Answered: SITUATION1 A liquid in a 750 cu.m…

Engineering

Civil Engineering

SITUATION1 A liquid in a 750 cu.m container has a mass of 1010kg 5. What is its mass density?

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter9: Mass And Mass-related Variables In Engineering

Section: Chapter Questions

Problem 19P

See similar textbooks

Related questions

Q: A differential manometer is attached to a pipe as shown in figure below. Calculate the pressure diff...

Q: Compute the volume between the two stations using prismoidal formula. Compute the volume between the...

Q: C 580 N 1330 N + 1.2 m 1.2 m 1.8 m D 1.5 m The resultant of the reactions at B is nearest to:

Q: A freight train starts from rest and travels with a constant acceleration of 0.5 ft/s 2. After a tim...

Q: 3. A rectangular object weighs 400 N. It displaces a volume of water that weighs 300 N. a. Draw the ...

A: Given: The weight of the object is 400 N. The weight of volume of water displace is 300 N.

Q: Using portal method, Calculate for the shear force in kN at member FC a = 12.6 kN, b = 27.2 kN, c =...

Q: Given in the tabulation below are the adjusted lengths and azimuths taken from the north of a closed...

Q: The center height of the road at station 7 + 110 is 2m fill while at station 7 + 160 it is 1.2m cut....

Q: the figure shown, determine the height "h" of water when the absolut essure at B is 290 kPa. Encode ...

A: PB =290kPa Pair=175kPa

Q: a picture that is related tocivil engineering. Give three mathematical terms describing the picture.

Q: justifiable

A: In any project there are three party which are used to be involved.These are owner, management teams...

Q: a- 33.8 kN, b 27.2 kN, 48 m kN D " KN " kN 4 m 5m A. - 40 x 10 mm A- 60 x 10 mm A- 40 x 10 mnm FIGUR...

Q: 1. Which of the following most nearly gives the maximum tensile force that the wire AB can support? ...

Q: 2. To push a 25 kg WOoden box up a inclined plane, a man exerts a force of 150 N parallel to the inc...

Q: The driver of a vehicle travelling at 80kph up a grade requires 9m less to stop after he applies the...

Q: Compute the required N160 for a clean sand at depth 10 m. The earthquake magnitude is 6.3 and the gr...

A: The pore water pressure which acts equally in every direction will act on the entire surface on any ...

Q: Which of the following most nearly gives the internal degree of indeterminacy?

Q: SIMPLE STRESSES 340 mm 3. Two plates are connected by bolts as shown in the figure. Compute the maxi...

A: NOTE: We’ll answer the first question since the exact one wasn’t specified. Please submit a new ques...

Q: 1. (i) A dry soil has a void ratio of 0.65 and its grain specific gravity is = 2.80. What is its...

A: 1. i. Find Unit weight : γd = G*γw1 + e γd = 2.80 * 9.811 + 0.65 = 16.65 KN/m3

Q: PROBLEM 2: The 280-kg, 6m-wide rectangular gate shown is hinged at B and leans against the floor at ...

Q: Determine the compression index and expansion index Please show graph

A: We will solve this question in step no. 2

Q: Vhich of the following is an external effect of a force? O A man pushes an unlocked door causing the...

Q: How are you going to promote safety in your community? State actionable plans

Q: .

A: As there are multiple questions posted, according to the guidelines only the first three subparts ar...

Q: A sieve analysis test was performed on a sample of coarse aggregate and produced the following resul...

A: Sive size Amount retained (lb) 3 in. 0 2 0 3/2 3.7 1 15.9 3/4 12.0 1/2 13.5 3/8 26.7...

Q: A 3-degree simple curve is used to connect two highways whose bearings are N11°E and N47°E. a) Compu...

Q: the lightest available section a service live load of 3.B =

A: solution step 1 . load combination and moment calculation L =34 ftsupported dead load =1.6 k/ftser...

Q: PROBLEM EXERCISE - ASSIGNMENT The cross-sectional area of an aluminum bar is 160 mm? It carries an a...

Q: Situation 3: Two uniform loads of 112 kN/m acting downward are supported by a uniform upward pressur...

Q: A driver travelling at 50mph is 80m from a wall ahead. If the driver applies the brakes immediately,...

A: find the acceleration of the car.,a=?

Q: 2. What should be the slope of a planned-timber flume, rectangular in cross section, to carry 0.80m3...

Q: A driver travelling at 50mph is 80m from a wall ahead. If the driver applies the brakes immediately ...

A: We have to find the value of PIEV time when the distance of the car from the wall when it stop is 10...

Q: Calculate for the shear force at member FE in kN of the frame shown in figure 1 using Portal Method....

Q: A plain sedimentation tank with a length of 20 m, width of 10 m and a depth of 3 m is used in water ...

Q: Problem no. 2 Determine the displacement at C. USE: E = 29X103 ksi, I = 1200in4. 15 k C 30 ft 15 ft

Q: Determine the effective depth of a slab (mm) having thickness of 150mm with reinforcement bar diamet...

Q: Determine the momeny of inertia of the wetted surface of the dam. the unit must be in ft^4

Q: The reaction time of the average automobile driver is about 0.7sec. The reaction time is he interval...

Q: HYDRAULICS

Q: A wall is made from a quarter circle and flat plate with h = 4 m, R = 1.5 m, and w 3 m. The water is...

Q: Determine

A: The minimum area if shrinkage bars is given by 0.12% of gross area of slab.

Q: 15 KN/m 1. The beam shown in the figure carries distributed loads. Design the square (a x a) cross-s...

Q: A differential manometer is attached to a pipe as shown. Calculate the pressure difference between p...

Q: Question 6Figure 10 shows the first-floor plan of a residential building. It is proposed thatthe str...

A: Please put the figure with question

Q: Determine

Q: Calculate the cracking moment (Mcr) for the plain concrete. Assume normal-weight concrete and f’c...

A: Given: The value of f’c is 4000 psi. Consider the figure,

Q: The force F acts on the gripper of the robot arm. The moments of F about points A and B are 210 N-m ...

Q: 2 kN 2 m В 2 m 2 m 3 m 4 kN E O 8.94 kN (C) O 8.00 kN (T) O 8.94 kN (T) O NONE OF THE GIVEN CHOICES ...

Q: Calculate the weight of the piston if the gage pressure reading is 70 kPa Gape dameter Fie 2-22

Q: 300 N D 200 N B 6.0 m E H 3.0 m--3.0 m+-3.0 m-+3.0 m 200 N 400 N

Concept explainers

Pressure and Stress

Question

SITUATION 1
A liquid in a 750 cu.m container has a mass of 1010kg
5. What is its mass density?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 : Basic concept

VIEW

Step 2: mass density

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A certain liquid has a unit weight of 8.35kN/m^3. What are the values of its mass density, specific volume, and specific gravity?
If the density of a certain liquid is 1.89 slugs/ft3, what is its specific weight in KN/m3?
a.) If the specific weight of a liquid is 55 lb/ft3, what is its density? b.) If the specific weight of a liquid is 9.6 kN/m³, what is its density? c.) If the specific volume of a gas is 295 ft3/slug, what is its specific weight in lb/ft³?
A steel cube 100mm on a side weighs 100N. We want to hold the cube in equilibrium under water by attaching it to a light foam buoy. If the foam weighs 500N/m3, what is the minimum required volume of the buoy?
If the specific gravity of the unknown fluid is 12.56 what is its specific weight in lb/ft³?
A liquid has a specific weight of 41.5 lbs/ft3. How much will a cylinder that measures 18” tall and 13” in diameter weigh?
If 3.00 moles of gas are in a container with a volume of 60.0L at a temperature of 400 K , what is the pressure inside the container?
A volume of 15.50 cu. Ft of a liquid weighs 782 lb. compute the mass density of the liquid.
If the specific volume of a certain gas is 0.7848 m3/kg, what is its specific weight?
1. A volume of 15.5 cu.ft of a liquid weighs 782 lb. Compute the mass density of the liquid.
IF THE SPECIFIC WEIGHT OF A LIQUID IS 52lb/ft^3, WHAT IS ITS DENSITY? ANSWER:1.616slug/ft^3 PROVE THE ANSWER IN DETAILED SOLUTION. THANKS
1.) If the specific weight of a liquid is 7000 N/m3, what is its mass density? 2.) If 300 ft3 of oil weighs 12,430 lb, calculate its specific weight, density, and specific gravity.