I’m not certain what to do next in the attached question. If the switch is closed, that means that the capacitor starts discharging, right? I’m just confused on whether there would be current flowing through the capacitor if the switch is closed. Wouldn’t there be a break in the current since the capacitor doesn’t touch? Any help would be appreciated. I just need help understanding C in the question. Thank you! CHAPTER 2I (57)In the circuit below, the switch SClosed, Take E = 10.0 V, R,= 50 KSL. Rz=100 k, and C= 1OMF, Determine the Fime(onstant (a) before the switch is closed and (b) after the switch is closed.(() Letthe switch be closed at t = 0. Determine the current in the switch as a function of timehas keenopen forlong time, His then suddenlyaA)T= RC- TIME CONSTANTE = 10VR,=5K=50,000 2Rq =100k=1oos2In Series: Ri+Rz (BEFORE)T= (150,0002)(-00o00 là = [1.538) I= Rq CT=(100,000)(.000 )=|IsecC = 10UF=,00001F

E = 10 volts R1 = 50000 ohm R2 = 100000 ohm C = 10×10-6 F = 10-5 F

In the circuit below, the switch S Closed, Take E= 10.0 V, R,=50 KQ, Ez=100k, and C= 10UF, Determine the Fime (Onstant (a) before the switch is closed and (b) after the switch is closed-(() Let the switch be closed at t = 0. Determine the current in the switch as a function of time has been long time, His then suddenly open for a A) T= RC TIME CONSTANT E = 10V In Series: R,+RZ (BEFORE) R,=5K2-50,0002 Rz=100k=lo0oso C = 10 uF - .0000 IF T= (150,000)(-0000 l) = [1.53 8) T= Rz C RZ %3D T= (100,00)(.00001). =|Isecl %3D

In the circuit below, the switch S Closed, Take E= 10.0 V, R,=50 KQ, Ez=100k, and C= 10UF, Determine the Fime (Onstant (a) before the switch is closed and (b) after the switch is closed-(() Let the switch be closed at t = 0. Determine the current in the switch as a function of time has been long time, His then suddenly open for a A) T= RC TIME CONSTANT E = 10V In Series: R,+RZ (BEFORE) R,=5K2-50,0002 Rz=100k=lo0oso C = 10 uF - .0000 IF T= (150,000)(-0000 l) = [1.53 8) T= Rz C RZ %3D T= (100,00)(.00001). =|Isecl %3D

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 80CP: Two infinite solenoids cross the plane of the circuit as shown below. The radii of the solenoids are...

See similar textbooks

Similar questions

Check your Understanding Repeat the calculations from the previous example for I0=0.040A .
In the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a constant VelOCity v. The velocity is in the same plane as the rails and directed at an angle 6 to them. A uniform magnetic field Bis directed out of the page. What is the emf induced in the r?
If a coil of wire is connected to a very sensitive ammeter and then waved about in the air, a current will be induced in it even if there are no magnets around. Why?
When there is an emf, the direction of the current will always be such that themagnetic field caused by it will try to oppose the change in producing it. Whoselaw is it?
A square conducting loop is in a region of uniform, constant magnetic field. Can the loop be rotated about an axis along one side and no emf be induced in the loop? Discuss, in terms of the orientation of the rotation axis relative to the magnetic-field direction.
(III) In Fig. 21–11, the rod moves with a speed of 1.16 m/s onrails 30.0 cm apart. The rod has a resistance of 2.5Ω Themagnetic field is 0.35 T, and the resistance of theconductor is 21.0Ω at a given instant. Calculate (a) theinduced emf, (b) the current in the conductor,and (c) the external force needed to keep the rod’s velocityconstant at that instant.
Check Your Understanding For the circuit of in Figure 14.12(b), show that when steady state is reached, the difference in the total energies produced by the battery and dissipated in the resistor is equal to the energy stored in the magnetic field of the coil.
A steady current flows through a circuit with a large induct3ve time constant. When a switch in the circuit is opened, a large spark across the terminals of the switch. Explain.
Does the time required for the current in an RL circuit to reach any fraction of its steady-state value depend on the emf of the battery?
A 120-V, series-wound motor has a field resistance of 80 and an armature resistance of 10. When it is operating at full speed, a back emf of 75 V is generated, (a) What is the initial current drawn by the motor? When the motor is operating at full speed, where are (b) the current drawn by the motor, (c) the power output of the source, [ d) the power output of the motor, and (e) the power dissipated in the two resistances?
Since the equation for torque on a current-carrying loop is =NIABsin, the units of N .m must equal units of A. m2T. Verify this.
If emf of the battery of Figure 14.12(b) is reduced by a factor of 2, by how much does the steady-state energy stored in the magnetic field of the inductor change?