Small packages traveling on the conveyor belt fall off into a 1-m-long loading car. If the conveyor is running at a constant speed of vc = 3 m/s, determine the smallest and largest distance R at which the end of A of the car may be placed from the conveyor so that the packages en

Q: Compute the resultant of the three forces acting on the plate shown. Locate its intersection with AB...

A:

Q: A homogeneous bar AB is supported at either end by a cable as shown in the figure. Calculate the lar...

A: Let m be the mass of bar AB  Diameter of cables,  Db= 28 mm  Ds= 20 mm  σb= 90 MPa  σs= 120 MPa     ...

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be u...

A: Answer: The maximum altitude is 11906 ft.  

Q: An open tank in the shape of a frustum of a cone is bound by two hoops, one at the top and the other...

A: Given: The diameter at top, d = 2 m The diameter at bottom, D = 3 m The height of the water, h = 2 m...

Q: find contraction of the bar.

A: Given; A steel bar of ;  Cross-section area,A=30×30mmAxial load,=300 KNlength of the bar,L=3 mE=200 ...

Q: 8.44 Combining Conservation Laws. A 15.0 kg block is attached to a very light horizontal spring of f...

A: Given                  Spring constant, k = 500 N/m             Mass of the block, M = 15 kg        ...

Q: A piston–cylinder assembly contains ammonia, initially at a temperature of -20°C and a quality of 40...

A: Given data as per question T1=−200Cx1=0.4considering properties table at T=−200CPsat=1.9019 baru1=uf...

Q: ind out the COP of a Carnot heat pump operating between temperatures 6o C and 37o

A: Given:Higher temperature, TH=37o C or 310 KLower temperature, TL=6o C or 279 K

Q: Draw clearly the Kinematic diagram and the degree of freedom Lift Table

A: A lift table is a device that raises merchandise, pallet loads, and other items using a scissor mech...

Q: A 40 kg-mass hangs from the end of a uniform beam. The beam is 6.0 m long and has a mass of 60 kg. T...

A:

Q: A 233 kg granite rock (p = 2700 kg/m³) is dropped into a lake. A man dives in and tries to lift the ...

A: Given:m=233 kgρ=2700 kg/m3ρw=1000 kg/m3

Q: (b) Consider a person standing in a room maintained at 25°C at all times. The inner surfaces of the ...

A: Given datafor winterTsur=15°Cfor summerTsurr=28°CA=1.5m2Ts=30°Cε=0.95

Q: Determine the equivalent torsional spring constant of a spring that will represent the system such t...

A: Given data: k=5 N/ml=1.5 m Need to determine the equivalent spring constant.

Q: Manufacture and design a U-pipe in an open state with a minimum of 7 different fluids with a datum.

A: A u-tube is a simple instrument to indicate the differential pressure between two points The discern...

Q: The following observations were recorded during a boiler trial of 1 hr duration. 700 kg of coal of c...

A: Explanation: The stepwise procedure to solve this problem is shown in the following attached image:

Q: 500 5. Calculate the resultant of the force system, and express it as a force and a couple moment wi...

A:

Q: A 1100 Nm torque is applied at B (CW looking from C towards A). Shaft (1) is solid brass with G 40 G...

A:

Q: Heat exchanger is device that facilitate the exchange of heat between two fluids that are at differe...

A:

Q: The asymmetrical support arrangement is chosen for a pedestrian bridge because conditions at the rig...

A:

Q: he quality of a two-phase mixture of: (a) water at 400°F and a specific volume of 0.55 ft/lbm; (b) R...

A: we will use the standard properties table Temp ( F) =400 Satiuration Pressure =247.26 vf =0.01864 ft...

Q: Q3: You have a truss which is shown below, two forces applying on it in B and C joints, which are (1...

A:

Q: An ideal double-reheat steam turbine receives 290,000 kg/hr of steam at 10 MPa and 400 °C. The two r...

A: Disclaimer:Since you have posted a question with multiple subparts, we will solve the first three su...

Q: m, find P!Q.

A: Need to find P/Q

Q: How does the Bernoulli’s Theorem Apparatus show the relationship between the kinetic and potential h...

A: According to Bernoulli's theorem, total energy (in the head form) remains constant. Assuming there i...

Q: A steel billet of 1800kg mass is to be cooled from 1100K to 450K. The heat released during this proc...

A:

Q: A stepped 100 N-m as shown in figure below. Modulus of rigidity of material is 90 GPa, then angle of...

A: Given data: Torque, T=100 N-m G=90 GPa

Q: wn gas has a mess of 1.5 kg and occupies 2.5 m while at a temperature of 300 K and a pressure of 200...

A: Given:m=1.5 kgV=2.5 m3T=300 KP=200 kPa

Q: Newtons and x is the displacement in meters. Assume displacement data is known The force vs. displac...

A:

Q: 124-mm-diameter pipe enlarges to a 139-mm-diameter pipe. At section 1 of the smaller pipe, the densi...

A: Given:d1=124 mmd2=139 mmρ1=221.912 kg/m3c1=23 m/sc2=15 m/s

Q: A stream of 50 m3/min of outdoor air at 27°C dry-bulb temperature and 30%RH is adiabatically mixed w...

A:

Q: Figure shows the schematic representation for the measurement of velocity of air (density= 1.2 kg/m³...

A: Given data: ρair=1.2 kg/m3ρw=1000 kg/m3g=9.8 m/s2x=10 cm Need to determine the velocity.  

Q: A thinwalled, filamentwound pressure vessel is pressurized such that at a point in the wall is  in ...

A: Since we are allowed to 3 subparts at a time. we’ll answer the first 3. Please resubmit the question...

Q: 6.17 A spacecraft is in a 300-km circular earth orbit. Calculate (a) The total delta-v required for ...

A:

Q: A rigid steel tank contains a mixture of vapor and liquid water at a temperature of 65°C. The tank h...

A:

Q: 500-liter tank contains a saturated mixture of steam and water at 300°C. Determine (a) the mass of e...

A: Given:V=500 LT=300°C

Q: Para a estrutura abaixo indique: a) Qual é a tensão no cabo BE? Considere P=792,1 kN. (Indique a re...

A:

Q: Design a hydrocooling unit to cool down fruits and vegetables from 30 °C to 5 °C in 20 minutes at a ...

A: Assuming specific heat of fruits Cf= 3.65 KJ/Kg mass flow rate of fruits= mf= 20000 Kg/h = 5.55 kg/s...

Q: A fan is rotating at 23 rotations per second (rps). The rotating shaft that powers the fan is applyi...

A:

Q: A 3 m³ tank initially contains a mixture of saturated steam and saturated liquid at 3400 kPa. Of the...

A: At 3400 KPa vf= specific volume of liquid= 0.001229 m3/kg vg= specific volume of vapour= 0.059654 m3...

Q: First consider the upper half of the gate. Based on the drawing below, which expression is correct f...

A: given; radius=Rdensity=ρheight=h

Q: Determine the equivalent spring constant of the system where the spring will be located in the posit...

A:

Q: At t = 0 bullet A is fired vertically with an initial velocity of 450 m/s. When t = 3 s, bullet B is...

A:

Q: A Triangular gate having a horizontal base of 1.30 m and an altitude of 2 m is inclined 45o from the...

A:  

Q: Calculate Stresses at (x.y.z) (0 in, 0.5 in, 0 in). You do NOT need to show Shear and Moment Diagram...

A: Find stresses at a point

Q: y (t) = 0.12t³ – 6.75t* + 135t3 – 1120t + 3200t + 9000

A: For Maximum Altitude, ∫0.12t5-6.75t4+135t31120t2+3200t+9000 =(5×0.12t4)-(4×6.75t3)+(3×135t2)-(2×1120...

Q: What materials are airplanes made out of? And is there any specific reason you should choose one mat...

A: The density of any substance or the material is the mass per unit volume of the substance. In the Si...

Q: A metallic rod of 500 mm length and 50 mm diameter, when subjected to a tensile force of 100 kN at t...

A:

Q: s designed so that the package is to reach the ground 37 seconds after release at A, determine the h...

A: distance = velocity * time elapsed

Q: The properties of anisotropic materials may change with direction.

A: The answer is True. The properties of anisotropic materials do change with direction.

Q: The load is supported by the four 304 stainless steel wires that are connected to the rigid members ...

A: Given: P = 500 lb   To find: Angle of tilt of the members AB and DC.

Heat Exchangers

Heat exchangers are the types of equipment that are primarily employed to transfer the thermal energy from one fluid to another, provided that one of the fluids should be at a higher thermal energy content than the other fluid.

Heat Exchanger

The heat exchanger is a combination of two words ''Heat'' and ''Exchanger''. It is a mechanical device that is used to exchange heat energy between two fluids.