Answered: Solve for the Resultant (Magnitude,…

Solve for the Resultant (Magnitude, Direction, and Location x) for the Nonconcurrent system below. Note: You do not need a y for the location for this problem. 600 N 200 N 45° 2m 4m _2m 100 N

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A simply supported beam made of 360UB56.7 (300 Plus) section. The beam has got full lateral support…

Q: -36 kNm 2 m X→- 2m +36 kNm 3 m -50 kNm -40 kNm + moment

A: We have to determine the value of X

Q: Find the Resultant (Magnitude and Direction) of the forces below. F4 = 20 N 3 7 F3 = 60 N 14 3 20⁰…

A: T find the magnitude and direction of resultant of the given force system

Q: The aluminum shade for the small high-intensity lamp shown has a uniform thickness of 1 mm. Knowing…

A: In order to calculate the volume of the given shade we can use the formula of Volume of frustum of…

Q: The frame is subjected to the load of 4 kN which acts on member ABD at D. Calculate the required…

A: Load = 4kN = 40 MPa

Q: ← Flow Between pipes Q.2 A car has a frontal projected area of 1.6 कर m² and travels at 60km/hr. It…

A: Velocity of the car-To Find-The power required to overcome wind resistance in units of kW.

Q: The piece of rubber is originally rectangular. Calculate the average shear strain Yxy at A if the…

A: Given data in question Cross section 400 mm and 300 mmDisplacements 3 mm and 2 mmTo find out Average…

Q: xplain the hydrological cycle and water balance

A: Hydrology describes the movement and distribution of water on Earth through the hydrological cycle…

Q: not solve based on eurocode 7, design approach 1, combination 2

A: Width of the footing, B = 5m , Length of footing , L = 10m , Dry Unit Weight,γdry=20kN/m3Saturated…

Q: B) The rates of rainfall for the successive 30 min period of a 3-hour stor are 1.6, 3.6, 5.0, 2.8,…

A: Given data-30 min rainfall period,Rate of rainfall = 1.6, 3.6, 5.0, 2.8, 2.2 & 1.0…

Q: 24-h traffic count at a road section was observed to be 1000 vehicles on a Tuesday in the month of…

A: A road section data for Tuesday, July Month is given-To Find-The value of the Annual Average Daily…

Q: A thin sealed unbound granular pavement is comprised of a 300mm CBR-60 Base sitting on a 300mm…

A: Given;A thin sealed unbound granular pavement is comprised of a 300mm CBR-60 Base sitting on a 300mm…

Q: The temperature of the cylindrical rod is heated to 45°C which is fixed in between A and C rigid…

Q: (4)+The-sandbag-in-the-figure-below-weighs-50-lb.--The-coefficient-of-friction-between-the-rope-and-…

Q: plain the processes for mining and processing iron ore for producing stee

A: Mines and processing plants provide the raw materials for steel production, a vital material in…

Q: The frame is made up of members ACE, BCD and DE. The frame is pin-supported at A and…

A: Consider Moment equilibrium at A500*3 =Bx*6Bx = 250 N

Q: 20 lb/in. A -10 in.-+ 15 in.- B

Q: Solve using Double Integration Method (Indeterminate Beam). Please step by step.

A: The below Indeterminate and continuous beam as shown with loading's of UDL and concentrated load;

Q: The beam shown in Figure 2 is a W16×36 of A992 steel. The two concentrated loads are service live…

A: Given;W1636 OF A992 Steel.point load = 70 k and 80 kL = 8'For A992 Steel, FY=50Ksi

Q: > A crane is used to lower weights into the sea for an underwater construction project. Determine…

Q: Based on the following figure determine the coordinates (on the x, y axes) of the centroid of the…

Q: The space truss shown below is made of steel (E sectional area of each member is 2.0 in² deflection,…

A: We will proceed in this question first by putting origin at A location. So that we know:A = ( 0,0,0)…

Q: Question 7 A simply supported beam made of timber is shown; determine the minimum required width b,…

Q: An agricultural land of 486 ha is to be irrigated for a crop having delta as 120 cm and 17 cm of…

A: An agricultural land-Area A=486 ha,Delta of the crop=120 cm,17 cm rainfall,Discharge of the canal…

Q: The beam is subjected to a shear of V=800N. Determine the average shear stress developed in the…

A: Shear force on beam V = 800 Nspacing of nails s = 100 mmdiameter of nails d = 2 mm

Q: Exercise 2.2 A house is to be designed in a site where the wind speeds, (m/s), were hourly recorded…

A: As the Calm wind hours are not given, I am assuming it is in equal intervals in 2 days' data.Raw…

Q: Task 2 Calculate forces related to fluids at rest and in motion b) An alternative suggestion for…

A: Given series of questions and asked to compute the following,2. An alternative suggestion for the…

Q: Part 2: Beam analysis The timber beam in Figure 2 is simply supported at points A and E. The…

A: Castigilano's TheormThe deflection is given by Now the reaction at the left and right support is ΣFy…

Q: What are the perks of both horizontal and vertical walls?

A: Horizontal walls are walls that are parallel to the ground or floor. Horizontal walls provide…

Q: How might a brick-and-mortar store implement FBA?

A: Fulfilment By Amazon (FBA) is a service offered by Amazon that allows sellers to store their…

Q: A rectangular concrete channel (n = 0.014) has a bottom width of 5.05 m and a longitudinal slope of…

Q: Q₁/ Along flexible strip Looting of 2.5m width having a smooth buse, is subjected to amniformly…

A: B = 2.5 m q = 80 kPa

Q: Implementing the Double Integration Method Find the moment M value that will result in a 5.011 mm…

A: Find:Moment M value that will result in a 5.011 mm deflection at the left free-end using Double…

Q: Analyze the whole section of a concrete gravity dam shown below. The specific weight of the concrete…

A: Weight = unit weight of material * Area of portion * 1 m lengthW1 = weight of triangular stemW1 =…

Q: Briefly, Explain How to construct the Forming Limit Diagram (FLD) for any metal?

A: The construct of FLD by the two methods is theoretical and the other is an experimental method.In…

Q: If the pump head is 75 m, discharge is 0.464 m³ /s and the motor speed is 1440 rpm at rated…

Q: What's the Displacement of the beam in mm at 2.0 meters from C?

A: Concrete load = 6/mTile load = 6/mSteel load = 0.01self weight of beam = 77*(100*150-43.75*125) =…

Q: Consider the smooth retaining wall shown in the figure below. Calculate the overturning moment at…

A: Surcharge load, q=15 kPaCohesion, c' = 3 kPaAngle of internal frictional, Unit weight of soil,…

Q: A horizontal curve is being designed for a new four-lane roadway with 11-ft lanes. The PT is located…

Q: Structural Metals Supply, Inc. has recently been contracted to design a beam for an overhead crane…

A: P = 10000 lb L = 30 ft or 360 inchFS = 1.5

Q: The floor system of an apartment building consists of a 4-inch-thick reinforced concrete slab…

Q: circular specimen of MgO is loaded using a three-point bending mode. Compute the minimum possible…

Q: 2m 60 N C 1.75 m 40 N 0.75m D 2m 60 N + 2m B

Q: For the truss shown in the figure, determine the reactions and bar forces assuming the C, as a…

A: Calculation of member forces and reactions at support using force method of analysis by taking Cy…

Q: What bottom width (B) of a trapezoidal grass-lined channel (n = 0.027) is required to carry 4,080…

Q: Under the effect of simple bending, what will be the bending moment M value in case of the material…

A: Here, width of the beam is not given. We are assuming that width of the beam= b mm Depth of beam=…

Q: Using a simply supported pre-stressed concrete beam, explain the following status using stress…

A: Note: As per Bartleby's guidelines, only first three subparts will be discussed in the solution. It…

Q: -Way on a major six-lane flexible pave ghway consists of trucks of type 1 and 2 with equivalency…

A: Given-parameters for truck 1 and truck 2 are given To find-1- Equivalent dingle axle load2- Design…

Q: 3- Estimate the Curve Number for all three AMC conditions for a basin with the following data: Soil…

A: Land use data of a watershed with 60% Farm, 15% seeded and 25% fair pasture land.

Q: Q12:- A horizontal circular curve with radius of 265 m and deflection angle = 72 degrees is planned…

A: Radius of curve=R=265 mDeflection angle=number of lanes=n=4Design speed=V=80 Km/hr=22.22 m/secCrown…

Question

Solve for the Resultant (Magnitude, Direction, and Location x) for the Nonconcurrent system below.
Note: You do not need a y for the location for this problem.
600 N
200 N
45°
2m
4m
100 N
.2m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction and given data

VIEW

Step 2: The magnitude and slope of the resultant.

VIEW

Step 3: Location of the resultant

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 6 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Calculate the value of 6.520kg/7.87 x 10^-3 m^3
Solve for the reduced level of a church spire C from the following observations taken from two stations A and B, 50 m apart. Angle BAC = 60°: Angle ABC = 50°, Angle of elevation from A to the top spire = 30o . Angle of elevation from B to the top spire = 29o , Staff reading from A, on bench mark of reduced level 20.00 m = 2.500m. Staff reading from B to the same bench mark = 0.500 m
The height of the tacheometer at A above the ground was 1.55m. Determine the elevations of P and Q, if the elevation of A is 75.5 m. The stadia constant k and c are respectively 100 and 0.0m.
e W By integration determin: *he S of the shaded arca shown . ¥ 'y-axis 1 ——» X-axis th my best wishes
With the line of sight horizontal, solve for the stadia constant given the following: Stadia Occupied: A Stadia Observed: B Distance from A to B: 90m Stadia intercept = 130cm Station Occupied: A Station Observed: C Distance from A to C: 30m Stadia Intercept = 70cm
Q1.17 Please show me how to solve problem... ty! Calculate the 1000 to 500 hPa thickness for a constant lapse rate atmosphere with y=6.5 K km^(-1) and T_o= 273 K.
Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. Block A is moving down the inclined plane with an initial velocity of vAo = 4 m/s, increasing at a rate of aA = (2t+1)m/s2. Determine the angular velocity (rad/s) of disk D after t=11.9 s.
A tower is located on a hilltop at T. Angular readings are taken with a theodolitefrom two instrumentation stations A and B, which are 50 m apart. Given the followingdata, determine the R.L. of hilltop at T and the tower height. Height of instrument (R.L.of instrumental centre) = 10 m. Vertical angles from A to the top and bottom of thetower at T is 35° and 28°(upward) respectively. Whole circle bearing of line AT, ABand BTis 25°, 110°, 5° respectively.
With the line of sight horizontal, solve for the stadia constant given the following? Station Occupied: A Station Observed: B Distance from A to B: 140m Stadia Intercept = 1.70cm Station Occupied: A Station Observed: C Distance from A to C: 70m Stadia Intercept = 1.00cm Fundamentals of surveying
What must be the pull in a 70 meters tape in order to eliminate the sag and temperature correction, given the following? a = 7x10% m? E = 2x101 N/m? Weight of tape, 11 N Po = 10kg To = 22°C T = 20°C K= 0.0000116/°C The tape length is supported at both ends.
Find the difference in elevation of station 7 and station 5. Find the difference in elevation of station 7 and station 4. Find the elevation of station 3.
8. Water flows into a vertical cylindrical tank at 12 ??³ /???; the surface rises in 6 ??/???. Find the radius of the tank.