Short Problem: Given a parallel RLC circuit comprised of the following element 60.08-ohm resistor, ideal inductor with reactance of 35.85 ohms; and a capacitor with reactance of 11.58 ohms. Compute for reactive power in VArs given an ac voltage source of 100 cis 0 volts. Give only the absolute value. Note: Follow this reminder carefully. Compute to the nearest 4 decimal places. No Scientific notation. Do not round off in the middle of calculation. Use stored values. Write the numerical values only. No units in your final answer. Spaces are not allowed. Excessive number of decimals as compared to the required number of decimals may result to an incorrect answer.

Short Problem: Given a parallel RLC circuit comprised of the following element 60.08-ohm resistor, ideal inductor with reactance of 35.85 ohms; and a capacitor with reactance of 11.58 ohms. Compute for reactive power in VArs given an ac voltage source of 100 cis 0 volts. Give only the absolute value. Note: Follow this reminder carefully. Compute to the nearest 4 decimal places. No Scientific notation. Do not round off in the middle of calculation. Use stored values. Write the numerical values only. No units in your final answer. Spaces are not allowed. Excessive number of decimals as compared to the required number of decimals may result to an incorrect answer.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.18P: Let a series RLC network be connected to a source voltage V, drawing a current I. (a) In terms of...

See similar textbooks

Similar questions

An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8 lagging from a 220-V,60-Hz, single-phase source. By placing a bank of capacitors in parallel with the load, the resultant power factor is to be raised to 0.95 lagging. Find the net capacitance of the capacitor bank in F that is required.
A transmission line has a reactance of 1 Pu is operating at Vs = Vr = 1 Pu. The generator is connected at source end which is delivering 0.5 Pu of active power and the transmission line is compensated with a series capacitance of 0.5 Pu. Find the load angle with series capacitance compensation ?
Q6: An AC source operating at 60 Hz with a maximum voltage of 170 V is fed to a series combination of1.2kΩ resistor and 2.5μF capacitor connected in a timer circuit. How can you evaluate the maximumcurrent in the circuit? Can you estimate the rms value potential difference across each circuit element?Compare the power factor of this timer circuit with a circuit contain only ohmic resistance. Justify youranswer?
A circuit branch is found to have an equivalent impedance of Z=120−j45Ω. It is given that this impedance is a series combination of a 120Ω resistor and another passive component. If the circuit has a sinusoidal voltage source whose frequency is 120 Hz. What is the value of the component in series with the 120Ω resistor? (Note: Express the value assuming a metric scaling of μ(10-6). Provide your answer in decimal form, up to 3 decimal places.)
power system analysis subject solve step by step
A 200V, 50 Hz sinusoidal supply is connected to a parallel network comprising three branchesA, B and C as follows: A, a coil of resistance 3 ohm and inductive reactance 4 ohm; B, a seriescircuit of resistance 4 ohm and capacitive reactance 3 ohm; C, a capacitor. Given that the powerfactor of the combined circuit us unity, find (a) the capacitance of the capacitor inF; (b) the current taken from the supply. [Ans. 127.32 F, 56A]
A source whose voltage is ? (?) = 50√2 cos (?? + 30 °) ? supplies a load of impedance ? = (4 + ?3) Ω. We want to know: a) the active, reactive and apparent power consumed by the load. b) the power of a capacitor that must be installed in parallel with the load to raise its power factor to 0.97 delayed.
A 90-ohm resistor, a 32 mH inductor, and a 5 uF capacitor are connected in series across the terminals of a sinusoidal voltage source, vs = 125∠-60° V. If the angular velocity is ω = 5000 rad/s, find: a. The value of capacitance that yields a steady-state output current i with a phase angle of -105°. Express your answer in 2 decimals. b. The magnitude of the steady-state output current i. Express your answer in the nearest whole mA.
a) What is the time domain expression for the current? b) If the load impendance is created by an inductor with value L=375 mH, find the phaser voltage Vx? c) If the load impendance is created by a capacitor with value C=16.7 uF, find the phaser voltage Vx?
The resistance and inductance of a coil can be obtained by connecting the coil in series with a known resistance R and measuring the coil voltage Vcoil, the resistor voltage VR and the total voltage V. The frequency must also be known, but the phase angles of the voltages are not known. Given that f = 60Hz , R = 10 ohm Vcoil = 22.4 V. VR = 20 V and v = 36v , find the resistance and inductance of the coil.
By Differential equations An electromotive force of 100 volts is applied to an RC series circuit, in which the resistance is 50 ohms and the capacitance is 0.002 farads. Determine the load q(t) of the capacitor, if q(0) = 5C. Find the current i(t). Pls dont skip any steps even on the integrals
Consider the Capacitance = 10uF, Vpeak of +13v during the positive half cycle and -7v during the negative half cycle. If we have a charging time of 18ms, calculate the Forward Resistance of the circuit in ohms. Calculate the Vout during the negative half cycle. Calculate the Vout during the positive half cycle. Calculate the Discharging time of the circuit in seconds.