Solenoid A is tightly wound while solenoid B has windings that are evenly spaced with a gap equal to the diameter of the wire. The solenoids are otherwise identical. Determine the ratio of the energies stored per unit length of these solenoids when the same current flows through each.

Solenoid A is tightly wound while solenoid B has windings that are evenly spaced with a gap equal to the diameter of the wire. The solenoids are otherwise identical. Determine the ratio of the energies stored per unit length of these solenoids when the same current flows through each.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 48P: Solenoid A is tightly wound while solenoid B has windings that are evenly spaced with a gap equal to...

See similar textbooks

Related questions

Q: The figure shows a stationary conducting loop adjacent to a horizontal current-carrying wire. For…

A: By the right-hand thumb rule, to produce a counter-clockwise induced current circulates in the…

Q: Arrange the following soleholds according to increasing inductance. Here N is the number of turns, A…

A: Given Solenoidwhere N is the number of turns. A is the cross-sectional area and L is the length of…

Q: Use Lenz's law to determine the direction of induced current in each case. (a) (b) (c) (d) B…

A: Faraday’s Law of induction states that when a conductor is placed in a magnetic field (B) and there…

Q: Experimentally, the magnetic flux Og in a solenoid was measured for various currents I. The data was…

Q: A conducting spherical shell is placed on one end of a long solenoid. If the current is doubled,…

A: Flux linked through surface is product of magnetic field & area. Magnetic field of solenoid…

Q: Two solenoids are part of the spark coil of an automobile. When the current in one solenoid falls…

A: The mutual inductance between two solenoids can be related to the self-inductance of the two…

Q: f the magnitude of the magnetic induction is less than that in a vaccum within a solid, so, this…

A: The diamagnetic materials have very weak magnetism. The magnitude of the its magnetic induction is…

Q: The wire of a tightly wound solenoid is unwound andused to make another tightly wound solenoid of…

A: The mathematical expression for the inductance is given as L=μ0N2Al Here, μ0 is the permittivity of…

Q: The current in a long solenoid of radius 7 cm and 17 turns/cm is varied with time at a rate of 6…

Q: What is the susceptibility and permeability of a perfectly diamagnetic substance?

A: For a perfectly diamagnetic substance, B=μ0H+1=01=-H

Q: Would the self-inductance of a 1.0 m long, tightly wound solenoid differ from the self-inductance…

Q: Experimentally, the magnetic flux OB in a solenoid was 4. measured for various currents I. The data…

Q: to support an energy density of 1.00 J/m^3 within the volume of the solenoid, how much current must…

Q: Use Lenz’s law to determine the direction of induced current in each case.

A: Lenz Law: The direction of the induced current in the coil should be such that its induced magnetic…

Q: A solenoid of length 0.700m having a cirular cross-setion of radius 5.00m stores 6.00 μJ of energy…

Q: A square loop of side length a is rotating with angular fre-quency ω in a constant, uniform magnetic…

Q: The current in a long solenoid with 20 turns per centimeter of radius 3 cm is varied with time at a…

Q: How can we calculate the self inductance of a solenoid?

A: Solenoid is a device made by a coil of wire.

Q: Two solenoids, A and B, are wound using equal lengths of the same kind of wire. The length of the…

A: The inductance of a solenoid can be determined as, Here, μ0 denotes the permeability, N denotes the…

Q: Find the self-inductance of a solenoidal coils with n turns per unit length and A cross sectional…

A: Magnetic flux =BA Cosθ

Q: Experimentally, the magnetic flux On in a solenoid was measured for various currents I. The data was…

A: Given The data or current and magnetic flux and we have to find the inductance of the solenoid?.…

Q: A long solenoid has a square cross-section with sides of length l, n turns per length has the z-axis…

Q: 0.5m 500 0 05 m B= 25, 5cos(120nt – 30°) (T) 500 Q resistance is connected to the square shaped…

Q: For a non-deformable loop of area A, immersed in a uniform magnetic field B. The induced fem is…

A: For a non -deformable loop of area A, immersed in a uniform magnetic field B. where B is the…

Q: A 400-turn solenoid, 25 cm long and 2 cm in diameter is traversed by an electric current of 3 A.…

A: (given) Number of turns (N) = 400 Length (l) of solenoid = 25 cm = 0.25 m Diameter of solenoid =…

Q: Show why the induced current in a wire can only be flowing in a particular direction.

A: According to Lenz's law, " If there is a change in magnetic flux then current in the loop induced in…

Q: Show that the self-inductance per unit length of an infinite, straight, thin wire is infinite.

A: From Ampere’s law

Q: 9) A wire of diameter d = 1 mm is wrapped around a cylindrical core of radius R= 5 cm and length I=…

A: Find magnetic field inside the solenoid, which is given by: B = u0*n*i u0 = 4*pi*10^-7 n = number…

Q: A very large, superconducting solenoid such as one used in MRI scans, stores 1.00 MJ of energy in…

Q: A solenoid has 45000 turns/m and diameter of 2.3 cm. If the current varies with time as I=24 t -…

A: 36) Self inductance = μo N2A/L Self inductance per unit length = 4π * 10-7 * (45000)2 * π*…

Q: Consider two identical circular coils of wire, each having self-inductance L and radius r. The coils…

A: Mutual Inductance: The current in one coil induces emf in the other coil. Due to the arrangement of…

Q: If a diamagnetic material is introduced into a solenoid that is carrying current I, what happens to…

A: We have to explain what happened to the energy stored here...

Q: A solenoid filled with air contains 1500 turns and its cross sectional area is 6.0 cm. If the length…

A: Given data: No. Of turns ( N ) = 1500 Cross sectional area ( A ) =6 cm2 = 6 × 10-4m2 Length of…

Q: Experimentally, the magnetic flux Pg in a solenoid was measured for various currents I. The data was…

A: We will use the given best fit line to find the inductance of the solenoid.

Q: 4A 6A Two rectangular conducting loops carry currents of 4 A and 6 A as shown in figure. What is the…

A: The circulation of B along an imaginary closed loop is proportional to the net amount of the current…

Q: Find the approximate formula expressing the mutual inductance of two thin coaxial loops of the same…

A: Write the given values of the problem- Radius=a Distance=l

Q: The current in a long solenoid of radius 7 cm and 17 turns/cm is varied with time at a rate of 6…

Q: For a technical application, an electrical engineer needs to create a solenoid using copper wire…

Q: In the circuit below, the switch S Closed, Take E= 10.0 V, R,=50 KQ, Ez=100k, and C= 10UF, Determine…

A: E = 10 volts R1 = 50000 ohm R2 = 100000 ohm C = 10×10-6 F = 10-5 F

Q: An ideal solenoid has a length of 25 mm. If the windings are compressed so that the length is…

A: Inductance: Inductance of a coil is defined as the emf induced in the coil when the current in a…

Q: Consider a uniformly wound solenoid having N turns and length ℓ. Assume ℓ is much longer than the…

A: To determine: Inductance of the solenoid.

Q: A single loop is made around the center of a solenoid with a length of 20 m and a radius of 5m. How…

A: Given Length of solenoid, h = 20 m Radius of solenoid,R = 5 m Mutual inductance, L = 1 Henry No…

Q: A 50cm long solenoid, having 500 turns and radius 2cm ,is wound on an iron core of relative…

A: Length of solenoid: l = 50 cm = 0.50 m Number of turns : N = 500 Radius of solenoid; r = 2 cm =…

Q: A self-induced emf in a solenoid of inductance L changes in time as ε = ε0e-kt. Assuming the charge…

Q: Imagine a long straight wire and above it is a circular loop of wire. If a current passing through…

A: Imagine a long straight wire and above it is a circular loop of wire. If a current passing through…

Q: For E = E2 = E = 1.8 V, R1 = R2 = R3 = R = R, = R = 1.1 2, %3D find the value of is. Notice that the…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A solenoid of N1turns has length l1and radius R1, and a second smaller solenoid of N2turns has length l2and radius R2. The smaller solenoid is placed completely inside the larger solenoid so that their long axes coincide. What is the mutual inductance of the two solenoids?
Show that the expression for the magnetic field of a toroid reduces to tlrat for the field of an infinite solenoid in the limit that the cenmal radius goes to infinity.
What is the self-inductance per meter of a coaxial cable whose inner radius is 0.50 mm and whose outer radius is 4.00 mm?
A solenoid with 4 x 107turns/m has an iron core placed in it whose magnetic susceptibility is 4.0 x 103. (a) If a cent of 2.0 A flows through the solenoid, what is the magnetic field in the iron core? (b) What is the effective surface current formed by the aligned atomic current loops in the iron core? (c) What is the self-inductance of the filled solenoid?
Would the self-inductance of a 1.0 m long, tightly wound solenoid differ from the self-inductance per meter of in infinite, but otherwise identical, solenoid?
Suppose that a cylindrical solenoid is wrapped around a core of iron whose magnetic susceptibility is x. Using Equation 14.9, show that the self-inductance of the solenoid is given by L=(l+x)+0n2Al where l is its length, A its cross-sectional area and N its total number of turns. Nm=U
Design a current loop that, when rotated in a uniform magnetic field of strength 0.10 T, will produce an emf =0 sin t. where 0=110V and 0=110V .
A long solenoid of radius a with n turns per unit length is carrying a tune-dependent current I(t)=I0sintwhere I0 and are constants. The solenoid is surrounded by a wire of resistance R that has two circular loops of radius b with b>a. Find the magnitude and direction of current induced m the outer loops at tune t=0.
A long solenoid of radius a with n turns per unit length is carrying a time-dependent current I(t)=I0sin(t) , where I0and are constants. The solenoid is surrounded by a wire of resistance R that has two circular- loops of radius b with b>a (see the following figure). Find the magnitude and direction of current induced in the outer
Show that for the circuit shown below, the initial energy stored in the inductor, LI2(0)/2 , is equal to the total energy eventually dissipated in the resistor 0I2(t)Rdt.
Two infinite solenoids cross the plane of the circuit as shown below. The radii of the solenoids are 0.10 and 020 m, respectively, and the current in each solenoid is changing such that dB/dt50.0T/s . What are die currents in die resistors of the circuit?
A 600-turn solenoid is 0.55 m long and 4.2 cm in diameter. Inside the solenoid, a small (1.1 cm × 1.4 cm), single-turn rectangular coil is fixed in place with its face perpendicular to the long axis of the solenoid. What is the mutual inductance of this system?