load on the roof which has a slope of 4%.
Show complete solution MN = 61 kN-m SN = 73 kN-m
A coal mine is using the room and pillar method, block version with rooms and crosscuts 20ft in width driven on 90ft centers. Entries are entry crosscuts are the same dimensions. If no barrier pillars are left, compute the percentage recovery with and without pillar extraction
A pipeline is being designed to pump 0.5 m3/s of water at 25°C through a concrete pipe. The headloss in a 120 m length of pipe should not exceed 10 m. Determine the size of the pipe using:a) Darcy-Weisbachb) Hazen-Williams (C = 120)
Sub marine fan is distinguished against turbidite apron froma) The type of sandstonec. The geometry of the natural embankmentb. Geometry of the supplierd. Lobe geometry
3. A triangular gutter is constructed by bending a strip of G.I. sheet in the middle. Find the angle between the sides when the carrying capacity is maximum.
I do not see the "h = 15m, P = 500 kN" in the problem.. where in the solution were they used?
1. Use: Lane Method Check the dam below againt piping using Lane Method of the soil below the dam is fine sand