Solve the following problems applying the Pythagorean Principle and check the result using the Kirchhoff's Voltage Law. 1. A three-phase, Y-connected, synchronous generator supplies a rated load of 12 MW at a power factor of 0.8 lagging. The synchronous impedance is 0.2 + j2 0/phase. If the line voltage is 11 kv, calculate the no-load line voltage. What is the voltage regulation?

Solve the following problems applying the Pythagorean Principle and check the result using the Kirchhoff's Voltage Law. 1. A three-phase, Y-connected, synchronous generator supplies a rated load of 12 MW at a power factor of 0.8 lagging. The synchronous impedance is 0.2 + j2 0/phase. If the line voltage is 11 kv, calculate the no-load line voltage. What is the voltage regulation?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.47P: Two three-phase generators supply a three-phase load through separate three-phase lines. The load...

See similar textbooks

Similar questions

With generator conyention, where the current leaves the positive terminal of the circuit element, if P is positive then positive real power is delivered. (a) False (b) True
A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
A 3 phase synchronous generator has a synchronous reactance Xs of 9 Ω perphase, a no-load line to neutral AC voltage E of 12 kV and a line to line terminalvoltage of V of 17.3 kV.(a) Derive the formula for the 3 phase power produced by the generator in terms ofthe power angle δm, |V |, |E|, and Xs. (δm is the angle between E and V ).(b) The power angle δm = 30 degrees. Calculate the 3 phase real power delivered to thegrid at the terminals of the generator.(c) The real power increases when the power angle δm increases, but there is amaximum possible theoretical power that the generator can produce. Calculate themaximum 3 phase real power. Solve A-C
A 3 phase, wye-connected salient-pole generator has on per phase basis Xd = 2 ohms, Xq = 1.5 ohms and R∅ = 0. When delivering its maximum power output to an infinite bus bar, the terminal and excitation voltages/phase are 1,430 V and 1,495 V, respectively. Find the power angle in electrical degrees at the above conditions
5. Solve the following problem: A THREE-PHASE GENERATOR SUPPLIES THREE LOADS IN PARALLEL BY MEANS OF A TRANSMISSION LINE (CONDUCTORS) OF 0.4 + J0.5 OHMS. LOAD No1 5.0 KVA AND POWER FACTOR OF 0.85 BACK. LOAD No2 8.0 KW AND 3.0 KVAR. LOAD No3 6.0 KVA, POWER FACTOR OF 0.80 BACK AND 480 VOLTS. DETERMINE THE GENERATOR PARAMETERS (POWER, POWER FACTOR, OHMS, CURRENT AND VOLTAGE MAGNITUDE).
Consider the following power system model with the following entities:i. A generator generates a sinusoidal waveform with amplitude of 300 V and angular frequency of 5 radians,ii. The transmission line has a resistance of 1Ω, andiii. A capacitive load with a value of 2F presents at the end of the system. Answer the following questions:(a) Draw the relevant diagram and label all entity values of the power system as described above.(b) Replacing the real source in Figure from part (a) with a complex source, find the response of the steady-state capacitor voltage in time-domain.(d) Repeat the sub-question (a) above, now showing calculations in s-domain.
Consider the following power system model with the following entities:i. A generator generates a sinusoidal waveform with amplitude of 300 V and angular frequency of 5 radians,ii. The transmission line has a resistance of 1Ω, andiii. A capacitive load with a value of 2F presents at the end of the system. Answer the following questions:(a) Draw the relevant diagram and label all entity values of the power system as described above.(b) Replacing the real source in Figure from part (a) with a complex source, find the response of the steady-state capacitor voltage in time-domain.(c) Repeat the sub-question (a) above, now showing calculations in frequency-domain.(d) Repeat the sub-question (a) above, now showing calculations in s-domain.
A 250V, 50 Hz single-phase supply feeds the following loads (i) incandescent lamps taking a current of 10A at unity power factor, (ii) fluorescent lamps taking 8A at a power factor of 0.7 lagging, (iii) a 3 kVA motor operating at full load and at a power factor of 0.8 lagging, and (iv) a static capacitor. Determine, for the lamps (incandescent and fluorescent) and motor, (a) the total current, (b) the overall power factor, and (c) the total power. (d) Find the value of the static capacitor to improve the overall power factor to 0.975 lagging.
A Y-connected, 3-phase, 1732 V, 120 kVA, synchronous generator has a synchronous reactance of 1.2 Ω/ph???. Feeds the specified load with pf = 0.9(+) . Fixed losses are assumed to be 5% of developed power. Find: A. The tension generated. b. The power angle. c. Voltage regulation. d. Efficiency. E. Phasor and Power Flow Diagrams
Two three-generator are parallel at 6.6 kV and delivering 3000 kW at 0.8 pf. The impedance for machine A is 0.5+j10 ohm and for B 0.4+j12 ohm. The excitation of A is adjusted to deliver 150 A at lagging pf. Determine the induced emf of machine A.
T e R e s e e e s 516 A three-phase, Y-connected synchronous generator is fated at 200KVA aud 2300 V. Jtis supplying rated current at rated terminal voltage (0 a 08 Jagang pf load. When the load is completely disconnected (without any change of field exitation), {he terminal voltage rises to 3800 V. (@ Draw a phasor diagram, illustrating the foregoing load condition. Mark each phasor by its symbol and its numerical yalue. () Calculate the synchronous reactance of this generator. Assume o negligible. e L R D ST
A 3 phase mesh-connected AC generator has a power angle of 15.4 degrees and synchronous impedance of 0.5 + j10 per phase while delivering 300A to its load at a lagging power factor and 13,200 volts line to line. Find the no load emf in volts, line to line.