Answered: Show that the energy that is going…

Science

Physics

Show that the energy that is going through the power supply is 50% decipated through the resistor plus the capacitor.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 3CQ: Show that the power dissipated by the load resistor is maximum when the resistance of the load...

See similar textbooks

Related questions

Q: Two 2.1-cm-diameter-disks spaced 1.8 mm apart form a parallel- plate capacitor. The electric field…

Q: a 650 kg car is taking a circular turn with a radius of 225 m that is banked with a 20 grade. If…

A: Free body diagram:At maximum speed, frictional force acts down along the ramp rather than up because…

Q: A femur (modelled as a cylinder of length 40.0 cm and diameter 2.3 cm) is impacted by a sideways…

A: Step 1:Length is 40cm is 0.04mDiameter of the cylinder is 2.3cm is 0.023mForce is 855NShear modulus…

Q: Optical tweezers use light from a laser to move single atoms and molecules around. Suppose the…

Q: A 0.420-kg object attached to a spring with a force constant of 8.00 N/m vibrates in simple harmonic…

A: an ideal gas undergoing an isothermal and reversible compression in a piston-cylinder device, here's…

Q: A 15 gram bullet is fired at 610 m/s into a 4.0 kg block that sits at the edge of a 75 centimeter…

Q: Please provide correct answer for this problem ,Show chart.

A: Given thatthe temperature of the methane is T = 600 K.the specific volume is v=1kgm3 the formula of…

Q: A magnetic field of magnitude 5.00X10-3 T is oriented at an angle of 30.0° with respect to the…

A: Approach to solving the question:Please see attached photos for detailed solutions. Thank you.…

Q: Please solve the problem correctly. Thank you!

A: Please comment down for any doubt. I hope my answer helps you.

Q: Please include a free body diagram and equation

Q: I need help with this problem and an explanation of why its the answer described below:

A: Simple harmonic motion (SHM) is characterized by an oscillatory motion where the acceleration is…

Q: An alpha particle travels at a velocity of magnitude 600 m/s through a uniform magnetic field of…

A: Step 1:Step 2:

Q: Consider the Figure. Let r = 5.3 cm. What is the strength of the electric field at the position…

A: Free Body Diagram:Introduction:Here, horizontal components cancel out and only vertical components…

Q: How do we know how many rays an object sends onto a lens?

A: The question is asking about the number of rays that an object sends onto a lens. In optics, a ray…

Q: In the figure, a climber leans out against a vertical ice wall that has negligible friction.…

Q: A thin layer of liquid methylene iodide (n = 1.756) is sandwiched between two flat, parallel plates…

A: To find the thickness of the liquid layer needed for strong reflection of light with a wavelength of…

Q: Question 6 of 6 < View Policies - / 10 Current Attempt in Progress The figure shows the finishing…

A: Please see the attached images for the solution.If there are queries, please do not hesitate to ask.…

Q: Please solve and answer the problem correctly and also be sure to give the correct units. Thank…

A: Step 1: Given data is Monochromatic wavelength is λ(vacuum)=537nmThe refractive index is n=1.33…

Q: I just need part C. I do not know where to start.

A: Step 1: Determine the acceleration in the x- and y-direction…

Q: The figure shows a three-particle system, with masses m₁ = 2.5 kg, m2 = 3.9 kg, and m3 = 6.2 kg.…

A: Step 1: Given that m1 = 2.5 kg , m2 = 3.9 kg , m3= 6.2 kg m1 has a coordinates of (0, 0) = (x1,…

Q: How do I solve E

A: Sure, The prompt in the image asks you to calculate the magnitude of the angular momentum of the…

Q: Please solve the problem correctly. Thank you!

A: Step 1:To solve this problem, we can use the time dilation formula from special relativity: where:t'…

Q: A hydrogen atom makes a transition from the n=8 state to the n = 4 state. What is the wavelength…

Q: sketch a diagram and label the object, concave and convex lenses, focal points, and all images.

Q: 9

A: Step 1: Given, A monochromatic light falls on a slit which has width = 0.00220 mm = 0.00220 * 10-3…

Q: A rocket, starting from rest, travels straight up with an acceleration of 47.1 m/s². When the rocket…

A: Step 1:Step 2:Step 3:Step 4:

Q: A certain type of laser emits light that has a frequency of 5.5 × 1014 Hz. The light, however,…

Q: Please solve and answer the problem correctly please and also be sure to give the correct units and…

A: Hope you understand... Please do rate...... Thankyou

Q: How is double slit phenomena used in CD tracking?

A: Step 1:The double-slit phenomenon, which demonstrates the wave-particle duality of light, isn't…

Q: Consider a string with a length of (51.5) cm tied at both end (like on a stringed instrument). If…

A: Approach to solving the question: Detailed explanation: Examples: Key references:

Q: An amoeba is 0.310 cm away from the 0.305 cm focal length objective lens of a microscope. An…

Q: Solve all parts and don't use chatgpt

Q: BO 45° 14. A mB=6 kg, mc=18 kg, SA = 2 M. R=16 CM, r=8 CM, Rc=28 CM, ic= 14 CM, mA=12 kg,

A: a logistic regression problem to determine the effect of treatment, covariate, and…

Q: Please solve the following and show the steps

A: concept pagehere we used potential formula check on the concept page (first page)point p from -12nc…

Q: A 83 kg man lying on a surface of negligible friction shoves a 69 g stone away from himself, giving…

Q: Deep ultrasonic heating is used to promote healing of torn tendons. It is produced by applying…

A: Step 1:Step 2: Step 3:Step 4:

Q: solve with use free body diagram, Please fast.

A: Step 1:Step 2:Step 3:

Q: A package of mass m is released from rest at a warehouse loading dock and slides down a 5.5 m high…

A: Step 1:Step 2:

Q: At a department store, you adjust the mirrors in the dressing room so that they are parallel and 8.8…

A: Here's how to find the distances to the first front and back images in this scenario with parallel…

Q: ▾ Part A A 1.9-cm-tall object is 24 cm to the left of a lens with a focal length of 12 cm. A second…

A: Step 1:Step 2:Step 3:

Q: The figure shows the stress-strain curve for a material. The scale of the stress axis is set by s =…

Q: The magnetic field of an electromagnetic wave is described by By = B0cos(kx - ωt), where B0 = 5.5 ×…

A: Step 1:Step 2:Step 3:Step 4:

Q: A doctor is trying to find out if their patient is experiencing blood clots, and decides to use a…

A: Step 1: So, the doctor would expect a change in frequency of approximately 125.48 Hz between the…

Q: You are in a hot air balloon 500meters above the ground. How far is the horizon if the earth radius…

A: Please see the attached image for the solution.If there are queries, please do not hesitate to ask.…

Q: A cook puts 5.80 g of water in a 2.00-L pressure cooker that is then warmed to 530°C. What is the…

Q: Can you explain how 1,675 is the answer?

Q: A projectile is fired horizontally to the west out of velocity of 40 m/s what is a horizontal…

Q: I=1A, g=0.1A/m, R=0.5m. (a) Find magnetic field vector at a distance 1m from the wire on the plane…

A: The magnetic field due to a long, straight current-carrying wire can be found using the Biot-Savart…

Q: The drawing shows an ideal gas confined to a cylinder by a massless piston that is attached to an…

A: Step 1:Given data:A=2.50∗10−3m2V0=6.00∗10−4m3T0=273Kxf=0.11mx0=0.087mΔx=xf−x0=0.023mStep…

Q: A capacitor has a charge of 40 μC. The potential difference between the conductors is 300 V. What is…

A: Approach to solving the question:Please see attached photos for detailed solutions. Thank you.…

Question

Show that the energy that is going through the power supply is 50% decipated through the resistor plus the capacitor.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step by step

Solved in 2 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

The timing device in an automobile's intermittent wiper system is based on an RC rime constant and utilizes a 0.500F capacitor and a variable resistor. Over whatrange must R be made to vary to achieve time constants from 2.00 to 15.0 s?
Show that the power dissipated by the load resistor is maximum when the resistance of the load resistor is equal to the internal resistance of the battery.
Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
The ignition circuit of an automobile is powered by a 12-V battery. How are we able generate large voltages with this power source?
When working with high-power electric circuits, it is advised that whenever possible, you work "one-handed” or “keep one hand in your pocket." Why is this a sensible suggestion?
Does the time required for the current in an RL circuit to reach any fraction of its steady-state value depend on the emf of the battery?
Check Your Understanding In an RLC circuit, L = 5.0 mH, C=60F , and R=200 . (a) Is the circuit under damped, critically damped, or overdamped? (b) If the circuit starts oscillating with a charge of 3.0103C on the capacitor, how much energy has been dissipated in the resistor by the time the oscillations cease?
Refer to Figure 10.17 and the discussion of lights dimming when a heavy appliance comes on. (a) Given the voltage source is 120 V, the wire resistance is 0.800 and the bulb is nominally 75.0 W, what power will the bulb dissipate if a total of 15.0 A passes through the wires when the motor comes on? Assume negligible change in bulb resistance, (b) What power is consumed by the motor?
A capacitor with initial charge Q0 is connected across a resistor R at time t = 0. The separation between the plates of the capacitor changes as d = d0/(1 + t) for 0 t 1 s. Find an expression for the voltage drop across the capacitor as a function of time.
Why do transmission lines operate at very hig1 voltages while household circuits operate at fairly small voltages?
Show that if two resistors R1and R2are combined and one is much greater than the other (R 1 >>R 2 ): (a) Their series resistance is very nearly equal to the greater resistance R 1. (b) Their parallel resistance is very nearly equal to smaller resistance R2.
Check Your Understanding When using Kirchhoff’s laws, you need to decide which loops to use and the direction of current flow through each loop. In analyzing the circuit in Example 10.7, the direction of current flow was chosen to be clockwise, from point a to point b. How would the results change if the direction of the current was chosen to be counterclockwise, from point b to point a?